How much electricity does a small submersible pump, the kind of goldfish farming, consume a day?

Updated on technology 2024-06-09
14 answers
  1. Anonymous users2024-02-11

    This pump is still available in specifications, from 100w to 100w. It should be determined according to the size of the fish tank, and the power required for the large fish tank is large. Take my 80*45 tank as an example, a light submersible pump.

    I use about one kilowatt-hour of electricity a day, and I use two 25W ones.

    This is actually not very power-intensive.

  2. Anonymous users2024-02-10

    Submersible pumps, according to the size of the fish tank, the supporting submersible pumps also have different sizes, from more than a dozen watts to dozens of watts, you can calculate the power consumption according to the formula according to the power indicated on the manual. The formula is: electricity consumption in one day = 24 kWh.

    For example, if the power of the submersible pump is 100W, then the power consumption of one day is (100 1000) x 24=, that is, the power consumption of one day.

  3. Anonymous users2024-02-09

    Fish tank filters don't cost a lot of electricity.

    The general filter pump commonly uses 5w-40w one kilowatt-hour electricity is 1000 watt-hours with a 40w filter water pump 24 hours a day on 40 * 24 = 960 watt-hour hours, less than one kilowatt-hour a day, in fact, the most power-consuming is the heating rod, generally 200w-500w, but fortunately, the heating rod is generally used in winter.

    The flow of water into the filter from the fish tank should not be too large to avoid excessive impact on the filter.

    It depends on the size of the water flow of the fish tank into the filter material, mainly on the filter fish tank, because it involves the water pump directly into the filter cotton. Therefore, this water flow must not be too large, once the water flows through the big hand, it will cause the water to flow like a high-pressure water gun.

    Similarly, the continuous impact of the filter will not only lose the filtration effect, but also greatly reduce the service life of the filter.

    If the water flow is too large, it is easy to cause excessive water accumulation in the upper filter tank, and then it will also make the trapped filter cotton lose its effect, that is, there is no filter effect at all, and the impurities will go directly into the tank, so there will definitely be small particles floating in the fish tank.

  4. Anonymous users2024-02-08

    The fish tank water pump costs about one day of electricity.

    In the process of raising ornamental fish, a water pump is needed to ensure the water circulation in the fish tank, the power of the pump generally ranges from five watts to 100 watts, taking the 100 watt pump as an example, the power consumption of one hour is the degree, and the power consumption of one day is the degree. Therefore, the fish tank water pump consumes about one kilowatt-hour of electricity.

    The water pump in the fish tank is a very important piece of equipment for maintaining the water circulation and oxygen in the fish tank.

  5. Anonymous users2024-02-07

    If the circulating pump of the trapped cracked fruit has been running at full capacity for 24 hours, then its power consumption is:

    95w × 24h

    24 hours is a day to eliminate Wang Sen closed consumption, or kilowatt-hour electricity.

  6. Anonymous users2024-02-06

    Summary. Hello, I've seen your question Ha Now I'm manually replying to the content for you, but it takes a little time, please be patient for a while, thank you, thank you

    A 15-liter fish tank with a 5-watt submersible pump can raise a few goldfish about 5 centimeters?

    Hello, Nianzi your problem I have seen Ha Now I am hand-hungry for you to return to the limb content, but it takes a little time, please wait patiently, thank you

    Hello, the 15-liter fish tank has a 5-watt submersible pump, which can raise a 1 cm long fish for 3-5 goldfish. Goldfish are all more than five centimeters long, which means that it takes 5 liters of water to raise a 5 centimeter fish. Do you have any questions that I would like to answer for you?

    I hope the above is helpful to you <> talk about jujube

    If you are satisfied with me, please give a thumbs up. Your praise is the infinite motivation for me to answer the question <>

  7. Anonymous users2024-02-05

    The hourly flow rate is 3 to 5 times the total amount of water.

  8. Anonymous users2024-02-04

    Novices can easily raise goldfish - the use of water pumps is a misunderstanding, I don't know that minutes are equal to a waste of money and electricity, and different accessories will have an impact on the water flow.

  9. Anonymous users2024-02-03

    These products are labeled, "Power: 5W (W)".

    One kilowatt-hour of electricity is 1kw h, that is to say, if the power of your aeration pump is 5w, it will consume one kilowatt-hour of electricity after 200 hours of continuous work, and such products generally do not exceed 10w (not excluding cases greater than 10w) The specific power consumption can be calculated by yourself.

    Look at the bottom right corner.

  10. Anonymous users2024-02-02

    The single-hole air pump is only 2-3 watts, and the electricity is 2-3 kWh a month, which is not more than two yuan. Heating rods are more power-intensive, usually hundreds of watts.

  11. Anonymous users2024-02-01

    1000 watt-hours is equal to one kilowatt-hour of electricity, 24 hours a day, you pump a few watts roughly multiplied by the calculation. The pump is small and has few kilowatt-hours of electricity a month.

  12. Anonymous users2024-01-31

    That doesn't use much, mainly if you use a heating rod to raise the tropics, then,

  13. Anonymous users2024-01-30

    Mine is a small cylinder of 50 with a 2 watt air pump.

  14. Anonymous users2024-01-29

    Submersible pumps. According to the size of the fish tank, the supporting submersible pump also has different sizes, from more than ten watts to dozens of watts, you can calculate the power consumption according to the formula according to the power indicated on the manual. The formula is:

    Electricity consumption in one day = 24 kWh. For example, in the spring, the power of the submersible pump is 100w, then one day.

    The power consumption is (100 1000) x 24=, that is, the power consumption of Xinsen lead electricity in one day.

Related questions
6 answers2024-06-09

What do you want to know?

Insulation resistance of submersible pumps: including the resistance to the ground of each phase of three phases, the normal is 300 megaohms to infinity. The phase-to-phase resistance of two pairs of three phases is normally 300 megaohms to infinity. Detect with a shake table. >>>More

9 answers2024-06-09

The most important thing is the flow rate and head. First of all, we need to figure out the flow rate, that is, how long it takes to pump and how much water, for example, the pool is 1 cubic meter, we hope to pump it in 10 minutes, then the flow rate should be 6m3 h, and combined with the water output speed of the well water stock, don't pump empty. Then there is the pressure or head, 8+8+17 (per layer) = 33m is necessary.

6 answers2024-06-09

The difference between sewage pump and submersible pump is mainly reflected in the following three aspects: >>>More

5 answers2024-06-09

Submersible pump head calculation method: The effective energy obtained by the unit weight of liquid after flowing through the pump. It is an important working performance parameter of the pump, also known as the pressure head. >>>More

8 answers2024-06-09

Something stuck is a reason, and it may be that the three-phase electricity is connected to the two phases, this has to be checked with a multimeter, go to find someone to borrow a multimeter, and measure whether the three wires of the submersible pump are broken. It is possible that the impeller is stuck and the friction of the stator rotor does not rotate. See if the sand has infiltrated into the bearing, clean it up, turn the impeller by hand, and see if it is smooth to rotate. >>>More