How to solve the situation of anti water ?

After such a situation occurs, it is necessary to find the problem in time, and the situation of floor drain blockage must be dealt with, and then the sewage pipe should be replaced.

The pipeline should be cleaned in time, the pipeline can be modified if possible, the height of the pipeline should be very reasonable, and the installation of some things should also be reasonable, and some blocked sleeves should be installed.

Be sure to adjust your mentality, open another pack of bait, and then lower the proportion of bait, so that you can solve it well.

Sewers often have back-water problems, and the biggest possibility is that the pipes are blocked, such as kitchen pipes are most likely to be clogged with leftover food debris, and bathroom pipes are likely to be hair. Secondly, it may be that the calcification and aging in the sewer pipe are serious, and over time, the scale, impurities, and rust in the pipe accumulate more and more, resulting in the situation of pipe blockage and backwater. If there is backwater in the sewer in the public area, most of them are in rainy days, especially when it rains, a large amount of stagnant water pours into the pipes, and there are debris caused by stagnant water, and the water cannot be discharged in time, which will lead to backwatering.

From the above description, we know that the basic cause of sewer backwater is clogged pipes, so we only need to solve the problem of clogged pipes. First of all, we need to clean the pipes regularly, especially the pipes that have been used for a long time, there will be a lot of scale and impurities in them. Secondly, we can mix baking soda with white vinegar to make a solution, and then pour it into the sewer, and the chemical effect they produce can play the function of unclogging pipes, or buy dredging agent directly, the same effect.

Secondly, if we are buying a house, we need to pay attention to the fact that the house on the second floor is most likely to be blocked and backwatered. Because of the drainage pipes on the second floor, the water flow must first be discharged into a separate pipe before it can pass through the public pipes, so when the water flow speed does not meet the requirements, the second floor is the floor that is most likely to have direct blockage problems.

There are many reasons for sewer backwater, the first is that the pipeline is blocked, resulting in the water can not be discharged in time and then overflows in reverse; The second is the aging of the sewer pipe, which leads to the phenomenon of reverse water due to poor water flow; The third is that there is a problem with the check valve, which causes the water to come out of the sewer.

The sewer is clogged with foreign objects, the sewer pipe is aging, etc. The sewer is blocked by foreign objects, resulting in the phenomenon of water backflow due to poor water flow; The aging of the sewer pipe leads to serious fouling of the inner wall and blockage to form a backwater phenomenon.

It may be caused by the relatively high temperature, or it may be because the quality is not particularly good when selecting materials at that time, and it has been built for many years, and there is a collapse, and the slope is relatively low, so it is easy to backwater.

There is a problem during the decoration, it may be because the waterproof effect is not done well, so it will cause such a situation, it may also be because some water pipes are not done well during the decoration, followed by the materials used are not very good, or it is possible that the sewer pipe is not installed well, and there is a blockage problem.

1. There is a blockage. First of all, it may be that the main sewage pipe of the building is blocked, so that the sewage will reflect at the nearest blockage point, but if the water backs up to the second floor, it means that multiple pipes on the second floor are blocked. In the case of Huaiyun, these situations should be solved immediately by a professional dredging company.

2. The hydraulic conditions are very poor. Secondly, residential irrigation is usually gravity artesian, sewage from the drainage pipe to the horizontal trunk pipe, and finally discharged into the outdoor inspection well, the speed of discharge is getting faster and faster, to the horizontal trunk pipe, there will be instantaneous congestion, if the pipe diameter is small or the slope is small at this time, it will cause the pipe to be blocked, thus causing the situation of backwater.

3. The amount of house subsidence is large. Then the sewage discharge of residential projects must meet the corresponding slope in order to achieve the self-net flow rate, but after some houses have lived for many years, there will be a subsidence situation, once the subsidence will be pressed, or even crushed out of the pipe, resulting in the drainage is not bright and smooth, and there will be a natural backwatering situation. In addition, the material of the pipe will also affect its patency, such as iron cast pipes, which are easy to rust and hang dirt and are easy to block, while PVC pipes, with smooth pipe walls, are not easy to hang dirt, and are naturally not easy to block.

Clause.

1. Try not to use the anti-water erbium.

Clause. Second, it is unlikely that erbium material will not be waterproof, but there is a way to reduce the backwater situation and increase the proportion of pollen.

Clause. Third, it is to use Marukyu erbium to change the anti-water situation. For example, Maruhisa's "ruler" is the best thing.

Finally, it is a time to open less erbium before erbium starts to reflux, erbium will run out, and you can also reduce the proportion of erbium water and add less water, which can reduce the reflux.

Here I can only talk very briefly about the production of erbium: erbium must be added to the drawing powder, and the erbium material in some proportions can be pulled out directly. Generally speaking, 5% to 20% depends on whether there is erbium containing drawing powder in your main erbium, if there is, add less drawing powder, and add more drawing powder if there is no or less.

You can grasp the amount of brushed powder by experimenting yourself. Add a little more water to the erbium material with drawing powder at a time, and wait until the erbium eats through the water. Hit erbium by hand in one direction, and wait for the erbium non-stick basin to complete the erbium, and the erbium material can be reunited.

The number of times you catch depends on what kind of fish you catch, and it is related to the fish and water conditions. If you want to atomize quickly, you can play less erbium, and if you want to do it slowly, you can play a few more.

The size of erbium is related to the technique of erbium. If you want to pull it bigger, pull erbium up. If you want to pull small, pull horizontally. The techniques of erbium pulling include pull-up, side-pulling, horizontal pulling, scraping the wall skin and so on. If you practice more, you will be able to make it big, small and small.