How do you clean the drain holes inside the refrigerator?

When the water outlet hole of the refrigerator is blocked, it often causes a large amount of water to accumulate in the refrigerator. To solve this problem, first unclog the clogged water outlet hole in the refrigerator. If you don't know, the water outlet hole of the fridge freezer and the drain hole of the fridge are both on the back.

Tools Ingredients: cotton swabs or chopsticks.

1.In the daily use of the refrigerator, when a large amount of water is often found on the bottom plate of the refrigerator fresh-keeping cabinet, it may be that the refrigerator outlet hole is blocked.

2.At this time, you can use a dry rag to absorb the stagnant water in the refrigerator first, so as not to get water everywhere in the next step.

3.Once the stagnant water has dried, you can find the outlet hole in the refrigerator. Generally, the water outlet hole of the refrigerator is in the crisper above the refrigerator. Open the crisper and you can find it at the back of the middle level inside.

4.As shown in the figure below, open the fresh-keeping cabinet of the refrigerator, and then remove the items in the middle of the fresh-keeping cabinet, and find that there is a water outlet hole behind it, and there is also a water guide tank at the location of the water outlet hole.

5.Wipe the inside of the sink first. If the water outlet is blocked, slowly use a cotton swab or chopsticks to get the blockage out, and then wipe the hole clean, so that the problem of the refrigerator water outlet blockage is solved.

6.The water outlet hole of the refrigerator should be checked frequently to avoid excessive clogging. After drilling under the hole, it will be troublesome to dredge; In addition, in order to reduce the situation that too much condensation and too much water in the refrigerator can cause mold and clog the water outlet hole, it is usually necessary to drain and empty the items with a lot of water before putting them in.

1. Unplug the power supply of the refrigerator; 2. Clear out the contents of the refrigerator room, and you will see the drainage hole at the bottom of the refrigerator. 3. Remove the battery cover from the back of the refrigerator. 4. Go back to the front of the refrigerator and poke the drain hole a few times with a plastic pipe.

5. Finally, put the power lid on the back of the refrigerator shut.

1. Be cautious and unplug the power of the refrigerator; 2. Clear out the contents of the refrigerator room, and you will see the drainage hole at the bottom of the refrigerator. 3. Remove the hidden battery cover behind the refrigerator. 4. Go back to the front of the refrigerator and poke the drain hole a few times with a plastic pipe.

5. Finally, put the wide lid of the power supply behind the refrigerator on it.

There is a drainage hole in the refrigerator compartment of your refrigerator (near the sink), you can poke it down with a soft wire about a meter, and after poking it out, pour a glass of water into a water cup to flush it, open a few small screws at the bottom of the refrigerator to see the water pipe, the condensate of the water pipe will flow into the water tray above the compressor, if there is more water, you can clean it, and the compressor will evaporate the water when it is hot.

1. Turn off the power supply of the refrigerator.

2. Clear out the contents of the refrigerator room, and you will see the drainage hole at the bottom of the refrigerator.

3. Remove the battery cover from the back of the refrigerator.

4. After removing it, you will see the drainage groove.

5. Go back to the front of the refrigerator and poke the drain hole a few times with a plastic pipe.

6. Finally, put the power lid on the back of the refrigerator.