I always have to press F1 to get in when my computer is turned on.,It s very troublesome how to chan

1. Restore or optimize BIOS settings.

After turning on the computer or restarting the computer, "CD...... is displayed on the screen, press the "DEL" key to enter the BIOS settings interface, award

Load BIOS defaults, this option is used to load the BIOS initial settings to determine the scope of the failure.

Load Oprimum Settings, which are optimized settings for the factory BIOS.

or AML Load BIOS Setup Defaults, which is used to load the initial BIOS settings.

Load High Performance Defaults, which is used to load BIOS optimization settings.

After selecting the default or optimized value with the keyboard arrow keys, press the Esc key, F10 key, and Y key to save and exit the settings.

2. Turn off the floppy drive.

Reboot, press Del into the BIOS, find Standard CMOS Setup, press Enter in the open interface, change Drive A: and DriveB: to None, set Floopy to Disable, press ESC, F10, Y, save and exit the settings.

3. Check and replace the motherboard battery.

Turn on the computer to see if you don't need to press F1 anymore.

To press f1 to start: There are several reasons:

1. The CMOS parameter settings are incorrect

Floppy drive: If the floppy drive is not detected, please check whether the data cable is connected, and then see if the settings in the BIOS are correct: check the settings of the boot sequence; In addition, if there is no floppy drive, it is directly shielded.

Keyboard: Some CMOS settings in the keyboard problem will also appear press F1 to boot the situation, the landlord to check it himself.

Memory: Disable Memory Verification.

2. Prompt for insufficient BIOS battery power - replace the battery 3. Jumper setting problem - refer to the manual to set.

press f1 to resume

In addition, it may be a non-fatal hardware error that can be replaced with a check.

The battery is dead, 2It's okay to disable the floppy drive in the BIOS, and you probably don't have a floppy drive.

These two conditions are more common.

It's good to change the address when the power is out.

Popularize computer repair and application knowledge.

This situation is generally caused by the boot detection floppy drive, and the BIOS setting error caused by the sudden power failure and crash of the computer.

Here's how to fix it:

1. Press the DEL button to enter CMOS when you boot up;

2. After entering, press the enter key in the "standard CMOS featrues" directory;

3. Change the value of "floppy drive a" to close, and change the value of "hold on" to "no error";

4. Press F10 to save and exit.