Hard drive problem ? O O 5, hard drive problem ? O O

In fact, this is very simple, you can reinstall the system on another disk outside the system disk, and use your newly installed system to enter the computer and remove the system tray of the original operating system with Vientiane.

For example, the original system was installed on the C drive, then you now reinstall the system on the D drive, enter the newly installed system after installation, format the C drive, and then you can use the reinstalled system, or you can install another system on the C drive.

How can DOS ask you to enter your password? Oh,It may be the password of the management system software in the Internet café.,If you don't have it.,Just use the optical drive to boot and reinstall the system.。 Use the system installation disk.

If you want to keep the original system, you can enter safe mode and rename the OP* folder in the C drive.

If the original system doesn't need to be kept, it's simple. Boot up the disc and then, it's up to you.

Of course, the Internet café machine may have a protection card, restore the genie and something like that. You pay attention.

There's another way, you can take the hard drive to me.

You hook this hard drive to another computer and use it as a slave disk, and then format it!

Pay attention to the jumper, to change it to the disc from the plate!

...Direct reinstallation...

Boot the system with the system disk, then delete the C drive directly, and then format it as a new partition.

Is the machine also the previous one??

Didn't you set a password in coms?

No, put it on a hard disk with a system, and plug this piece in as well.

Then I put this hard disk in Windows.

It is recommended to try it with a hammer...

20g of old antiques and a p for use But if the home is compatible with the machine, you can also use it as a super U disk. . .

You change the jumper of the hard drive to see if it works.

1. Determine whether there are physical bad sectors (hardware disk problems).

After booting up, listen to the sound of the hard disk, if it is different from usual, there is a metal impact "dangdang" sound, that means the hard disk itself should be faulty, you can try to format the hard disk at a low level, but the effect will not be obvious, you can also take the hard disk to the computer city to repair the hardware place, repair it, but it costs a few hundred yuan.

2. If there is no abnormal sound.

Then there may be a logical bad sector (soft), so it can be repaired, please find a light boot disk, after entering DOS, first run fdisk or other partition software to find out whether the partition exists, if there is a run format c: format C disk, reinstall the system, if the problem still exists after installing the system for a period of time, then please run the low command under DOS to fully low-level hard disk.

If the partition is gone, then it may be that the partition table is corrupted, you can repair it with Diskman software, or directly repartition, install the operating system, and solve the fault!

The hard disk that prompts the IO error is largely caused by bad sectors and other reasons, it is precisely because of the bad sectors, so after inserting into the computer, it is difficult for the system to read the corresponding information, so the system freezes death, and the system returns to normal after unplugging the hard disk.

In this case, the problem is that if there is no data, the ** low grid program performs a low grid to see if it can be done correctly. If you can, repartition formatting is ready to go.

If there is important data, be sure not to manipulate it indiscriminately, it will destroy the data. Specific testing is required, and then professional means are used to restore the ridge. Don't format bleed, repartition, etc. Don't use software to scan the recovery at will.

Back up important data to a portable hard drive, and then find a dealer to deal with the warranty.

What questions do you have about hi me, click on my name to see my information qq