The best run in method for the first 1000 kilometers of the new car

The new car has been run-in before leaving the factory, but in order to keep the mechanical system in the best condition and prolong the service life in the future, it is recommended that you drive your car carefully for the first 1500 kilometers and maintain it in stages.

1 100 km, the new friction brake pads have not yet reached the braking effect of 100, the brakes should have an amount of advance, especially in the first 200 km, the tire friction is not enough, so it is necessary to use more force than normal when braking. This also includes when you have just changed your tires or brake pedals.

2 For the first 500 km, the new tyres have not yet reached optimal adhesion, so try to avoid sudden braking when cornering fast.

3 In the first 1500 km, drive gently, at a speed of no more than 100 km/h and no more than 2500 rpm.

Do not make the speed reach the limit in each gear, and the speed of each gear per hour should be controlled within three-quarters of the top speed, roughly: 1st gear 25 km, 2nd gear 40 km, 3rd gear 60 km, 4th gear 90 km, 5th gear 100 km. Don't practice your driving skills at this time and run wildly.

In addition to the speed limit, it is also necessary to strictly implement the driving injury procedures, one is to avoid the throttle full open; The second is to maintain the normal operating temperature of the engine. At the same time, the new car should not be tired, the load rate should be less than 90, and choose a flat road to drive.

Since the parts are still in the running-in period, excessive load and excessive speed will aggravate the impact on the parts. In addition, the car should also pay attention to avoid emergency braking as much as possible during the run-in period, and pay attention to preheating when starting the cold car. Strive to start slowly and stop slowly.

Drive slowly, don't exceed 80, remember to step on the small throttle, don't bomb the oil, just run in at high speed, and the speed is even.

First of all, you're sure you haven't drunk and have a driver's license And then, the speed is 90 is the best, and it's good for the engine and gearbox, the first maintenance is recommended to be about 2000 kilometers, and the second maintenance is 5000 kilometers, and the transmission oil has been changed because there are too many iron filings in it, plus don't bang the throttle upstairs, don't accelerate sharply, slow down sharply, that's all, I wish you a happy car purchase... Russia is a car repairer...

Summary. Hello The run-in period of a new car refers to the first period of time in the use of the new car, including the gradual adaptation and run-in process of various parts such as the engine, transmission, and suspension system. Normally, the run-in period of a new car varies from 3,000 km to 5,000 km.

During this time period, it is advisable to follow the following principles:1Pay attention to the speed of the vehicle:

New cars should not exceed the speed limit during the run-in period, do not drive on the highway for a long time, and should maintain an appropriate speed. 2.Avoid hard acceleration and braking:

During the run-in period, it is necessary to avoid rapid acceleration and braking, and maintain a relatively stable driving state to fully run in the engine, transmission, brake and other parts. 3.Appropriately enhanced maintenance:

During the run-in period, it is necessary to pay attention to vehicle maintenance, such as keeping the engine oil clean, changing the engine oil in time, cleaning the engine auxiliary equipment, etc., to ensure the long-term service life and performance stability of the parts. In short, the run-in period of the new car is an important driving stage, and proper run-in can ensure the smooth operation of the vehicle, prolong the life of the vehicle, and improve the performance and stability. However, according to the actual situation, it is necessary to follow the manufacturer's advice and check and maintain it in time.

Hello The run-in period of a new car refers to the first period of time in the use of the new car, including the gradual adaptation and run-in process of various parts such as the engine, transmission, and suspension system. Normally, the run-in period of a new car varies from 3,000 km to 5,000 km. During this time period, it is advisable to follow a few principles:

1.Pay attention to the speed: the new car should not exceed the speed limit during the run-in period, do not drive on the highway for a long time, and should maintain an appropriate speed.

2.Avoid rapid acceleration and braking: During the run-in period, it is necessary to avoid rapid acceleration and sudden braking, and maintain a relatively stable driving state, so as to fully run in the engine, transmission, brake and other parts.

3.Appropriate maintenance: During the run-in period, it is necessary to maintain the heavy vehicle, such as keeping the oil clean, changing the oil in time, and cleaning the engine auxiliary equipment, so as to ensure the long-term service life and performance stability of Hongru parts.

