About the safe use of electricity 40, about the safe use of electricity

When people go out of power, the power will be cut off after use, and the power supply will be temporarily cut off when the power is out.

Wall outlets should not be placed too low, and small children should be taught to stay away from power sources, switches, and plugs.

When using screw-port lamps, a fuse should be installed on the lamp head, and it is best to install a cable switch to avoid accidents caused by touching the metal part when switching on and off the lamp.

The push-button power switch on the wall should be repaired in time if it is broken.

When your hands get wet or sweat excessively, do not touch the wire latch and the lamp that uses the light head switch.

Do not go near the wires of the electric stove, so as not to burn the wires and bury hidden dangers.

Do not hang clothes on wires.

If the fuse is broken, do not use iron wire, copper wire, or aluminum wire instead.

When the wire is damaged or broken, do not touch it, disconnect the power supply in time, and then find an electrician to repair it quickly.

If someone is found to be electrocuted, use an insulator such as a dry wooden stick to pick up the power supply, and do not drag the electrocuted person in a state where the power supply is not separated from the electrocuted person.

Measures to prevent electric shock:

1) Household appliances should be connected to the ground wire.

2) Master the knowledge of household appliances and do not disassemble and install electrical appliances by yourself.

3) If you find a problem with the wires, switches, etc., ask a professional to repair it.

4) Do not dry clothes on broken wires.

5) Stay away from high-voltage lines (10 meters away) that are blown by strong winds.

6) It is forbidden to repair electrical appliances on damp floors. If you notice a "thunderbolt" spark, turn off the power immediately to prevent electric shock.

7) During a thunderstorm, you should enter the place with lightning protection facilities in time, and do not take shelter under isolated electric poles, eaves, trees, and chimneys.

1. Residual current action protection device should be installed at the end of the electrical equipment.

Lighting, power lines, and mobile electrical appliances below 4 meters should use a complete copper core rubber sheath soft cable as the power cord, and at the same time, the socket circuit should also install a residual current action protection device.

3. Combustible materials cannot be stacked around electrical equipment, power lines, switches, and sockets.

4. The socket should be connected to a PE wire.

The following points need to be paid attention to in the safe use of electricity:

1. Do not repair or move live lines or equipment at home with bare hands and feet, such as table fans, washing machines, televisions, etc., to avoid electric shock;

2. Do not use metal to touch electricity, do not touch the power supply with wet hands, and do not use a wet cloth to wipe lamps, switches and other electrical appliances;

3. Install the three-pin socket correctly, and do not change the three-prong plug to a two-prong plug at will;

4. Use the power cord correctly, and do not pull or connect the wires indiscriminately;

5. Do not add electrical appliances to the original line without permission;

6. Correct use of household appliances, and shall not use electrical equipment that does not meet safety specifications;

7. Develop good habits, in the case of unattended or long-term non-use, please unplug the power supply of electric irons, hair dryers, electric stoves and other electrical appliances;

8. It is forbidden to use lead wire, copper wire and other substitute fuse wires as fuses;

9. Use leakage protector to prevent personal electric shock and electrical fire.

We hope you find ours helpful.

Legal Analysis: Article 1 of the Electricity Act.

Ten. I.X.

IX.II. Ten. Iv. 30.

Iv, fifty-two, five.

Ten. Article 54 stipulates the following provisions on the safe use of electricity:

1) No unit or individual shall illegally occupy the land for substation facilities, transmission line corridors and cable passages.

2) Electric power enterprises shall strengthen the management of production safety, adhere to the principle of safety first and prevention first, and establish and improve the responsibility system for production safety.

3) The state implements the management principles of safe electricity use, saving electricity and planned electricity consumption for the first and most used electricity.

4) Power supply enterprises and users shall abide by the relevant provisions of the state and take effective measures to do a good job in the safe, economical and planned use of electricity.

5) No unit or individual shall endanger power generation facilities, substation facilities, power line facilities and their related auxiliary facilities.

