How to fold the military training quilt into tofu blocks, and how to fold the quilt in the dormitory

1.First of all, prepare a quilt for the troops, a quilt with very strong cotton wool. This quilt can be folded into a nice shape. After the quilt is flattened, fold one-third of the width of the quilt along the long parallel line. Fold it up and flatten it.

2.Then fold one side of the quilt over and press your hands inside the quilt. Don't make the folds uneven. Then take one end of the quilt and hold the length with your hand. Then press out a seal with both hands.

3.Next, pinch along the stripe with your hand. Make the marks more visible, and finally fold the quilt over.

4.Trim after folding. Press and hold with your thumb and forefinger and press the other three fingers against the quilt. Trim off right-angled edges.

5.Then fold the other end of the quilt and trim the inside in the same way. Then trim the top edge at a right angle.

6.After the right-angle repair, collect 7 pairs in the middle of the quilt and press them into strips. In the same way as before, the note bar in the middle is a little deeper.

7.Then quickly fold the quilt up and down with both hands. The neat side of the quilt is close to the door. One end faces the interior.

8.Then place the quilt in the middle of the bed. Press the upper edge with your fingers and straighten along one end. Straighten the folds and trim the front edges of the quilt. Stick your fingers into the quilt in multiple places.

9.The quilt is folded for three points and trimmed for seven points. So work hard every step of the way. You can slow down at first, and when you become proficient, you will be faster. Finally, smooth the quilt sheets.

10.Note: Note that it is best to take the same length of the two sections of the quilt, so that they will not be long and short.

1. Lay the quilt flat and press it flat, as shown in the figure below

2. Measure the size with your hands and measure the width of the two palms, as shown in the figure below

3. Then grab out the small groove and make the mark more obvious, as shown in the figure below

4. Then start to fold, press three fingers on the quilt, and trim out the right-angled edge, as shown in the figure below

5. In the same way, fold the quilt into the shape shown in the figure below;

1. Lay the quilt flat and press it flat, as shown in the figure below

2. Measure the size with your hands and measure the width of the two palms, as shown in the figure below

3. Then grab out the small groove and make the mark more obvious, as shown in the figure below

4. Then start to fold, press three fingers on the quilt, and trim out the right-angled edge, as shown in the figure below

5. In the same way, fold the quilt into the shape shown in the figure below;

Raw quilt bed.

Step Method.

Lay out the quilt and fold it once a little less than a third of the width to see how the fold looks like in the picture. O, this may not be clear, let me explain: the left part is folded, and the right side is not folded.

At one-fifth of the way to one end of the quilt, pick up a five-centimeter-wide bump, which should be extended if you stack the quilt thickly. It should not exceed 10 cm at most, otherwise the quilt will become tofu dregs. Pick the bulge hard so that your quilt will be three-dimensional.

Take a look at the renderings.

Next, repeat step 3 at the other end of the quilt, and at a fifth of the way on one end of the quilt, pick up a five-centimeter-wide bulge that should be extended if you stack the quilt thickly. It should not exceed 10 cm at most, otherwise the quilt will become tofu dregs. Take a look at the renderings.

Now a semi-finished product is formed, and there is a middle part to move on. Pick out a bump in the middle and look at the renderings and you'll understand.

Fold upwards along the bulge, if shown, to form a largely finished quilt.

Pick out the eight corners of the quilt to form a flute-like tofu block, haha, my high school is much better than this stack, and now I haven't practiced for many years, and I'm rusty.

I put it in a box and shake it a few times.

Is it so easy to stack and waste time.

1. Fold one-third of the width of the quilt along the long parallel line, and after folding, compact and smooth the hidden sail.

2. Then fold the quilt on one side, press it inside the quilt with your hands, and press out the strip mark with both hands.

3. Pinch the strip print by hand to make the mark more obvious.

4. Fold the quilt over.

5. After folding, trim the edges and pinch them with your thumb and index finger. The other three fingers are pressed on top of the quilt to trim out the right-angled edges.

6. Fold the other end of the quilt. In the same way, trim the inside edge, then trim the top edge at a right angle.

7. After the right angle is repaired, the double closing is pressed out in the middle of the quilt, and the middle bar should be deeper.

8. After the hail, fold the quilt quickly with both hands.

9. One slow end of the neat edge of the quilt is in the direction of the door, and the other end is facing the interior.

10. Place the quilt in the middle of the bed, press the upper edge line with your fingers, and straighten it along one end.

11. Trim the edge of the front end of the quilt, and point to the quilt in many places.