Find the software and methods of hard drive data recovery

I've encountered this problem before...

It's that the other disks of the computer are gone, only the C disk and an unpartitioned hard disk are left, **A Disk Genius software, use Disk Genius to rebuild the partition table, but this software needs to run in a pure DOS environment, and it needs to be next MaxDOS

Don't know what system you are. You go to search,The next maxdos corresponding to your system,Restart after installation,Keep pressing the downward arrow key when restarting,Sometimes you can not press it,Then select maxdos,Enter,Find it,There is a pure DOS option,Enter the post-DOS environment,Enter the name of the disk genius running program,Press enter to start disk genius,The following operation,I won't go into detail here,Go to the Internet to find a disk genius tutorial.。。。

This method only works sometimes, sometimes it doesn't, good luck...

If you have important information, it is recommended to find a professional to take a look, and you have to collect tickets. . .

I also have the same experience as the landlord, don't add or delete any data on the hard drive, or install the program, I later recovered more than 90% of the data, it is useless to use easyrecovery, I will tell the landlord my experience.

On someone else's computer, remember to search for the serial number, which should be together, and then install it on the U disk on your own computer, and then run, remember to get a mobile hard disk, because the data recovery needs to be put somewhere, and putting it on your own computer will directly lead to the inability to recover other data.

It's a bit slow.,I didn't recover until nine o'clock in the morning.,But the landlord can breathe a sigh.,Because it's a mobile phone to surf the Internet.,Can't restore the easy data to you.,I'm sorry.。

If you draw a slash, you can't recover it.

If you don't complete the following operations, you can do it again, it doesn't matter, it doesn't matter much.

1. If it is a hard morning hall failure, if you do not recognize the disk, you should stop the power-on attempt, and then restore the data. If it is a logical fault such as accidental deletion, it is recommended that you directly contact a professional organization to help restore the data if it is important.

2. If you want to try to recover by yourself, you can sweep down the hard disk partition and try it. The location of the partition where the recovered files are saved cannot be the same partition as the lost files.

3. The most rigorous method is to connect the hard disk that needs to be recovered to the slave disk, and then scan the slave disk through the main disk boot, and restore it to the main disk partition. In this way, it avoids the coverage caused by the misoperation of Lu Bian. It should be noted that the data recovery software is very limited in the actual recovery ability, and the operation steps are irreversible.

Method steps2.Install the software on your computer.

Once the installation is complete, double-click on its shortcut.

3.This interface will appear when the software is opened.,See each function yourself**Oh.。

4.Locate the disk from which you lost data in the figure below.

5.Right-click on the disc found in the previous step.

As indicated, right-click, click.

This one is in the scan of the flag, and so on.

6.When the scan is over, a new partition that was not previously available will appear at the very bottom of the partition.

7.Double-click on the section at the bottom, the section inside the green box.

8.Wait a minute, this one is going to take all of your lost files.

According to the second picture**, select the Chinese part first.

Click the button that is not overridden in that **.