Blasting and other operations that may endanger the safety of power facilities around power facilities shall be carried out only after approval and measures to ensure the safety of power facilities shall be carried out in accordance with the provisions on the protection of power facilities. No unit or individual shall construct buildings or structures that may endanger the safety of electric power facilities, plant plants that may endanger the safety of electric power facilities, and pile up articles that may endanger the safety of electric power facilities, in the protection zones for electric power facilities designated according to law. Plants that have been planted before the demarcation of the protection zone for electric power facilities in accordance with the law obstruct the safety of electric power facilities shall be pruned or cut down.

1) When any unit or individual needs to carry out operations that may endanger the safety of power facilities in the protection zone of power facilities demarcated according to law, it shall be approved by the power management department and take safety measures before carrying out the operation.

Legal basis: Electricity Law of the People's Republic of China

Article 1 This Law is enacted to safeguard and promote the development of the electric power industry, safeguard the legitimate rights and interests of investors, operators and users of electric power, and ensure the safe operation of electric power。

Article 2 This Law shall apply to the construction, production, development and use of electric power within the territory of the People's Republic of China。

Article 3 The electric power undertaking shall meet the needs of national economic and social development and develop appropriately ahead of schedule。 The State encourages and guides economic organizations and individuals at home and abroad to invest in the development of power sources and set up electric power production enterprises in accordance with the law。

In the investment of electric power enterprises, the principle of who invests and who makes profits is implemented.

Article 4 Electric power facilities shall be protected by the State。

It is forbidden for any unit or individual to endanger the safety of power facilities or illegally occupy or use electric energy.

Article 5 The construction, production, and use of electric power shall protect the environment in accordance with law, adopt new technologies, reduce the discharge of harmful substances, and prevent and control pollution and other public hazards。

The State encourages and supports the use of renewable energy and clean energy for power generation.

Safe use of electricity, there are the following aspects:

1. Do not repair or move live lines or equipment at home with bare hands and feet, such as fans, washing machines, televisions, etc., to avoid electric shock;

2. Do not touch the electricity with metal, do not touch the power supply with wet hands, and do not wipe the lamps, switches and other electrical appliances with a wet cloth;

3. Install the three-pin socket correctly, and do not change the three-prong plug to a two-prong plug at will;

4. Use the power cord correctly, and do not pull or connect the wires indiscriminately;

5. Do not add electrical appliances that exceed the line load on the original line without permission;

6. Use household appliances correctly. Do not use substandard electrical equipment;

7. Use leakage protector to prevent personal electric shock and electrical fire;

8. Develop good habits and unplug electrical appliances such as electric irons, hair dryers, and electric stoves when unattended;

9. Use the power cord correctly, and prohibit the use of lead wire, copper wire, etc. instead of the fuse as a fuse, etc.

(15) The household wiring shall not be directly laid on the flammable building materials, and porcelain beads or porcelain clips must be used if the wiring is needed on the wood; Porcelain sleeves must be used to cross the planks. Do not use flammable plastics and other flammable materials as decorative materials.

16) Although the grounding or neutral wire is not charged normally, if there is leakage after the disconnection, the shell of the electrical appliance will be electrified; In case of a short circuit, the ground wire will also pass through a high current. For its safety, the specification of the grounding (zero) wire should not be less than the phase wire, and no switch or fuse should be installed on it, and there should be no connectors.

17) The grounding wire shall not be connected to the water pipe (because the water pipe joints are now plugged with insulating tape, and there is no grounding effect); It must not be connected to the gas pipe (in case of electric sparks causing gas**); It should not be connected to the ground wire of the ** wire (in case of strong current channeling and weak current); It should also not be connected to the down lead of the lightning cable (in case of lightning counterattack).

18) All switches, switches, and fuses must have covers. Bakelite covers must be replaced if they are aged or incomplete. Those who are dirty and damp must be wiped clean after the power is off before use.

19) Do not drag the power cord on the ground to prevent the power cord from tripping people and prevent damage to the insulation.

20) Before the trial of household appliances, all switches and buttons should be placed in the original shutdown position according to the manual, and then operated in the order of opening and stopping operation required by the manual. If there are moving parts such as moving head fans, sufficient space for movement should be considered in advance.