In short, the run-in period of the new car is an important driving stage, and proper run-in can ensure the smooth operation of the vehicle, prolong the life of the vehicle, and improve the performance and stability. However, according to the actual situation, it is necessary to follow the manufacturer's advice and check and maintain it in time. <>

The run-in period is about 3,000 to 5,000 kilometers, and it is OK to <>

The run-in period of new cars is generally about 1000-1500 kilometers. The running-in period, also known as walking, refers to the running-in of the internal parts of the new car in the initial stage, which also has the meaning of the running-in between the driver and the car. However, with the progress of modern automobile technology, the run-in period of new cars has also been greatly shortened, if we drive cautiously, running 1000 kilometers is basically past the run-in period.

During the run-in period, the owner needs to control the speed of the vehicle reasonably, and avoid sudden braking and rapid acceleration. Preheat the vehicle before starting, so that the engine can be lubricated normally, so as to avoid unnecessary failures of the car during the run-in period, which will affect the normal use. It takes about 1000 km for the engine to run in, and for the first 500 km, you can try to drive at 60 to 70 km/h at no more than 2200 rpm; Between 500 and 1000 km/h, the speed can be increased to 90 to 100 km/h, and the rpm is below 2500 rpm, which can promote the run-in.

Characteristics of the run-in period of the new car: 1. There are many small problems in the vehicle. The failure of the new car during the run-in period is normal, because the parts of the new car in the run-in period can not be fully run-in, it is easy to have some relatively small faults when driving, coupled with bad driving habits will increase the probability of car failure, and the owner needs to pay attention when driving during the run-in period.

2. High fuel consumption. The new car is in the run-in period, because the gap between the various parts of the engine is relatively small, in the process of engine operation needs to distinguish greater power, fuel consumption will therefore rise, the new car in the run-in period of high fuel consumption 1-2 oil is also more common, after the run-in period, fuel consumption is still high, it is recommended that the owner timely leak the inspection, to avoid other faults caused by the car. 3. Lubricating oil is easy to deteriorate.

Excessive friction between the various parts of the new car will increase the temperature of the lubricating oil during operation, and at the same time, some impurities will fall into the lubricating oil during the operation of the vehicle, and the oxidation and deterioration of the lubricating oil may occur.

The run-in period of the new car is generally 1000-3000 kilometers, the new car needs the owner to reasonably control the speed during the run-in period, avoid sudden braking, rapid acceleration of the operation, preheat before the vehicle starts, so that the engine can be lubricated normally, to avoid unnecessary failures of the car during the run-in period, affecting the normal use.

The run-in mileage of cars is generally 1,000 to 2,500 kilometers, and imported cars are longer, mostly 1,500 to 3,000 kilometers. The run-in period is divided into 3 phases. Namely:

The initial 100 km, the initial run-in is 200 km, and the run-in forms an oxide film for 3000 km.

Usually do a good job of inspection and maintenance, and pay attention to the following aspects of the problem, to improve the quality of running-in.

1) Before starting to preheat the EFI car, you should turn the key to the second gear and wait for 5 10 seconds before starting. After the key door is opened, the gasoline pump is turned on to adjust the oil pressure and fuel injection volume, so it is good for the motor and engine of the car to start it after a few seconds.

2) Do not drive at high speed, new cars have speed regulations in the initial stage, domestic cars are generally stipulated within 40-70 kilometers per hour; Imported cars are generally stipulated in the initial 1000 kilometers, when the throttle is fully open, the speed does not exceed the maximum speed of 80, and it is required to pay attention to the engine tachometer and speedometer in use, so that the engine speed and speed are working at medium speed. Generally speaking, the engine speed during the break-in period should be strictly specified between 2000 and 4000 rpm.

3) Avoid overload, re-run the car with full load, which will cause damage to the parts. Therefore, in the first 1000 km, domestic cars can not exceed 75 -80 of the rated load; Imported cars cannot exceed 90 percent of the rated load. In addition, try to choose a better quality road surface to avoid excessive vibration, collision or emergency braking, and reduce the load on the body and power system.

4) Do not remove the speed limiter in advance, the speed limiter is a throttling device installed between the carburetor and the intake pipe. The driver should not remove it in advance, but after the initial 1000 kilometers in conjunction with the initial driving maintenance. Imported cars generally do not add speed limiters, and the speed is completely controlled by the driver.

5) Avoid running long distances, and new cars run long distances, which will increase the continuous working time of the engine and aggravate the wear of parts.

6) Avoid emergency brakingEmergency braking not only makes the braking system in the run-in be impacted, but also increases the impact load of the chassis and engine, so do not use emergency braking within the initial 300 kilometers.

The run-in mileage of the new car is about 1000-2500 km.

