How to make an ornament out of leaves

The method of using leaves as decorations, take, for example, the river lantern decorated with leaves:

1.Collect leaves, flowers, and plants, remembering that soft, thin leaves and petals will dry faster than thick ones. Place the petals and other materials between two paper towels and place them in a heavy book to dry.

2.Measure and cut four inches of rectangular wax paper. You can make adjustments to the desired size of the cut.

3.Fold the wax paper in half into a square. Open the wax paper and put the petals or leaves inside. Close the wax paper and the petals will be sandwiched between the two layers of wax paper.

4.Place the wax paper on top of the ironing board or cloth, turn the iron to mid and quickly iron the wax paper to seal. In this way, the two layers of wax paper are fused together. Repeat this step until all four square sheets of wax paper cover are sealed.

5.Place the two sheets of wax paper cover and pat them away. Adjust the bezel so that the side you want to put on the outside of the paper lamp faces you. Cut a strip of tape that is one inch longer than the bezel, place the tape between the edges where the two bezel are in contact and flatten it.

6.Turn the bezel over and flatten the extra tape on the reverse side. "Close" the two bezels and press your fingers along the tape to make the crease a little deeper. Continue this step to connect the bezels until the four bezels are connected into a cube.

Make a heart out of leaves, it's a girl's favorite thing.

To make this heart, you just need to paste to compare the pattern of a heart, which is made according to its appearance and structure.

Wang* Xiang.

Manual method with leaves:Preparation tools: paper, scissors, glue sticks, leaves.

1. Prepare paper, scissors, glue sticks, and leaves.

2. Start with the largest leaf as the body of a small fish.

3. Use three smaller leaves and stick them on the right side of the body as tails.

4. Use two smaller leaves to stick to the top and bottom of the body as pectoral and pelvic fins.

5. Finally, use the tip of the scissors to pierce a hole in the position of the head of the fish to indicate the eyes, and the leaf paste is completed.

You can make leaf bookmarks.

Detailed production process:

1. Osmanthus leaves are the best choice. Don't be too old, too young leaves won't work.

2. Prepare an old toothbrush, it must be without curls! Otherwise, the leaf veins will be broken. Prepare a container for brushing leaves, the bottom of the starvation should be flat, and put a little water in the container for later use.

3. Put the osmanthus leaves in the pot to cook (the time will be longer), if possible, buy a pack of alkali in the supermarket, and put it in the pot together when the leaves are cooked, about 1 5. (Note: Alkali may corrode aluminum pans).

4. After boiling for a while, take out a leaf with chopsticks, put it in a container, try to brush it with a toothbrush to see if you can brush off the mesophyll, and cook until the mesophyll can be brushed off.

5. Then take out the leaves, rinse them with water, and carefully brush the mesophyll with a toothbrush, both front and back. Brush one piece and take one piece. If there is a mesophyll that cannot be brushed, cook again.

6. After the leaf is wide and the meat is brushed, rinse it with water, carefully wrap it with newspaper or facial tissue, put it in a thick book, and it will be good in a few days.

The leaves do the manual tutorial as follows:

Material preparation: different shapes of leaves, cardboard, glue, scotch tape.

Operation steps: Step 1: Wash the leaves, wrap them in a paper towel, put them in the middle of the book and put them at the bottom, and take a few more books on top to press them. Make the leaves flatter.

Step 2: Apply some glue to the leaves, be careful, the leaves are easy to break! Then stick it on the cardboard.

Step 3: The cardboard is cut according to the size and shape of the leaves, and you can choose any color of the cardboard you like.

Step 4: You can use a laminator to press a layer of film for the core shed leaf bookmark. If you don't have a laminating machine, you can also use scotch tape instead, like Ms. Xiaoli.