21) When the household appliances are found to be sparking, smoking or burning smell after being energized, they should be stopped immediately and the power supply should be cut off for inspection.

22) When moving household appliances, be sure to cut off the power supply to prevent electric shock.

23) The surrounding area of the heating appliance must be kept away from flammable materials. Electric stoves, heating stoves, electric irons and other heating appliances shall not be placed directly on the wooden board to avoid disasters.

24) It is forbidden to touch the live switch with wet hands; It is forbidden to pull out or plug in the power plug with wet hands; When unplugging or plugging in the power plug, the fingers should not touch the metal part of the contact; Electrical components or bulbs cannot be replaced with wet hands either.

25) For household appliances (such as hair dryers, soldering irons, etc.) that are often used by hand, do not wrap the wires around your hands.

26) For household appliances that come into contact with the human body, such as electric blankets, electric oil caps, electric foot shoes, etc., they should be tested and checked before use, and only contact the human body after there is no leakage.

27) It is forbidden to move household appliances by dragging wires; It is forbidden to pull the plug by dragging the wire.

28) When using household appliances, plug in the socket on the uncharged side first, and finally close the knife switch or plug in the socket on the live side; Deactivating household appliances is the opposite, first pull the live side knife switch or unplug the live side socket, and then unplug the uncharged side socket (if needed).

29) When the power wire needs to be cut off in an emergency, insulated electrician's pliers or knives with insulated handles must be used.

30) When rescuing the electrocuted person, first disconnect the power supply or pick the power cord with a wooden board or insulating rod, and do not directly drag the electrocuted person by hand. to avoid serial electric shocks.

What are the safety issues in the use of electricity? Star Awareness Project

Summary. Hello dear, glad to answer for you! <>

The relevant regulations for the safe use of electricity are:1Professional electricians are certified to work after passing the examination, and the electrical equipment, line repair and installation work must be carried out by the electrician, and other personnel are prohibited from the above work, 2

In the process of construction electricity, equipment electricity, and domestic electricity, if an abnormal state occurs, the cause should be immediately cut off to check the cause, and it can only be used after being repaired by a professional electrician, and major and complex problems should be reported to the leadership in a timely mannerWear protective equipment correctly, overhaul electrical equipment on site, cut off the power supply first, and hang up the warning sign of "no closing, someone working", no one is allowed to move without the consent of the hanging personnel; When the power switch knife is far away from the maintenance personnel, manual protection should be set up, 4When using electrical equipment, do not touch the electrical switch with wet hands and wet objects, and when the instrument and equipment are not in use or off duty, the power should be turned off <>

Relevant regulations for the safe use of electricity.

Hello dear, glad to answer for you! <>

The relevant regulations for the safe use of electricity are: 1Professional electricians are certified to work after passing the examination, and the repair and installation of electrical equipment and line sources must be carried out by electricians, and other personnel are prohibited from the above work in the town, 2

In the process of construction electricity, equipment electricity, and domestic electricity, if an abnormal state occurs, the cause should be immediately cut off to check the cause, and it can only be used after being repaired by a professional electrician, and major and complex problems should be reported to the leadership in a timely mannerWear protective equipment correctly, overhaul electrical equipment on site, cut off the power supply first, and hang up the warning sign of "no closing, someone working", no one is allowed to move without the consent of the hanging personnel; When the power switch knife is far away from the maintenance personnel, manual protection should be set up, 4When using electrical equipment, do not touch the electrical switch with wet hands and wet objects, and when the instrument and equipment are not in use or off duty, the power should be turned off <>

Kiss, 1No unit or individual shall illegally occupy the land for substation facilities, transmission line corridors and cable passages, 2Power supply enterprises and users shall abide by the relevant provisions of the state, take effective measures, and do a good job in the safe use of electricity, saving electricity and planning electricity use, 3

The state implements the management principles of safe electricity use, saving electricity, and planning blind electricity consumption, 4No unit or individual shall endanger power generation facilities, substation facilities, power line facilities and related auxiliary facilities