Summer is coming, do you know how to replace the car air conditioning filter

1. The first step is to open the engine compartment cover and confirm the position of the air filter, the air filter is generally located on the left side of the engine compartment, that is, above the left front wheel, you can see a square plastic black box, and the filter element is installed inside; Face. There are 4 clips around the cover of this housing that are used to press the plastic housing above the air cleaner and keep the air intake line sealed. The structure of the buckle is relatively simple, we only need to gently break up the two metal clips upward, and the entire air filter cover can be lifted up, and there will also be individual models using screws to fix the air filter, at this time, you need to choose a suitable screwdriver to unscrew the screws on the air filter box, you can open the plastic shell to see the air filter inside;

2. In the second step, take out the air filter element to check whether there is more dust, you can gently pat the end face of the filter element or use compressed air to clean the dust on the filter element from the inside out, do not use tap water for rinsing. If the air filter is checked to be severely clogged, it is required.

To replace the filter with a new one. Comparing the old and new filters removed, we can see that the filter paper of the old filter has turned black. This is because a lot of dust has accumulated in the paper fibers.

Excessive dust accumulation will inevitably lead to low air flow, resulting in poor engine working conditions and weakened power performance. Therefore, regular replacement of the air filter is helpful for the maintenance of the power performance of the engine;

3. In the third step, after the air filter element is processed, the air filter box needs to be thoroughly cleaned,-- a large amount of dust will accumulate under the air filter, which is the culprit that causes the engine power to decline;

Fourth, when installing a new air filter, we need to pay attention to the right under the air filter. A protruding plastic sheet designed to prevent the installation of an anti-air filter. When installing the air filter, the plastic sheet should be stuck into the card slot of the filter seat to be installed in place;

4. After making sure that the air filter is installed in place, you can cover the shell, and the 4 buckles on the edge are buckled and you're done.

In the blink of an eye, it's hot summer again, Air conditioning is a necessity in this season, especially in the stuffy car, but the filter must be cleaned or replaced during the use of the air conditioner, so today I will show you how to change the car air conditioning filter.

In different models, the position of the air conditioning filter element is also different, the air conditioning filter element of some models is under the front windshield, covered by the diversion water tank, when replacing the filter element, first open the engine cover and then remove the clamp that fixes the flow tank, remove the flow tank, you can see the air conditioning filter; The air conditioning filter element of most models is located in the glove box in front of the passenger seat, and the glove box needs to be removed when replacing it, and you can see the air conditioning filter inside, which is generally in the lower left part.

Open the glove box to the maximum position, you can see the fixed buckle, remove it, squeeze both sides of the glove box to the middle with both hands, and the glove box can be disassembled;

Open the air conditioner air filter cover and pull out the air conditioner air filter core;

Replace the core of the air conditioner with a new one, and if the air conditioner filter is not very dirty, it can be used after cleaning, except for activated carbon.

Install the parts in reverse order of disassembly, replace the cover, install the glove box, and then snap the snap to complete the replacement.

The above is the content of how to replace the air conditioner filter introduced to you today, I hope it will be helpful to friends in need.

When the car is driven with the air conditioner, it has to inhale outside air into the cabin, but the air contains many different particles, such as dust, pollen, soot, abrasive particles, ozone, odor, nitrogen oxides, sulfur dioxide, carbon dioxide, benzene, etc.

The time to replace the air cleaner mainly depends on the external environment. In Germany, an Audi A8 can run 150,000 kilometers before changing it once. In general, in China, the maintenance cycle of the air filter element of the vehicle is about 10,000 kilometers or about half a year, and in the case of serious haze, it is best to replace the car once every 3 months.

During the operation of the engine, impurities such as dust and metal grinding debris will constantly mix into the cylinder. In hazy weather, there are more moisture and pollution particles in the air, which are easy to gather and solidify after inhalation, which will cause poor air exchange in the engine and increase fuel consumption for a long time. In addition, when the haze enters the air conditioning system, moisture and dust will remain on the filter element, which is easy to breed bacteria.

After starting the air conditioner, it will not only affect the air intake, but also cause the fan and duct to be polluted, causing a series of problems.

The air conditioning filter is actually equivalent to the "mask" of the car, its role is to filter out the abrasive debris and impurities in the air to ensure that the engine can run normally. At the same time, it prevents the growth of bacteria in the air intake, which can lead to odor in the car and even affect the health of the drivers and passengers in the car.

It is best to replace the air conditioning filter element once every six months. Replacement Steps:

1. Japanese cars usually install the air conditioning filter element at the back of the co-pilot's glove box, and the first step to replace the air conditioning filter is to open the glove box cover.

2. Find the fixing buckle on the right side of the glove box and pull it out hard.

3. Remove the fixed buckle of the glove box cover and make it detached.

4. Squeeze both sides of the glove box to the middle with both hands, and the glove box can be taken down.

5. Take off the glove box to see the cover plate of the air conditioner filter, press the fixed buckles on both sides of the cover plate hard, and the cover plate can be removed.

