The engine waded into the water and ignited twice, after which it traveled two kilometers? 35

Shut down after wading, generally do not start twice, it is easy to cause the connecting rod to bend, but if the water intake is limited, the compression ratio of the engine is small, that is, the water intake is less than the volume of the combustion chamber, it will not cause the connecting rod to bend, plus less driving, and it will not cause the cylinder to be pulled due to poor lubrication, it is estimated that you are lucky, but it is recommended to measure the cylinder pressure after changing the oil, if all are normal, it will be fine to change the oil twice, and pay attention to check whether the transmission is flooded.

As long as the treatment can be started normally and the engine does not shake, it means that there is basically nothing inside the engine, and the electrical appliances that will be wading in the water need to be carefully checked to ensure that the circuit and relay will not affect the normal operation. It is best not to disassemble the engine, which will affect the sealing and later use.

It is impossible to burst the cylinder. You're already in the water. It is better to overhaul the engine. Clean the water inside. If you don't clean it, even if you change the oil to a new one, the wear and tear of the engine will be very great.

After the engine enters the water, the car does not burst the cylinder after driving for another two kilometers, and there will be no cylinder explosion after maintenance, but the two kilometers after the water entry will damage the cylinder block, and the performance of the engine will be reduced.

Hope it helps, hopefully!!

After the engine waded in the water, it was ignited for the second time, and after driving two kilometers, it was found that there was water in the oil, which required a thorough cleaning of the water inside the dough machine.

If it is cleaned thoroughly, and the car can still be driven after changing the oil, there will be no follow-up problems, but the line can not be guaranteed, and the plugs of various electrical appliances will have residual water, which needs to be dried with a hair dryer and cleaned.

Clean the water. The oil was replaced. Check the wiring harness.

If so, it is possible that the water is sucked directly into the engine compartment by the air intake, because the liquid is incompressible, so the connecting rod is bent.

Not starting again, just the damage to the vehicle will be a little smaller. If you start it again, the connecting rod may be thrown off directly, and the middle cylinder will be poked into a big hole, and the loss will be even greater.

Automatic transmission models: automatic transmission models will not easily stall, while manual transmission models may often stall due to low driving level.

However, it is not excluded that automatic transmission cars will not stall, and the main reason is that the engine stalls due to carbon accumulation caused by the use of low-quality fuel.

In addition, the reason for the stalling of the new car (automatic transmission) is mainly caused by the lack of driving skills, and another possibility is the problem of the car engine or oil circuit, but for the new car, the problem of the engine itself is less likely, and most of the reason is the problem of the oil circuit.

Finally, for old models, the reason for the stalling is not only the lack of driving skills, but also the stalling caused by the use of substandard oil to cause carbon accumulation in the engine.

It is recommended to go to the 4S store to deal with it, which is more professional.

Damage in positions such as piston connecting rods and valves. If the vehicle stalls during wading, it means that the engine has entered the water, because the water is difficult to be compressed, the piston can not reach the original top dead center position, the piston movement stroke becomes shorter, and the top dead center position will move down significantly. At this time, starting the engine will cause the piston connecting rod to bend, which will seriously damage the cylinder block and cause irreparable damage.

Insurance Liability. Engine damage caused by water ingress and secondary ignition is not subject to any compensation from the insurance company. Moreover, the practice of igniting the engine twice after water ingress is a serious violation of the insurance principle of claims, so the insurance company will not pay the claim, even if you have purchased water insurance.

So, once your car has stalled after wading, be sure not to try to ignite it again.

Because you have no way to tell if the car stalled because of water ingress. At this point, you should try to push the car out of the stagnant water as soon as possible (if someone helps), then call rescue** or contact a nearby workshop to tow the car away for inspection and repair.

The engine wading and stalling without a second ignition may not be fine.

If the engine is not damaged by water, it will not be damaged, and if it is water, it will be damaged. Once the vehicle is turned off in the water, do not restart it, the water is from the air intake pipe to the resonant box, then to the air cleaner, and finally into the engine. Once the water enters the engine of the cracked car, it will cause the engine to malfunction instantly, which will cause the car to stall.

If the vehicle is accidentally flooded while driving, the vehicle owner should turn off the engine immediately.

The engine wades into the water and stalls to start the vehicle again.

If the vehicle needs to drive on a waterlogged road, if the water accumulates more than half of the tires, there is a possibility of water ingress. When the vehicle stalls, do not start again.

