What does windlass mean wildcat in English and Chinese

Anchor chain reels for anchor chain cabins Anchor sprockets, wildcat anchor sprockets.

It should be like this, and the general way to write it is: cocjking fast, or resin. Not sure why it was merged. It means epoxy, that is, the windlass has to be fixed with epoxy resin. View the original post

There are two types of windlass are horizontal and vertical, and horizontal windlass is generally used on merchant ships. The vertical windlass is also known as the anchor winch, and its power part is located below the deck to save the deck area. Recently, large ships have adopted vertical windlass because the windlass is too large, the bow deck is difficult to accommodate, and it is not conducive to operation.

Anchor winch machine? I've heard it for the first time, I've never seen it, so I'm begging for it.

Intel 9 series chipset, including Z97 H97, and integrated PCH for BroadWell-Y Broadwell-U

Anchor preparation is the preparation before anchoring. When preparing the anchor, the first thing to do is to throw a single anchor or a double anchor according to the requirements of the bridge. Check whether the windlasser is normal and whether the brake is good, close the power of the windlass, tighten the brake a little tighter, and loosen the safety of the chain stopper.

If you find something in the nearby waters, report it to the bridge in time. Anchoring: When the bridge pulls a short air whistle, it is a signal to drop the anchor, then turn on the chain stopper, let the anchor drop into the water, in the process of anchoring into the water, to use gestures and lights to report the length and direction of the anchor chain to the bridge.

Generally, the length of the chain is 3 5 times the depth of the water, according to the angle between the anchor chain and the water surface, when the chain is about the same, it is necessary to brake with a brake from time to time, so that the anchor chain is effective, so that the anchor slowly goes deep into the mud, and after the bridge determines that the boat is pulled, then put the anchor chain to the appropriate length, put down the chain stopper, and install the chain stopper insurance. Hang the anchor ball at the end.

The two meanings of anchor preparation refer to the fact that the ship itself has a fixed number of anchors installed, and the additional number of anchors is also called anchoring, which is placed in other locations of the ship or in the base warehouse; The second refers to the work prepared when docking at the pier or when anchoring is about to be dropped. At this time, the windlass is energized and the chain stopper is opened. Anchoring refers to the process of starting the windlasse or gravity anchoring to make the anchor enter the water.

Are you the head of the water or the first mate?

The windlass is a machinery used to retract anchors and anchor chains on ships, and it is a windlass that has been certified and audited by the State Ship Inspection Bureau. The windlass generally uses manpower, steam engine, electric motor, hydraulic motor, etc. as power. The windlass is usually installed on the bow deck of the ship.

The development trend of ZY12 is to use one unit to realize anchoring, mooring, automatic mooring and cable operations. According to the drive form, it can be divided into: manual, electric, hydraulic.

There are other different classifications, marine windlass, diesel-operated windlass, etc.

How to match the anchor, anchor chain and windlass.

MQT-120 bolting rig.

M: Bolting rig Q: Pneumatic T: Outrigger 120: Output power 120KW: Maximum rated torque.

Anchor preparation is to be ready to anchor at any time, that is, to be able to anchor at any time. Start the hydraulic power station of the windlass when preparing the anchor, disconnect the chain device, slowly release the brake of the windlass when the anchor is dropped, and the anchor chain will be dropped by its own weight and control the speed through the brake.