Is it OK for a glass cleaner to wipe three layers of glass?

He has three layers of glass, that is to say, his magnetic force is relatively strong, if it is three layers of glass can penetrate the magnetic force, it is enough magnetic, if you wipe two layers of glass, it is definitely possible. However, because of the strong magnetic force, you must be careful not to touch directly head-on, but slowly touch one piece from an oblique position, otherwise you may smash the glass.

If you can adjust the size, you can...

Nowadays, glass is more and more favored by consumers, not only frosted glass, hot melt glass, stained glass and other decorative art glass, but also a variety of functional glass, such as sound insulation and noise reduction laminated glass, insulating glass and thermal insulation and flame retardant fireproof glass. This article will introduce how to use a glass cleaner to help you understand the key points of using a double-sided glass cleaner.

1. How to use the glass cleaner.

How to use the glass cleaner;

1. Break open the double-sided glass window cleaner by hand.

2. When you start using it, remember to tie the safety rope on the outside and put the safety rope on your wrist.

3. Soak the product and apply the cleaning liquid to the cleaning surface, or you can use dish soap to add water to the bucket.

4. Put a piece of cord outside the window (the rope should be long enough so that it can be cleaned to every corner of the product), and a piece with a handle in the window.

5. Move the safety column switch on the product (one on the left and right sides of the product), which can be tightly sucked to the glass, close the window, and can be used.

Rotate the button on the cloth to easily change the cloth.

7. According to the product arrow (product "arrow" appearance) pointing from top to bottom, scrub according to the "C" route, that is, the low middle of both sides arches upward, and the product arrow points to always be in front of the scrubbing, scraping back and forth.

Second, the use of double-sided glass cleaners.

1.Do not use glass cleaning equipment if the glass has been broken.

2.If there are stains on the glass, remove them with a marble blade.

3.Before using the glass cleaning equipment, please make sure that there are no other impurities in the item, and if so, please remove them first.

4.Glass cleaning equipment is not capable of cleaning frosted, coated and polished glass.

5.It is recommended to keep the glass cleaning device in a dark place after use, as this can effectively extend the life of the product.

6.Because there are magnets inside the glass cleaning equipment, keep it away from TVs, computers, refrigerators, etc.

7.Scouring pads can be used instead of wiping cloths inside the glass cleaning equipment.

Yes, but you need to choose the right specifications. The thickness of the double-layer window is generally 15 22mm, when you choose a double-sided glass eraser, you must be optimistic about the specifications, and the product will be marked. There may also be text on the product:

Double-layer hollow window special, strong magnetic, etc. If it is the first time to use, it is recommended to choose a slightly larger suction power. For example, select:

15 24mm, do not choose the upper limit is 20mm. In order to avoid unskilled use, the suction power is not large enough, causing the outer piece to fall off.

Summary. Holding one piece without a handle in one hand and the handle in the other, rotate the two pieces of glass firmly so that it rotates 90 degrees. Then break it again, and it can be easily broken.

Insert the tip of your finger between the two pieces as far as possible from the end of the product wipe, and then break it firmly. People with a little more strength can break it open, because the wiping end is far away from the magnet, and the suction is the smallest.

Hold the piece without the handle vertically on the edge of the table and hold it with your hand, then hold the handle with the other hand and push it down hard. Stagger the two pieces with great force.

The three layers of glass are rubbed together and opened.

3. Hold a piece without a handle in one hand, hold the handle of the bracelet with the other hand, and rotate the two pieces of glass to rotate 90 degrees. Then break it again, and it can be easily broken. 2 3 Insert the tip of your finger from the end of the product cloth between the two pieces as much as possible, and then break it vigorously.

People with a little more strength can break it open, because the wiping end is far away from the magnet, and the suction is the smallest. 3 3. Hold the piece without a handle vertically on the edge of the table and hold it with your hand, then hold the handle with the other hand and push it down with force. Stagger the two pieces with great force.

