What should I do if I can t hear the sound without headphones plugging in my iPhone?

Hello, take a look at the following methods, no, just go to the maintenance personnel and repair them.

1. The reasons for the silence when the mobile phone is plugged into the headset and the treatment methods are as follows:

1.Check to see if the metal piece inside the headphone jack is out of place, using a ballpoint pen.

The core dials it back.

3.Go to your phone's settings - Mode change - Change the headphone mode to the outgoing sound mode.

4.Use a toothpick to get through the speaker hole, and if that still doesn't work, restart the phone or restore it to factory settings.

5.If it doesn't work, you can only send it for repair to prove that the speaker is damaged.

2. Reasons and solutions for the silence of the mobile phone.

1.Check to see if the metal piece inside the headphone jack is out of place, and use the refill to dial it back.

3.Go to your phone's settings - Mode change - Change the headphone mode to the outgoing sound mode.

4.Use a toothpick to get through the speaker hole, and if that still doesn't work, restart the phone or restore it to factory settings.

5.If it doesn't work, you can only send it for repair to prove that the speaker is damaged.

You should have turned off a small button on the top left side of the phone, you check, it is up and down, it should be dialed to the bottom.

The iPhone phone has no sound when the headphones are plugged in, which is caused by the system delay that does not enter the headphone mode.

1. Unlock your iPhone to the bottom of the main screen page, and press and hold the [Home Button] on the body.

2. By pressing and holding the [Home Button] of the dust, you can enter the control surface sail or segment board of the voice assistant [Siri].

3. In the control page of [Siri], place the command [Turn on headphone mode], and the system will automatically turn on the headphone mode.

4. When the [Headphone Mode] is successfully turned on, the headphone logo will appear at the top of the iPhone screen, which can solve the problem that the iPhone has no sound reputation when the headphones are plugged in.

1. No sound when iPhone plugs in headphones may be caused by damage to the headphone plug or headphones.

2. The remaining possible problem is the headphone jack and the headset itself, the contact damage of the headphone jack may cause the headset to have no electrical signal, but it is unlikely, the reason is that the mobile phone can recognize the headset plugged in.

3. The most likely reason is that the earphone cable near the earphone plug is disconnected, which may cause the two earphones to be silent at the same time.

This is caused by the headset not being successfully plugged into the phone, an error in the phone program, or a hardware issue with the phone.

1. After removing the earphones, slowly plug them back into the phone, and then check if the earphones have sound.

2. Go to the phone settings to set the headphone mode, the specific method is as follows:

1. First, click "Settings" on the desktop of your phone.

2. Then select the "General" option in the settings interface.

<>4. Click on the "Audio Call" option after entering.

<>3. Bring your phone and warranty card to Apple's official repair center for maintenance.