How do you clean a refrigerator drain hole? How to clean the drain hole in the refrigerator

When the water outlet hole of the refrigerator is blocked, it often causes a large amount of water to accumulate in the refrigerator. To solve this problem, first unclog the clogged water outlet hole in the refrigerator. If you don't know, the water outlet hole of the fridge freezer and the drain hole of the fridge are both on the back.

Tools Ingredients: cotton swabs or chopsticks.

1.In the daily use of the refrigerator, when a large amount of water is often found on the bottom plate of the refrigerator fresh-keeping cabinet, it may be that the refrigerator outlet hole is blocked.

2.At this time, you can use a dry rag to absorb the stagnant water in the refrigerator first, so as not to get water everywhere in the next step.

3.Once the stagnant water has dried, you can find the outlet hole in the refrigerator. Generally, the water outlet hole of the refrigerator is in the crisper above the refrigerator. Open the crisper and you can find it at the back of the middle level inside.

4.As shown in the figure below, open the fresh-keeping cabinet of the refrigerator, and then remove the items in the middle of the fresh-keeping cabinet, and find that there is a water outlet hole behind it, and there is also a water guide tank at the location of the water outlet hole.

5.Wipe the inside of the sink first. If the water outlet is blocked, slowly use a cotton swab or chopsticks to get the blockage out, and then wipe the hole clean, so that the problem of the refrigerator water outlet blockage is solved.

6.The water outlet hole of the refrigerator should be checked frequently to avoid excessive clogging. After drilling under the hole, it will be troublesome to dredge; In addition, in order to reduce the situation that too much condensation and too much water in the refrigerator can cause mold and clog the water outlet hole, it is usually necessary to drain and empty the items with a lot of water before putting them in.

Refrigerator drain hole**:

Drain location: The drain of the refrigerator is generally on the back of the refrigerator. There is a small hole about one centimeter in diameter in the lower part of the back of the refrigerator, and that small hole is the drain pipe of the refrigerator, which leads to the water tray on the top of the compressor.

1. How to clean the drain hole of the refrigerator.

1. Disconnect the power of the refrigerator, take out the food, and clean the refrigerator; 2. Remove the baffle on the back of the refrigerator and cover the drainage hole with a plastic bag to receive water; 3. Dredge the drainage hole with iron wire, and then pour warm water into the drainage outlet after completion, if the water flow of the drainage outlet is smooth, it means that the cleaning is successful; 4. Remove the plastic bag, install the back panel, and wait for the refrigerator to dry before reusing.

Second, what are the maintenance skills of the refrigerator.

1. Take out the items in the refrigerator regularly, and then clean the refrigerator, because the refrigerator stores more food, so if it is not cleaned regularly, after a period of use, there may be an unpleasant smell, and even a large number of bacteria will breed, thus affecting the quality of food. Of course, if the user chooses a refrigerator with sterilization and deodorization functions, it will not be so troublesome.

2. When placing the refrigerator, it is required that the space should avoid direct sunlight, and there should be a good ventilation environment, and at the same time, heat sources should be avoided as much as possible, including the heat generated during the operation of other household appliances, otherwise it will lead to an increase in the burden of the refrigerator, thereby affecting the power consumption of the refrigerator. In addition, the heat dissipation part of the refrigerator is generally on the back, so when placing the refrigerator, it should be about 10 cm away from the wall.

3. If the user encounters the situation of going out and not using the refrigerator for a long time, he needs to unplug the plug, and then sort out all the things in the refrigerator, and then use a rag to clean the refrigerator inside and out, pay attention to the ventilation to ensure that the inside is dry, and then close the refrigerator. At the same time, the door needs to be sealed with paper.

Answer: How to clean the drain hole in the refrigerator:

1. Disconnect the power supply of the refrigerator first to avoid electric shock.

2. Take out the food in the refrigerator again.

3. Then use iron wire to dredge the drainage hole.

Fourth, finally pour warm water into the drain, if the drain flow is smooth, it means that the cleaning is successful.

Remove the plastic bag, secure the back panel, and wait for the refrigerator to dry before reusing.

<> how to clean the drain hole in the refrigerator: first plug one of the parts of the pump into the drain hole - the air pipe, inflate it all the time, add a little water to the drain hole, and then rinse it several times with the pump so that the drain hole can be cleaned. However, the power should be cut off before cleaning to avoid electric shock.

This answer is applicable to most refrigerator brands such as Haier BCD-581WBPP and Siemens KA62NS22Ti.

1. Unplug the power supply of the refrigerator; 2. Clear out the contents of the refrigerator room, and you will see the drainage hole at the bottom of the refrigerator. 3. Remove the battery cover from the back of the refrigerator. 4. Go back to the front of the refrigerator and poke the drain hole a few times with a plastic pipe.

5. Finally, put the power lid on the back of the refrigerator shut. Expand your knowledge: Causes of water accumulation in the refrigerator refrigerator There are many reasons for water accumulation in the refrigerator refrigerator, and the main reasons are as follows:

1. When the food is stored, the temperature is too high and it is not cooled and put it directly into the refrigerator, and the hot air contains moisture.

Larger, cooling in the refrigerator can cause a lot of condensation.

Water accumulation occurs when condensate is generated faster than it is discharged. 2. The number of door openings is too frequent, causing a large amount of hot air to enter the refrigerator, and the hot air will produce condensate in the condensation, and the generation of condensate will be greater than the speed of discharge, which will cause water accumulation. 3. The leakage hole designed at the back of the refrigerator is to drain the condensate in the refrigerator, if the drainage speed is found to be poor, the leakage hole should be checked to see if it is blocked, and the leakage hole should be dredged with a thin wire in the state of cutting off the power supply.

The drainage hole in the refrigerator compartment is blocked, which will cause excessive water accumulation in the refrigerator room, which will flow into the room along the refrigerator door, causing the refrigerator to leak.

When the water outlet hole in the refrigerator is blocked, then it will cause a large amount of water to be left in the refrigerator, to solve this problem, you need to dredge the water outlet hole that has been blocked in the refrigerator first, if you don't know the water outlet hole in the refrigerator room, the drainage hole of the refrigerator is in the back.

Tools Ingredients: a cotton swab or chopsticks.

1. In the daily use of the refrigerator, when it is found that a large amount of water is often generated on the bottom plate of the refrigerator fresh-keeping cabinet, then it is possible that the water outlet hole of the refrigerator is blocked.

2. At this time, you can use a dry rag to absorb the stagnant water in the refrigerator first, so that it will not get the water everywhere in the next step.

3. After drying the stagnant water, you can find out the water outlet hole of the refrigerator, generally the water outlet hole of the refrigerator is in the fresh-keeping cabinet above the refrigerator, when the fresh-keeping cabinet is opened, you can find it in the back of the middle layer inside.

4. As shown in the figure below, when the fresh-keeping cabinet of the refrigerator is opened, and then the items on the middle layer of the fresh-keeping cabinet are removed, this water outlet hole is found in the rear, and there is a water guide tank at the position of the drainage hole.

5. Wipe the inside of the water guide tank first, if the water outlet hole is blocked, then slowly use cotton swabs or chopsticks to get the blockage out, and then wipe the hole clean, so that the blockage of the water outlet hole of the refrigerator is solved.

6. The water outlet hole of the refrigerator should be checked from time to time to avoid too many blockages, and it will be very troublesome to dredge it after getting under the hole; In addition, in order to reduce the situation that there is too much condensation in the refrigerator and the moisture is too high, which causes mold and clogs the water outlet hole, those items that usually have residual water should be drained and poured before putting them in.