I wish you a happy life.

If the inside of the double glazing is dirty, you need to remove one side and clean it again, or use a double glazing wipe.

Use a flathead screwdriver to remove the glass window, use a wallpaper knife to disassemble the top glass, and then remove the adhesive strip from the lower glass, and then clean the stains inside. Wipe the front and back sides of the glass, glue the glass around with double-sided tape, pay attention not to leave traces, and finally install it back, so that the stain is cleaned up.

If you can't wipe it off with your hands or a rag, you can use a machine to separate the double glass cleaning machine, and then put the thin part of the double glass cleaning machine into the double glass, and the detergent on the other side will be absorbed through the glass. Hold the outside of the cleaning machine, and the cleaning machine inside will also move because of the adsorption effect, so that you can clean the dirt in the middle of the double glazing.

Precautions for cleaning double glazing:

If there is no platform on the outside of the window, you need to clean it with a glass scraper, but it is not safe to clean the glass on the outside, it is best to straddle the window and use a long glass scraper to clean it. Hanging from above, most buildings or companies will contact professional glass cleaning personnel to operate, and they will hang from the roof to the outer layer of glass for construction.

Two people are responsible for one side, sometimes there are stains on both sides of the glass, you can work with two people to clean up, we start the control treatment above, so that there is no need to spend time converting. Using a glass scraper, add water to the glass cleaner and spray it onto the glass, and then use the scraper to clean the stain back and forth.

The three-layer glass and the middle glass are all synthesized after cleaning, and there is no dust. When cleaning, only clean the inside and outside. However, it is necessary to choose a glass eraser with suction power suitable for the thickness of three layers of glass

You can wipe it inside and out, but you can't wipe it in the middle layer.

You can refer to the use of the glass cleaner of the current better brand "Yilaijie" brand of glass cleaner:

Open the product. Strap the safety rope around your wrist.

After soaking the product in water, apply a detergent.

Open the window, place the one with the sound outside the window, and the one with the handle inside the window, engage on both sides, and close the window.

Begin to wipe the glass, arcing.

When you are done using it, place the magnetic barrier block and close the glass cleaner.

1.Rotate the two suction pieces of the glass in different directions to separate them;2.Soak the double-sided glass cleaner sponge thoroughly and pour dish soap onto the sponge3.

Put the safety rope pull ring on your hand, put the side with the safety rope outside the window, and the side of the handle inside the window, and then slowly move the two glass cleaners together4.After the glass is wiped clean, remove the glass insert.

Questions. According to the method you introduced, the key is that the adsorption force is too low, the glass is wiped off, and I have adjusted to the number 5, which is double glazing.

That's because the magnetism of your suction piece is too weak.

You can change it to a more magnetic one.

Questions. Can I change it, I've bought it for a few days, and I only opened it today to clean the glass for the eleventh holiday.

Negotiate with the seller to settle the matter.

Questions. Okay, thank you. You are welcome.

How to use the cloth?3-8mm.

This is a problem that I am afraid no one can solve, because the gap is very small, the vacuuming does not work (I tried, but some colleagues said that the Scotch scouring pad is cut with a knife on many vertical grooves, and it can be embedded when used to wipe the groove, and it is easy to wipe it), the novice upstairs is kind, but don't wipe the glass, because the seal is not good after dismantling it, and it is more likely to enter the soil in the future, and it will have to be removed in the future.

When I encountered this problem and couldn't solve it, I found a supplier, and since it had been used for several years, they only agreed to give me a new one at a 7% discount.

It's not easy to seal, If you can still find the original supplier, try to get them to change it for you. There is no other solution.

If any of the masters have a way, teach us, we are grateful.

Just wipe it clean inside!! When it rains, it's like washing glass.

If it is insulating glass, wipe it with double-sided glass, and there is a strong sale

The method of using double-layer glass cleaner is very simple, have you learned it?