-
Anonymous users2024-02-11One case is a problem with the keyboard interface, you can unplug it and plug it back in.
The second way is to go to the BIOS and choose to read the BIOS default settings, that is"load..."I don't remember exactly what English it is, but there are two"load...", you must choose the one above, and finally save to exit, restart!
-
Anonymous users2024-02-10The computer battery is dead or the BIOS is set incorrectly or you don't have a soft zone.
-
Anonymous users2024-02-09I'm going to press f2 I don't know why, oh, I didn't use it before, I don't know how it became like this,,, who will tell me,
-
Anonymous users2024-02-081. Look at whether the settings in your BIOS are incorrect, if it is incorrect, change it in BIOS, and then turn off FLOPPY in BIOS, and some motherboards will have the option to boot F1, if so, turn it off and change it to Disable. Then restart and take a look.
2. If the first method does not work, reset the BIOS, or restart after discharging to see the next 3. The second method does not work to replace the motherboard battery.
4. If it doesn't work, let the manufacturer test the motherboard.
-
Anonymous users2024-02-07The boot displays "warning:immediately backup your data and replace your hard disk drive,a failure may be imminent".
The error message "warning: immediately backup your data and replace your hard disk drive, a failure may be imminent" indicates that there is a serious error on the hard drive, and such a place often includes a detailed description of the cause of the error and the area where the error occurred.
The most thorough way to solve this problem is to replace it with a new hard drive, and if the hard drive is still usable for the time being, you should back up your important data as soon as possible.
-
Anonymous users2024-02-061. Shield the floppy drive in the BIOS settings.
Press the DEL button when you boot it (some motherboards press F2), and after entering the BIOS, look at it in CMOS.
drive a option.
Change the option to none
After that, press F10 to save and select [Y].
2. Set it in boot, as follows: bootboot settings configuration put "wait for".'f1' if' error", read"disabled”。
Then F10 is OK to save and exit.
3. If the above methods fail to solve the problem, it is recommended to replace the motherboard battery.
-
Anonymous users2024-02-05Computer problems, you know, it will be better to smash it directly.
This kind of fault is generally caused by the insufficient voltage of the motherboard battery, which can be replaced, but some motherboard batteries can not solve the problem after replacement, at this time there are two possibilities: 1. The motherboard circuit is a problem, which should be repaired by professionals; 2. The CMOS jumper on the motherboard is due to human failure, and the CMOS jumper on the motherboard is set as the clear option, so that the CMOS data cannot be saved.
Turn the floppy drive on the shield.
Go to the BIOS to change the settings, press F1 to check the situation when the floppy drive occurs, so that it does not detect the floppy drive. >>>More
After entering the BIOS, there is an Advanced or Boot option, just select First Boot as CDROM or ***ROM, and then F10 to save and restart.
1. Restore or optimize BIOS settings.
After turning on the computer or restarting the computer, "CD...... is displayed on the screen, press the "DEL" key to enter the BIOS settings interface, award >>>More
You need to press the F1 key to enter the boot, mainly because the settings in the BIOS do not match the real hardware data, which can be divided into the following situations: >>>More