My computer has to press F1 to boot

Turn the floppy drive on the shield.

Go to the BIOS to change the settings, press F1 to check the situation when the floppy drive occurs, so that it does not detect the floppy drive.

After powering on, press and hold the del key.

Go to the BIOS and then enter the first item, set Flopyy (floppy drive to) None or Disable, then press F10, click Y to save, and then reboot. `

There are several scenarios:

1.There is no floppy drive in the computer or the floppy drive is broken, but the BIOS is set with a floppy drive to boot first.

a.Turn off the floppy drive for priority start.

b.Turn off the power-on floppy drive detection function: press Del on boot to enter the BIOS >"advanced bios features" > "boot up floppy seek" > "disabled"

2.It turned out that there were two hard disks hung, and two hard disks were set up in the BIOS, and then one was removed, but I forgot to change the BIOS settings.

3.A dead motherboard battery can also cause data loss and cause this failure.

You can change the settings in the BIOS.

If you change the settings, it still doesn't work.

Then you check if your optical drive is connected correctly.

But I think it's usually a matter of setting up in the BIOS.

BIOS Problems! The CMOS battery is dead or there is a problem with the BIOS settings, the brothers above have already said, if it doesn't work to change the battery, just do what they say!

Turn off all floppyy settings in the BIOS!

Removed from the startup sequence!

Absolutely!

This relationship is not very big, you can change the jumper under the setting, see the Tianji network specifically.

Press it, press it, don't change it yourself, change it wrong, and take the electronic city when you want to make a system.

To press f1 to start: There are several reasons:

1. The CMOS parameter settings are incorrect

Floppy drive: If the floppy drive is not detected, please check whether the data cable is connected, and then see if the settings in the BIOS are correct: check the settings of the boot sequence; In addition, if there is no floppy drive, it is directly shielded.

Keyboard: Some CMOS settings in the keyboard problem will also appear press F1 to boot the situation, the landlord to check it himself.

Memory: Disable Memory Verification.

2. Prompt for insufficient BIOS battery power - replace the battery 3. Jumper setting problem - refer to the manual to set.

address

areinvalid

inboth

apcand

dmipress

f1toresume

In addition, it may be a non-fatal hardware error that can be replaced with a check.