6. Pull out the old air conditioner filter to the outside.

7. Load the new air conditioner filter and restore it to its original position in reverse according to the disassembly and assembly order (pay attention to the installation direction of the air conditioner filter).

How to dismantle the air conditioner filter.

1. Before disassembling the air conditioning filter, you should carefully open the air conditioning shell, the air conditioning shell is generally stuck by two small card slots, and slowly open the outer cover outward.

2. After opening the outer cover of the air conditioner, there are generally two buckles inside, and it is necessary to slowly open the outer cover completely, and the next thing is to take the filter, and it is relatively simple to take the filter, but it is stuck by a few card slots, first push the filter up, and after the lower end is out of the card slot, then slowly drag the filter down and take it out.

3. After removing the filter, some of the black particles filtered by Jiayan Jingqiang are some empty and blind, which need to be taken off separately for cleaning and drying, and do not put them in the sun when drying.

4. Compared with disassembly, it is more troublesome to install the filter screen, and the filter screen should be plugged into it along the card slot during installation.

1. The air conditioning filter is generally located behind the storage compartment in the passenger position, and when the air conditioning filter is replaced, the storage compartment needs to be removed before it can be replaced.

2. The storage compartment is generally snapped into the live buckle, usually at the bottom. Hold the left and right sides of the storage compartment with both hands and lift it firmly to remove it.

3. After the storage compartment is removed, you will see the air conditioner blower, and the position of the air conditioner filter element is on top of it. Find a lid that is placed horizontally, the left and right sides of the lid can be moved, and the lid can be opened by gently moving it outside.

4. After the lid is opened, you can see the air conditioner filter inside, just take it out!

5. After inserting the new air conditioner filter into it, just put the lid that you just removed and cover it.

6. Fix the removed storage compartment against the buckle position. The replacement of the empty filter element of the car is boring and boring.

I'm glad to answer for you. How to replace the air conditioning filter: 1. The air conditioning filter of most cars is behind the glove box of the co-pilot, and we need to remove the glove box before changing.

Different car disassembly methods are a little different, like this only need to be put down by pressing on both sides of the glove box, and some are slightly more complicated to remove the buckle, the overall method is almost the same, and it is not difficult to check the town, and the owner's manual must be written. When the glove box is removed, you can see the box with the air conditioning filter, which is the long black box; 2. Gently pull it out, this box is buckled, pay attention to it, don't deadlift it and break it, you can see the air conditioner filter when you pull it out. Remember to wipe the box clean before removing the old filter and replacing it with a new one, and then you can install the new air conditioner filter; 3. It should be noted here that the filter element has a direction, and there will be an arrow on it that is not blind, and it must be consistent with the direction on the box.

Put it back the way you are, cover the glove box, and you<>'re good to go

The steps to replace the trapped core of the automobile air conditioning filter are as follows:Operating environment: BMW X3, pliers, new filter element, etc.

1. Most of the installation positions of the car air conditioning filter are behind the glove box in the passenger cab, so first of all, open the cover plate of the glove box in the passenger seat, clamp the buckle with pliers, and remove the hook by gently pushing it out with your hand.

2. Unscrew the buckles on the left and right sides of the glove box counterclockwise, put down the glove box, and then the air conditioner filter cover can be seen.

3. Pick open the cover plate of the air conditioner filter and pull out the air conditioner lattice.

4. Take out the old air conditioner filter and replace it with a new one.

5. Push the air conditioner lattice back into the slot, buckle the cover, and buckle the glove box hook into the slot.

6. Tighten the buckles on the left and right sides of the glove box clockwise, and buckle the glove box to complete the noise.

The effect of the car air conditioning filter is to digest and absorb all kinds of dust and harmful substances in the outside air, so as to bring a faster driving natural environment to the employees in the car. If it is replaced frequently, it is very easy to block and grow germs, and then use the pipeline into the car, which is harmful to the body. Speaking of replacement, do you know where the car cabin air filter is?

How to change the car air conditioning filter?

Where is the car cabin filter?

Different car air conditioning filter parts are different, some car air conditioning filter under the windshield, is covered by the drainage stainless steel sink, when replacing this kind of filter, you need to tear the hood open, remove the buckle that fixes the water flow channel, remove the dirty stainless steel sink, you can see the air conditioning filter; The air conditioning filter element of most car series is located in the glove box in front of the front seat, and the glove box must be disassembled and assembled when replaced, and you can see the air conditioning filter inside, which is generally on the lower left side.

How to change the air conditioning filter element of the car (the air conditioning filter element in the glove box).

1. Open the glove box to the highest part, you can see the fixed lock, take it out, and squeeze both sides of the glove box to the middle with both hands, and the glove box can be disassembled and assembled;

2. Open the rear cover of the air conditioner air cleaner and pull out the activated carbon fiber of the air conditioner air filter;

3. Replace the activated carbon fiber of the new air conditioning air filter, if the air conditioning filter is not very dirty, it can be completely removed and re-applied, except for the activated carbon.

4. Install the components in the relative order of decomposition, then install the rear cover, install the glove box, and replace it with the lock.