Because when the water enters the engine statically or dynamically rushes to the engine intake, sometimes it will directly cause the engine to stall and run wild, but sometimes the water has not completely entered the engine cylinder, but if it continues to start twice, the water will directly enter the cylinder through the air intake, and the gas can be compressed but the water cannot be compressed.

When the crankshaft pushes the connecting rod to compress in the direction of the piston, the water can not be compressed, and the large reaction force will cause the connecting rod to bend. Some models may be slightly deformed, although after draining, the imitation can start smoothly and the engine runs normally. However, after a period of driving, the amount of deformation will increase, resulting in the risk of breakdown.

Something's wrong, what about after the engine waded? If you can't ignite it, if you ignite at 20, the engine must be overhauled, so you can repair the car.

It is not serious if the car turns off after passing through the water, it depends on the situation. If the flame is extinguished due to improper operation, it will not cause any effect; But if it is because of the water ingress into the engine, then it is another matter, under normal circumstances, after the water ingress is turned off, it is not possible to continue driving, and it needs to be repaired in the maintenance shop.

Whether it needs to be overhauled or not depends on the degree of damage to the car. After wading and stalling, if the car does not start a second time, it is generally not necessary to overhaul it; But if it is started a second time, the probability of overhaul will be very high.

The impact of the second start of the car wading.

Water has the characteristics of incompressibility, and the strong motive of the engine in the case of water ingress will cause the engine connecting rod to bend. In severe cases, it will also lead to problems such as piston jamming and wear of the middle cylinder.

In addition, the water entering the cylinder will mix the oil with the water, resulting in poor oil quality, which will increase the wear between parts and make the car vibrate more during subsequent driving.

Summary. Dear Sorry to keep you waiting, I'm glad to answer for you Will the engine be broken when the car turns off and ignites the second time after wading through the wading section: When the car turns off and does not respond to the second ignition after wading, the engine may be damaged.

When a car stalls after wading through water, it may be due to water entering the inside of the engine, or it is due to other reasons. If the engine is started again at this point, the stagnant water may be compressed, leading to failures such as bent connecting rods or cracked cylinder walls, and in severe cases, the engine will be scrapped. Therefore, when the car stalls after wading in water, you should contact the tow truck in time to tow the car to the repair shop for inspection and repair.

If the engine does not respond after the second start, do not continue to start to avoid more serious failures.

Dear Sorry to keep you waiting, I'm glad to answer for you The car has passed the Hengshui section of the jujube and turned off the second ignition without reacting, will the engine be broken: When the car wades into the water, the engine will be damaged if the engine is turned off and the second ignition is not responded. When a car stalls after wading through water, it may be due to water entering the inside of the engine, or it is due to other reasons.

If the engine is started again at this point, the stagnant water may be compressed, resulting in failures such as bent connecting rods or cracked cylinder walls, and in severe cases, the engine will be scrapped. Therefore, when the car stalls after wading in water, you should contact the tow truck in time to tow the car to the repair shop for inspection and repair. If the engine does not respond after the second start, do not continue to start to avoid more serious failures.

Kiss Expand knowledge: What to do if the car wades in water and turns off: 1. Keep calm, turn off the ignition switch, and don't start the car again; 2. Call the insurance company and report the case; 3. Wait until the car is towed to the repair shop, and inform the insurance company of the specific address; 4. In the process of waiting for rescue, remove the negative wire of the battery to avoid a short circuit caused by water ingress of the electronic equipment on the car; 5. Before repairing, the insurance company can verify the loss.

Hope it helps you <>

The second ignition is normal and the spine is dry, the engine Hupi fault light is not on, the depth of the water is less than half a wheel high, this morning to do the maintenance Sakura do the hole oil no water, but the air intake filtration is a little wet, is this problem big.

Dear, it's not a big problem, if the engine fault light doesn't light up after the second ignition, and there is no water in the machine Biling potato oil, but the air intake hand filter is a little wet, then the problem may not be too serious. However, in order to determine whether the engine was damaged, it was still recommended to tow the car to the repair station for inspection and repair. Moisture in the intake air intake filtration can affect the intake efficiency of the engine, leading to problems such as decreased power and increased fuel consumption.

At the same time, if water gets inside the engine and is not treated in time, it can cause more serious failures and damage. Therefore, timely inspection and repair are recommended to ensure the normal operation of the engine.

Does this check require disassembling the engine?

Yes, you need to disassemble the engine, we can call the 4S shop or find an auto repair shop to consult, safety is the most important.