How to solve the warping of furniture film? What are the reasons for furniture film warping?

First, use a syringe to suck a little bit of glue in. If the viscosity of the glue is too high at this time, it is not good to suck into the syringe, you can pour it from the tail of the syringe, and then put it into the pusher. Then, you can clean up the flying wallpaper a little.

If it is PVC, especially the deep embossed wallpaper, you can mix the glue with a little thicker general squeeze glue into it, without all the walls being full, get about two-thirds of it, and then use a small scraper to carefully squeeze out the excess glue, you can add a little bit of strength to make the flying wallpaper re-paste, basically this way, the wallpaper can no longer fly, Finally, use a damp sponge to wipe off the excess glue. In addition, the repair methods mentioned above are for the wallpaper of more common materials, if it is gravel or flocking and other wallpaper, because of the particularity of the wallpaper, it is best not to stain the surface with glue, and it is also best not to use a scraper to scrape, to use a special brush to deal with, so if this kind of wallpaper is flashed, it is best to contact professionals to deal with it, and the specific problems are analyzed.

If you have a warped edge of the furniture film, you can try the following methods:

1.Clean up the glue in the original veneer with an abrasive cloth or a small iron file, and then use all-purpose glue (which is glued to the fireproof board) or milky white glue and wood glue powder (but the effect is slower) to paint, pay attention to not too much, cool and dry for about 1 minute after brushing, and then glue, gently knock or press with a heavy object, keep it for a certain time, and it is done. **There is woodworking adhesive glue, such as Sengo woodworking adhesive can also be used.

2.First take down the wardrobe door and put it flat, pour the milky white glue into the open part, and then press it with something, or use a clip card, wipe the glue out of the outside clean, and take it off after 24 hours.

3.Don't use 502, it will be hard and deformed!

1.Clean up the glue in the original veneer with an abrasive cloth or a small iron file, and then use all-purpose glue (preferably sticky fireproof board) or the milky white glue and wood glue powder mentioned on the hug (but the effect is slower) to brush it with attention not to be too much, cool and dry for about 1 minute after brushing, and then glue, gently knock or press with a heavy object, keep it for a certain time, and it's done. **There is woodworking adhesive glue, such as Sengo woodworking adhesive can also be used.

2.First take down the wardrobe door and lay it flat, pour the milky white glue into the open part, and then press it with something, the focus. Or you can use a clip card, wipe the glue pressed out from the outside, and take it off after 24 hours.

There are generally the following reasons for the warping of furniture film:

1. There is a problem with the adhesive, which leads to the fact that the film cannot be well integrated with the furniture during the bonding process, resulting in warping;

2. There is a problem with the allocation of space, and it cannot be pasted tightly on one side to the other;

3. There is air or dust between the film and the furniture, which will loosen the film.