How to Clean the Refrigerator Drain Hole Ways to clean the refrigerator drain hole

When the water outlet hole of the refrigerator is blocked, it often causes a large amount of water to accumulate in the refrigerator. To solve this problem, first unclog the clogged water outlet hole in the refrigerator. If you don't know, the water outlet hole of the fridge freezer and the drain hole of the fridge are both on the back.

Tools Ingredients: cotton swabs or chopsticks.

1.In the daily use of the refrigerator, when a large amount of water is often found on the bottom plate of the refrigerator fresh-keeping cabinet, it may be that the refrigerator outlet hole is blocked.

2.At this time, you can use a dry rag to absorb the stagnant water in the refrigerator first, so as not to get water everywhere in the next step.

3.Once the stagnant water has dried, you can find the outlet hole in the refrigerator. Generally, the water outlet hole of the refrigerator is in the crisper above the refrigerator. Open the crisper and you can find it at the back of the middle level inside.

4.As shown in the figure below, open the fresh-keeping cabinet of the refrigerator, and then remove the items in the middle of the fresh-keeping cabinet, and find that there is a water outlet hole behind it, and there is also a water guide tank at the location of the water outlet hole.

5.Wipe the inside of the sink first. If the water outlet is blocked, slowly use a cotton swab or chopsticks to get the blockage out, and then wipe the hole clean, so that the problem of the refrigerator water outlet blockage is solved.

6.The water outlet hole of the refrigerator should be checked frequently to avoid excessive clogging. After drilling under the hole, it will be troublesome to dredge; In addition, in order to reduce the situation that too much condensation and too much water in the refrigerator can cause mold and clog the water outlet hole, it is usually necessary to drain and empty the items with a lot of water before putting them in.

1. Disconnect the power of the refrigerator, take out the food, and clean the refrigerator.

2. Remove the baffle on the back of the refrigerator and cover the drainage hole with a plastic bag to receive water.

3. Dredge the drainage hole with iron wire, and then pour warm water into the drainage outlet after completion, if the water flow of the drainage outlet is smooth, it means that the cleaning is successful.

4. Remove the plastic bag, install the back panel, and wait for the refrigerator to dry before reusing.

Clean the drain hole of the refrigerator** How to clean the drain hole of the refrigerator.

1. First of all, you must turn off the power of the refrigerator (safety first). 2. Clean up the refrigerator where you store your belongings, so that you can see the drainage hole at the bottom. 3. Use a screwdriver to remove the battery cover from the back of the refrigerator.

4. Pull it down and you'll see the drain. 5. Go back to the front of the refrigerator and poke a stool with a plastic pipe to eliminate the drainage hole. 6. Just install the power lid back behind the refrigerator. 2

Cleaning method of refrigerator drain hole: 1Disconnect the refrigerator, remove the food, and then clean the refrigerator; 2.

Remove the baffle on the back of the refrigerator and cover the drain hole with a plastic bag to receive water; 3.Use wire to unclog the drain hole, and pour warm water into the drain pipe when finished. If the water flow at the drain is smooth, the cleaning is successful; 4.

Remove the plastic bag, pretend to destroy the back panel, and wait for the refrigerator to dry before using it. There are usually two reasons for a clogged drain hole:1

The refrigerator has not been cleaned for a long time, the branch is too dirty, food residues, etc. May clog drain holes. 2.

Opening and closing the refrigerator door frequently can cause a lot of hot air to enter. During the condensation process of hot air, condensate will be generated, and the rate of condensate generation is greater than the speed of discharge, resulting in water accumulation. If the temperature of the refrigerator is still relatively low at this time, it may directly cause "freezing blockage".

The correct way to clean up the rotten drainage holes in the refrigerator is described as follows:

Tools: refrigerator, exhaust pipe, clean water.

1. When cleaning the drainage hole of the Bingchun Hu box, you can buy the air tube of the pump online and insert the air pipe of the pump into the refrigerator for drainage.

2. Repeatedly inflate the drain pipe to make it leak, inject a small amount of water into the drainage hole, and then rinse it several times with a pump.

3. This can be used for several times to thoroughly clean the drain hole of the refrigerator.

4. In addition, some tools are needed to clean up in this process, and the power should be cut off before cleaning the refrigerator.

5. You can't clean the refrigerator with the power on, it is easy to have electric shock, and the drainage hole in the refrigerator is easy to block.

6. Because the temperature of the refrigerator is too low, or the drainage hole is frozen by frost, which hinders the drainage.

1. First prepare a slender and soft tube, syringe, detergent and hot water;

2. Connect one end of the hose to the syringe, insert the other side into the drainage hole, and extract the dirty water in the drainage hole;

3. Put an appropriate amount of detergent in hot water, stir well, use a syringe to absorb the mixed washing water, add it to the drainage hole, and stop until the water overflows;

4. Repeat step 2 above to suck out all the water from the drainage hole;

5. Repeat step 3; Repeat this a few times.

Refrigerator cleaning method:

1. First disconnect the power of the refrigerator (unplug), take out all the food in the refrigerator, and then clean the refrigerator with a towel;

2. Remove the baffle on the back of the refrigerator and cover the drainage hole with a plastic bag to receive water.

3. Dredge the drainage hole with iron wire, and then pour warm water into the drainage outlet after completion, if the water flow of the drainage outlet is smooth, it means that the cleaning is successful.

4. Remove the plastic bag, install the back panel, and wait for the refrigerator to dry before reusing.

Disconnect the refrigerator from power, remove the food, and clean the refrigerator again; Remove the baffle on the back of the refrigerator and cover the drain hole with a plastic bag to receive water; Dredge the drainage hole with wire, and then pour warm water into the drain after completion, if the drain flow is smooth, it means that the cleaning is successful; Remove the plastic bag, secure the back panel, and wait for the refrigerator to dry before reusing.