How to solve the toilet drain blockage by yourself

Buy a 2-meter pipe dredge at the stall, make some bends at the head 2 cm, and put water on one side and extend it through the water outlet.

Dredging, stretch in while shaking, and then reach into the dredge at the water inlet while draining the water, repeat it several times! Meantime.

In the future, it should be dredged every other week.

If a professional comes, you can use manual methods first, do not pour water, or you can surround the pool to prevent water from splashing. Of course, everything else has to be put away. And you have to make sure that it is dredged in a short time, otherwise the smell will be very strong.

2. Find a wire with a diameter of millimeters, 3-4 meters long, fold it in half from the middle, and then twist it into a strand, and then turn it into a single end.

Bend both ends in different directions, then put this one end into the sewer pipe, grab the other end, and go inside.

While twisting in one direction, if you encounter resistance and can't stretch in, just pull out, don't twist at this time, drag directly, some sundries can be hooked out, repeated several times can basically dredge, if your wire hook can't get something, it is unblocked, then the problem may not be your home, it may be blocked downstairs pipeline.

3. The sewer is full of water, press down with a leather plug, and then lift it violently, so that a certain pressure will be formed.

and pumping, which may flush away the clogged debris; But if it's stuffed too hard, I'm afraid only the serpentine tube will do, and you can also use the wire mentioned above, but this is expensive and not easy to get, it's best to find someone to dredge it, and there is another one called a tube.

The road dredging agent is sold in supermarkets, and you can also try it.

4. If the problem has not been solved, then find a professional dredging company.

If the sewer is clogged with food, a particularly convenient method is introduced: first fill the sewer with water, then take a wet towel to wrap the outlet of the trachea that pumps the bicycle, and then take the wrapped end and stuff it into the sewer, plug it hard, and if possible, you can wrap it with tape to ensure that there is no air leakage. Now you can use the trachea to pump up the sewer.

Under normal circumstances, there is an air pressure that can push the debris out.

1. Waterway dredging agent: Waterway dredging agent is particularly effective for clogging and dredging caused by hair, greasy, paper, etc. It is widely used in restaurants, hotels, homes, etc. for dredging vegetable sinks, basins, bathtubs, floor drains, and toilets.

Do not damage sewer pipes (including PVC pipes) and do not damage the plating layer.

How to use: Remove the stagnant water in the sink or sanitary ware, pour 50-100g of this product into the sewer pipe, if there is no water in the sewer, ** into half a cup of water. At this time, the pipe is boiling. Rinse with plenty of water after about 20 minutes.

Recommended dosage: basins, bathtubs, floor drains - 100g, vegetable sink - 200g, toilet - 400g.

Second, the practice of dredging the bathtub sewer blockage: mainly to deal with the hair left in the bath and cause blockage, because the bathtub drain is covered, can only be dredged from the floor drain, go to a small store to buy a 8 yuan hand spiral wire, (diameter of about 6 mm) from the floor drain while shaking down until the hand has a foreign body feeling, and then gently pull out while shaking, the blocked hair and other dirt will be swung on the spiral wire, the problem is solved. It is even more convenient if there is no cover at the drain in the bathtub.

Don't use hydrochloric acid, first of all, pollute the environment, secondly, it is easy to cause danger to the human body, and again, the pipeline is easy to be eroded by hydrochloric acid and perforated for a long time, and the trouble is even greater).

3. Put the caustic soda into the mouth of the sewer, and then pour a pot of boiling water into it, not a warm kettle, but a large kettle for boiling water.

Fourth, if you have used the water to pour the child and ask the worker to use the iron branch to pass through and slightly smooth, but then do not go to the water, it is not suitable to use the iron branch again, for fear that the anti-corrosion channel will be penetrated. You can use thick rattan instead, the rattan head can be nailed ten eight inches long iron nails, one side stretches into one side and turns and stirs, loosen the debris, and then pour it with a concentrated alkali solution, and then push the rattan out and pull it out, if it continues many times, it can be effective. In addition to thick rattan, you can also buy a spring canal device from a hardware store, which has a better effect.

Salt, white vinegar, straws, etc., used by ordinary people, do not work.

1. First prepare some nylon cable ties, and connect several nylon cable ties end to end as shown in the figure below for later use.

2. Next, use scissors to cut the side of the nylon cable tie with scissors as shown in the figure below.

Clogged toilet drains are a common problem, especially in older houses. Here are some simple ways to help you solve this problem.

The first method: use a household unclogger.

Household unclogging is one of the effective tools to solve the problem of clogged sewer pipes, it can force unclogging pipes and push the blockages out of the pipes. The steps to use the unclogger are as follows:

Step 1: Soak the rubber tip of the dredge in hot water to make it soft.

Step 2: Aim the rubber tip at the drain hole and press down firmly until you push it as low as possible.

Step 3: Quickly lift the dredge upwards and reciprocate more than a dozen times until you hear a click when the water is opened.

The second method: use small sticks or wires.

Sometimes the blockage is too small to be solved by a dredge, so you can use a small stick or wire to try to solve the problem. The steps to use a small wooden stick or wire are as follows:

Step 1: Drain the drain drain and dry it with a towel or cloth.

Step 2: Place a small wooden stick or wire into the sewer hole and gently stick it in.

Step 3: If you feel resistance, stick in until you push the blockage out.

The third method: the use of chemicals.

Chemicals are another more reliable solution. Chemicals can dissolve blockages as quickly as land ants, and the blockages in the pipeline can be removed at one time by arranging certain chemicals. The steps to use chemicals are as follows:

Step 1: Buy a disinfectant and clean solution, and pour an appropriate amount of disinfectant into the drain according to the instructions.

Step 2: Observe the reaction status of the cleaning solution, if you hear a crackling sound, it means that the dirt in the pipe has been swept away.

Step 3: Then rinse the pipes and reinstall the sewer hinges.

In short, unclogging a clogged sewer pipe requires different methods depending on the actual situation. If using a dredge doesn't solve the problem, try using small sticks or steel slag to bury the wire, or use chemicals. When cleaning drains, please pay attention to safety, it is best to use gloves to avoid problems such as **sensitivity due to contact with certain chemicals.

After the sewer pipe in the bathroom is blocked, there are two ways to quickly dredge it. One is to use the pressure of using a cannon to fill the sewer pipe with water, and the hall will take a cannon barrel and poke it hard at the sewer hole, and in general, it will be dredged. The second is to buy some sewer dredging agent, pour the appropriate amount of dredging agent into the sewer pipe, soak it in the sewer pipe for five minutes, and then use flushing water, or high-pressure water gun to charge for a while, and naturally dredge the sewer pipe.