Problem 15 after the phone is connected to the router

Updated on technology 2024-06-16
6 answers
  1. Anonymous users2024-02-12

    1. Do you use Kaspersky Antivirus or Kaspersky Firewall, or is it similar to Kaspersky's incognito mode function? If yes,Then you just turn off this incognito mode,Don't be incognito on the network, this situation won't occur after stealth,Invisibility sometimes affects BT** speed,There is also P2P network TV。 A reboot of the machine or cat can sometimes do the trick, but it won't solve the problem at all.

    The fundamental reason for this situation is that the broadband network you use (such as telecommunications, Netcom, Tietong, etc.) often has to detect your computer, and this situation will occur when the other party cannot detect your computer network card, and when this situation occurs, your network card does not get the IP address at that time, so this situation will occur.

    It's not a big problem, though. Generally, this problem is not easy to occur, unless the broadband network you use needs to be adjusted to the network.

    2. Check whether there is strong magnetic field interference in the place where the network cable passes.

    Third, the cause of static electricity, friction has static electricity, let alone the computer. The computer's computer source conversion and display will produce static electricity, especially the computer's power conversion is in a high-frequency oscillation state of 500kHz is the most culprit of the chassis electrification, find a piece of wire, connect it to the ground wire on the power socket, and connect the other end to the iron post on the window sill. You can measure the voltage change of the front and rear chassis, which is not small.

    The normal chassis voltage should be around 3 volts (I haven't measured it myself, my friend said, there should be no problem).

    Fourth, in addition, there are certain requirements for the first line to use ADSL modem to access the Internet, one is that each joint of the line should be connected, and the other is that any equipment can not be connected before the ADSL modem separator, such as: ** extension, anti-theft device, etc. When reconnecting the binding post of the junction box, it is best to wipe the ** wire and the binding post with fine sandpaper, and wrap the ** wire on the binding post a few more times when wiring, and then tighten the screws to ensure good contact.

    Remove the first socket at home, use direct wiring, it is best to use welding when connecting wires with wires, and then wrap them with insulating tape, anyway, you can't connect any equipment before the separator, so as to ensure that the line contact between the junction box and the adsl modem separator is good, and the quality of signal transmission is ensured.

  2. Anonymous users2024-02-11

    I guess the wifi is unstable, try to reconnect.

  3. Anonymous users2024-02-10

    Dear Hello If the connection between the phone and the router is out of order, you can try the following solutions:1Restart your phone and router:

    Sometimes connection issues can be caused by network conflicts or device caching issues. Try turning your phone and router off and back on, respectively, and connecting them again. 2.

    Make sure the wifi password is entered correctly: Check whether the password entered when the phone is connected to wifi is correct. If the password is wrong, you won't be able to connect to the router.

    3.Check WiFi signal strength: The distance between your mobile device and your router may affect the stability of your WiFi connection.

    Try to keep your phone as close to the router as possible to make sure the signal strength is strong enough. 4.Clear the web cache:

    Sometimes web caching can cause problems with escort connections. Find the Network Settings option in your phone's settings and try clearing the network cache before trying to connect again. 5.

    Update router firmware: If your router firmware is outdated, it can cause connectivity issues. Check your router's official ** for the latest firmware update reputation, and follow the instructions to update it.

    6.Reset your router: If the above methods still don't solve the problem, you can try restoring your router to factory settings.

    Note that this will erase all custom settings, including wifi names and passwords, so make sure you have a backup of this information. If the above methods still do not resolve the connection issue, it is recommended to consult network technical support or contact the manufacturer of the router for further assistance. Hope mine can help you

  4. Anonymous users2024-02-09

    Hello, according to the problem description you provided: To solve the problem of abnormal connection between your phone and router, you can try the following steps:1

    Check your network connection: Make sure your phone and router are connected to the power source and that your network cable or Wi-Fi signal is stable. If you are using a Wi-Fi connection, make sure that there are no obstructions between your phone and the router blocking the signal.

    2.Reboot your device: Simply restarting your phone and router can fix the connection issue.

