How to make a tumbler, how to make a tumbler steps

To make a tumbler depends on what material you use, if you use eggshell, you need to make the small head of the egg and the hole on the back of the hole slightly larger and break the membrane inside, and then blow from the hole in the small head, blow the eggs out, wash and dry the eggshell, you can use a hair dryer to dry. Then put some small steel balls (bicycle repair or hardware stores are sold) into the eggshell (of course, from the larger hole into it), the amount of small steel balls is about one-fifth of the volume of the egg, the amount is less tumbler can not stand, try a few more times, slowly add, add until you are satisfied; You can also use small stones and sand instead of small steel balls, which are heavy and have good results.

After the small steel ball is put into the eggshell, the eggshell is placed upright and fixed, and then the 502 glue (to use a large bottle, the small bottle is not enough) is dripped into it, so that the small steel ball and the eggshell stick together, after the glue is dry, it is OK. Then it's just a matter of doing some beautification.

If you can't stand or stand very slowly after the tumbler falls, it means that there are fewer steel balls, and you need to add more and glue them well. The amount of small steel balls should never exceed one-third of the volume of the eggshell, otherwise it will never stand up. Another is that the small steel balls should stick to the bottom of the eggshell, don't stick crookedly, otherwise they will become tilters.

1.First of all, prepare the materials: colored pencils, paints, brushes, small iron nails or screws, candles, colored paper, glue, eggs:

Colored pencils were originally used to draw eyes and mouths, but we used colored paper to cut the eyes and mouth into better than the paintings, so you can also use colored pencils; Make a small hole in the egg from the pointed end and pour out the egg mixture for later use.

2.Chop the wax and put it in an empty eggshell with a small iron nail, don't overfill it, just stand on the table3Pour hot water into a cup and place the eggshell filled with wax and nails.

4.When the wax melts, place it upright so that the wax can fix the nail to the bottom of the eggshell Wait for the wax to solidify!

5.Cut some confetti and stick it to the eggshell.

6.Finally, a little more careful dressing up is done.

The bottom is a little more rounded, and the upper part is lighter, so it's about ......

z Find a table tennis ball r

Divide the ping pong ball in half.

Use half of it to add plasticine and other things to the bottom to stick firmly.

And finally, make a nice shell, seal the opening of the ping-pong ball, and make it look like you want.

First use a needle to pierce a small hole in it, and then put sand to fix it, otherwise it will not stand up, and then decorate it, and a tumbler will be established.

Find a ping pong ball, cut it in half, put some clay in the remaining half, and finally you can make a cone of paper and stick it along the cut surface to the ping pong ball.

The tumbler is easy to make.

Here's how to make a tumbler:

Step 1:

Take out a raw egg, use chopsticks to make a small hole in the top of it, remember, not too big, and pour the egg mixture into the bowl. Then clean the inside of the eggshell with water.

Step 2:

Once the water in the eggshell is dry, you can put something weighty into the eggshell, such as a small iron nail or sand, from a small hole.

Step 3:

After putting an appropriate amount of weight inside, you can seal it, you can use candles or glue. Then draw some expressions or other favorite patterns on the eggshell. That's it.

How tumblers work:

The tumbler principle is that objects that are light at the top and heavy at the bottom are more stable, that is, the lower the center of gravity, the more stable.

When the tumbler is balanced while standing, the distance between the center of gravity and the contact point is minimal, i.e., the center of gravity is the lowest. When you deviate from the equilibrium position, the center of gravity will always be higher. Therefore, the equilibrium of this state is a stable equilibrium.

So no matter how much the tumbler is shaken, it will never fall.

For example, the experiment of "rolling on a cone" seen in the science museum is also for this reason, although the shape of the cone and the shape of the tracks on both sides cause the center of gravity to fall, but it looks as if it is rising, and the upward scroll is inconsistent with the facts in life. But it's just an illusion, and in essence, the center of gravity drops, and the lower the center of gravity, the more stable.

Step 1: Prepare the materials, double-sided tape, eggshell, plasticine, glue, scissors, markers, compasses, cardboard.

Step 2: Draw a fan with a compass on the prepared cardboard.

Step 3: Cut out the painted fan.

Step 4: Roll the cut fan into a cone, paste the double-sided tape and fix it to form a cone.

Step 5: Put the plasticine into the eggshell, do not fill it, only take up 2 3 of the eggshell.