It is divided into three stages, driving to 100 kilometers for the initial run-in, 200 kilometers for the initial run-in degree, 3000 kilometers for the run-in to form an oxide film.

The new car should avoid full load driving during the run-in period, because excessive load will lead to an increase in the load of the engine and transmission, so that the output power of the engine is too large, resulting in excessive wear of the parts. Therefore, the owner should understand the maximum load mass of the car, so that the new car can avoid full load driving during the run-in period, so as to prolong the service life. The owner can find the curb weight and the allowable gross mass data on the car product manual or configuration sheet.

The curb weight is the quality of the car according to the factory technical conditions (such as spare tires, tools, etc.), and all kinds of oil and water are filled; The allowable total mass refers to the total allowable mass of the car when it is ready to drive under normal conditions, including carrying people (including the driver) and carrying goods. The allowable total mass minus the empty mass is the maximum carrying mass of the vehicle, that is, the maximum mass of people and goods that the vehicle can bear.

The break-in period for new cars is usually less than 1,500 km.

Different OEMs have different requirements for running-in mileage, but there are only slight differences. For example, most of them require 1,500 kilometers, but some require more than 2,000 kilometers. There is no need to be serious about this.

Running-in can be carried out in accordance with the requirements of the first volume of vehicles; Today's new cars can be driven on the highway. To be precise, they can get on the highway right out of the factory, not to mention the highway and elevated road. The run-in of cars now is very different from what it used to be.

As we all know, the vehicles in the past have to go through a long period of running-in, which is mainly due to the insufficient level of vehicle manufacturing in the past and poor technology, resulting in low precision of parts.

For example, the friction surface of the gear tooth surface, cylinder wall, sliding bearing and other parts is too rough, which requires a long time of running-in, and the excess part of the rough surface is worn off by controllable low wear, so that the friction surface becomes smoother. This was the break-in method for early vehicles. The requirements are also strict.

For example, it usually requires more than 5,000 kilometers of long-distance running-in, and there are strict requirements for engine speed and vehicle speed.

How to quickly deal with formaldehyde and smell in a new car?

1. Place the bamboo charcoal bag, which is an item with strong adsorption capacity.

2. Do a good job of ventilation measures and open windows frequently.

3. Put some peel to remove the taste.

Summary. Dear, the new car run-in needs the following:1

Try not to brake urgently: Emergency braking not only impacts the braking system in the run-in, but also increases the shock load on the chassis and engine, and it is best not to brake urgently during the first 300 kilometers. 2.

Don't overload: If the new car runs at full load during the run-in period, it will cause damage to the parts. Therefore, within the first 1000 kilometers, the general load capacity should not exceed 75%-80% of the rated load.

3.Running high speed: the new car runs long distance during the run-in period, the continuous working time of the engine will increase, which is easy to cause wear and tear of the parts, it is recommended to run at high speed as long as the speed of 120 mph does not exceed 3000 rpm, if it exceeds 3000 rpm, consider reducing the speed, control the speed at 3000 rpm.

Hello dear, the run-in period of the new car is about 5000 kilometers. The engine grinding period is about 3000 kilometers of driving distance, the gearbox is mainly to amuse the gear mountain laughter between the running-in, the running-in period is about 5000 kilometers of driving distance, the shortest running-in time between the tire and the ground, about 200-300 kilometers or so.

Dear, the new car run-in needs the following:1Try not to brake urgently:

Emergency braking not only makes the braking system in the run-in be impacted, Danqing digging will also increase the shock load of the chassis and engine, in the first 300 kilometers, it is best not to brake urgently. 2.Don't overload it:

If the new car is running at full load during the run-in period, it will cause damage to the parts. Therefore, within the first 1000 kilometers, the general load capacity should not exceed 75%-80% of the rated load. Modular nucleus 3

Running high speed: the new car runs long distance during the run-in period, the continuous working time of the engine will increase, which is easy to cause wear and tear of the parts, it is recommended to run high-speed time difference as long as the speed of 120 mph does not exceed 3000 rpm, if it exceeds 3000 rpm, consider reducing the speed, control the speed at 3000 rpm.

Dear, during the run-in period after buying a new car, we must pay attention to the use of the vehicle, and try to keep the vehicle in a light-loaded rubber car state to avoid overweight; Pay attention to the operating status of each component of the vehicle at any time, such as water temperature and oil pressure; Drive at a constant speed, not drive violently and violently, and develop a good driving habit. After the run-in period, you can use it with confidence, and if the run-in period is better, it will bring better fuel economy and safety to the vehicle in the future.