    Try turning off your phone's Wi-Fi function first and then turning it back on; Next, unplug your router and wait a few seconds before plugging it back in. 3.Check your password and security settings:

    Make sure that the Wi-Fi password you entered is correct and that you haven't changed your router's security settings. If you're not sure if your password is correct, you can try connecting a different device to verify. 4.

    Update software and firmware: Make sure that both your phone and router's operating system and firmware are up to date. Updating software and firmware can fix known connectivity issues.

    5.Reset your router: Consider restoring your router to its factory settings.

    This will clear all the custom settings you have in your tracks, including your Wi-Fi name and password, so make sure you have a backup of this information before doing so.

  5. Anonymous users2024-02-08

    Hello dear, happy to answer your <>

    The abnormal connection between the phone and the router may be caused by a variety of reasons, please try the following solutions:1Make sure that the phone is close to the router and that the signal strength is sufficient

    Hold your phone close to the router to avoid obstacles and try to connect. 2.Restart your router and phone:

    First, unplug the router, wait about 30 seconds, then plug it back in and wait for the router to boot up completely. At the same time, turn off your phone, wait a few seconds, and then turn it back on. Then try to reconnect.

    3.Check the wireless network name and password: Make sure that the wireless network name (SSID) and password entered when connecting to the handheld machine are correct.

    The correct information can be found on the router's settings screen or on the back of the router. 4.Confirm that the router is working properly:

    You can try to connect to the router by connecting other devices (such as computers, tablets, etc.) to confirm that the router itself is working properly. If other devices also can't connect, it may be a router configuration or hardware issue that needs to be further checked and repaired. 5.

    Turn your phone's Wi-Fi off and back on: Turn off Wi-Fi in your phone's settings, wait a few seconds, and then turn Wi-Fi back on and on again, and try to reconnect to your router. 6.

    Clear your phone's Wi-Fi cache: Find it in your phone's settings"Application management"or"App Information", select"wi-fi"or"Wi-Fi"Related options, try clearing the cache and reconnecting. 7.

    Update the router firmware: In the router's settings screen, check if there is a new firmware available, and if so, follow the operation guide provided by the router manufacturer to upgrade it. If the above methods still do not solve the problem, it is recommended to contact the router manufacturer's technical support or network service provider for further help.

  6. Anonymous users2024-02-07

    Summary. The reasons why the mobile phone is connected to the wifi but the network is abnormal and cannot access the Internet are: 1. The wifi itself is a problem, and the wifi may not be connected normally, resulting in the inability to access the Internet.

    The reasons why the mobile phone is connected to the wifi but prompts that the network is abnormal and cannot access the Internet are: Qing Laxian 1, the wifi itself is a problem, and the wifi may not be connected normally, resulting in the inability to access the Internet.

    I'm sorry I don't understand, but can you elaborate on that?

    2. Router problems, the router may be overheated or damaged. 3. It is possible that the broadband is in arrears, resulting in the inability to go to the game and lose the network. 4. The wifi name package contains Chinese, resulting in some mobile phones unable to connect to the Internet.

    5. There may be a problem with the mobile phone system, which may cause the connection to wifi but the Internet cannot be accessed.

Related questions
16 answers2024-06-16

I want two threads.

The wiring sequence is. >>>More

7 answers2024-06-16

There are two situations, first: your computer is poisoned by ARP, as soon as you start the Internet virus, trick other computers into sending data packets to your machine, and your computer throws away these packets, their computer will not be able to get on, use 360 to kill the virus. >>>More

24 answers2024-06-16

Now you can live without a computer at home, but you can't live without wifi. Because mobile phones must use wireless Internet access. But if you don't have a computer and need to set up a router, how do you set up a router on your phone? Today, we're going to talk about how to set up routing with your phone. >>>More

17 answers2024-06-16

Set up your wireless router again.

Does the cat connect to the wireless router, do you do this: >>>More

12 answers2024-06-16

Connect the network cable from the cat with the WAN port on the router, and connect the computer with the network cable to the user terminal on the router. After connecting, enter it in the browser, and you can open the router interface. The username and password are generally admin, and you can enter your broadband username and password after entering, and the router will be turned up at the most.