Step 6: Connect the finished cone with the eggshell placed in the plasticine to form a tumbler.

Step 7: Place the tumbler on a smooth table, try to push it, and the tumbler will automatically stand up again.

1Take a raw egg, make a hole at one end of the egg, and pour out the egg mixture;

2. Take another piece of colored paper, cut out a semicircle, apply glue at one end of the semicircle, glue the two sides together, and make a tumbler hat;

3. Then fill the eggshell with rice (or pebbles), and then squeeze it into the hot melt adhesive to fix;

Glue the inside of the hat and stick it to the eggshell.

4. Rub a circle of glue on the inside of the hat and stick it to the eggshell;

5. Finally, draw the eyes and mouth on the hat and you're done.

Tools needed: eggshells, colored paper, colored pencils, scissors, glue.

1. Prepare the materials for making tumblers, as shown in the picture below:

2. Open the egg from the pointed end and wash it, and put in a weighted object, as shown in the picture below

4. Cut off the part of the circle quarter, as shown in the figure below

6. Glue the conical shape to the egg shell, as shown in the figure below

7. Draw an expression on the eggshell with a colored pencil, as shown in the picture below

Eighth, such a tumbler is done, as shown in the figure below:

On August 28, the fish and vegetable courtyard was filmed.

The tumbler is easy to make.

Make a mold and move his center of gravity down as much as possible, just like an egg tumbler, only about half of the sand, and lower the center of gravity, and a simple egg tumbler is ready.

Take an egg out of the bag, take a toothpick, use it to make a small hole in the top of the egg, and slowly pour the yolk and egg white out of the small hole. After that, carefully dig the hole a little bigger with your little finger, gently stuff some plasticine into the eggshell, and finally seal the hole with adhesive, and then the shape of the tumbler is almost out, but it is not very pretty. So I took another piece of orange paper, carefully cut it into a triangle, and rolled it into a little hat and put it on top of the tumbler's head.

The final step is to dress it up with bright colored pencils.

Use scissors to poke a small hole in the tip of the egg, and be careful, it must not be too big! Then pour out the egg yolk and egg white, preferably in a bowl, and eat it, wash the eggshell with water and dry it with a hair dryer. Pour soybeans or sand into it, no more than 1|3. Otherwise, you won't be able to stand up.

Light the candle, drip the candle water into the egg, fix it, make a hat on top of the hole to cover the hole, draw the nose, mouth, and that's it

Recently, the school has to hand in handmade products, but don't always be unavailable, there is wood and something else? (⊙o⊙)？

Tools required: cardboard, scissors, pencils, double-sided tape, twist ball base, bouncy ball, plasticine.

1. First prepare the materials for making the tumbler: cardboard, plasticine, twisting ball base, bouncy ball or glass pinball, pencil, scissors and double-sided tape.

2. Knead the plasticine into a round ball.

3. Fill the kneaded plasticine into the base of the twisting ball.

4. Stuff the bouncy ball or pinball into the middle of the plasticine.

5. Glue a circle of double-sided tape on the groove of the twisting ball base.

6. Next, make a cone shape with cardboard. The Prudence first drew a circle with a compass or other tool and cut it out.

<>8. Roll into a conical shape, pay attention not to seal it at this time.

9. Glue the conical shape to the double-sided tape, adjust the size, and seal the cone.

10. In order to make the shape more vivid, draw a small smiley face on the cone-shaped filial piety.

11. The cute tumbler is ready.

Tool materials: double-sided tape, eggshell, plasticine, glue, scissors, marker, compass, cardboard.

Here's how to make a tumbler:

1. Draw a fan shape with a compass on the cardboard and cut it out.

2. Roll into a conical shape and paste double-sided tape to fix it.

3. Put the plasticine into the eggshell.

4. Connect the finished cone with the eggshell.

5. Place the tumbler on a smooth table, try to push it, the tumbler will automatically stand up again, and the tumbler will be ready.

The steps to make a tumbler are as follows:Material preparation: a chicken sail without an eggshell, a piece of colored paper, a colored pen, a pair of scissors, and a bottle of glue.

1. Open the egg from the pointed end and wash it, and put it in a weighty object.

2. Cut out a circle on colored paper.

3. Cut off the quarter of the circle.

4. The colored paper is arranged into the shape of a cone.

5. Glue the conical shape to the egg shell.

6. Use a colored pen to draw this expression on the eggshell.

7. A tumbler is done.