-
Hello! According to my experience, there are several methods, the first method is to use the task manager to forcibly turn off proe, and then open it again!
The second method, as long as you don't have purge, then you can open the previous save file, and you can also restore the previous state!
The third way is to redefine the failed features and find the previous step! (It's a bit harder, but it's classic!) )
I hope my answer is useful to you and have a great life!
Mine, are you still satisfied?
-
It's simple. Select Quick Repair, select Suppress Item, and then select Suppress All; It's been that way. After the OK pops up, close the file directly, remember, it cannot be saved;
In order to prevent the file from failing to open again, it is recommended that you convert the file to an STP file and open it again so that it will not fail.
-
Select the first item when it pops up for the first time.,It's not necessarily what to say.,You can go back to before you modified.,If you choose the later one.,You have to redefine or delete it.。
-
Be careful, if you can cancel the change, cancel the change or redefine, and sometimes delete a lot of features, so even if you can, you can't undo it.
-
In the menu manager, see Fix Model -Feature -Redefine
Select the wrong feature.
-
Press "Quick Repair" – Exit Search". Guaranteed to work!!
-
This is because the license file is not cracked correctly, you try to crack it again.
-
If you have additional wealth, tell you.
-
In fact, there is no need to be so troublesome, this is a common network card address error (that is, a virtual network card or an active network card), at the bottom of the first interface of the installer is your host ID (network card address) and write this address into the license (you can refer to step 2 above)!
-
That's if you don't have an internet connection enabled.
-
Paste your installation process along.
-
The installation is unsuccessful, the system environment has changed, the network is disconnected when it is cracked, or the network card may not be opened, for various reasons.
-
It should be that the license is installed incorrectly. Have you modified the license file?
-
First of all, make sure that all six sets of numbers in the license file have been replaced with your own NIC number! Open it again after replacing it and check it again (this is important)! If you get an error of -9, just modify the license file!
Secondly, the location of the license file is not the same as the location of the license file before your installation, if it is inconsistent, it will be displayed as a -1 error!
-
Your shortcut key is perfect for setting up problems.
The proe shortcut teaches the rent macro grinder.
Virus. Just kill the virus.
The reasons are summarized in the following aspects, which occasionally appear, point: cancel, you can! >>>More
1. Ctrl+R, enter cmd, press enter.
Enter echo %path% to see all the environment variables. >>>More
How can I use getdlgitem and getdc before the dialog box is created? >>>More
5 workarounds are available:
It is recommended to enter safe mode and try the following methods. >>>More