Qianjiang 125 6K motorcycle, what to do if there is a knocking sound on the throttle at medium and h

1. Detonation, commonly known as knocking cylinder and calling rod. Detonation is an abnormal combustion phenomenon that occurs during the combustion of an engine. To put it simply, "knocking" is a phenomenon of abnormal combustion of the engine.

Detonation is an abnormal pressure in the combustion chamber caused by abnormal combustion. When the engine knocks, it makes a knocking sound. The slight discontinuous knocking sound is quite crisp, somewhat similar to the sound of tapping a triangle.

In the event of severe and continuous detonation, the engine will have a "mile-mile" sound, and the engine will also be obviously weak at this time.

1. There is an irregular metal knocking sound of "clang", "click" and "dangdang" in the engine.

2. Engine tremor.

3. The engine temperature is too high.

4. The fuel combustion is incomplete, and there is black smoke in the exhaust gas.

5. The engine power decreases.

6. Increased fuel consumption.

7. During normal driving, the speed suddenly changes inexplicably.

Second, the main reasons.

1. The ignition angle is too advanced: in order to make the piston get power immediately after entering the power stroke after the end of compression top dead center, it is usually ignited in advance before the piston reaches the top dead center (because it takes a while from ignition to complete combustion). Ignition too early will cause most of the oil and gas to burn when the piston is still compressing the stroke, and the unburned oil and gas will be subjected to great pressure and spontaneous combustion, resulting in detonation.

2. Excessive carbon deposition in the engine

Excessive carbon deposition in the combustion chamber of the engine will not only increase the compression ratio (high pressure), but also produce high temperature hot spots on the surface of the carbon deposit, causing the engine to knock.

3. The engine temperature is too high.

If the engine is too hot, the inlet temperature is too high, or the engine cooling water is poorly circulated, which will cause the engine to detonate due to high temperature.

4. The air-fuel ratio is incorrect

Too thin the fuel-air mixing ratio will increase the combustion temperature, and the increase in combustion temperature will cause the engine temperature to rise, of course, it is easy to knock.

5. The octane number of fuel is too low

The octane number is an indicator of the knock resistance of the fuel, and the higher the octane number, the stronger the knock resistance. Engines with high compression ratios have higher pressure in the combustion chamber, and are prone to knocking if fuel with low knock resistance is used.

3. Inspection and maintenance.

1. Detect the change of engine combustion chamber pressure; Detect the vibration frequency of the engine block; Detection of combustion noise of gas mixtures.

2. The measurement accuracy of directly detecting the pressure change of the combustion chamber to detect the vibration of the engine is high, but the sensor is difficult to install, and the durability is poor, so it is generally used for measuring instruments, and the pressure detection sensors in practical applications are indirect detection type.

3. The fastest and most effective way to suppress detonation is to delay the ignition advance angle and reduce the combustion pressure. Therefore, the working principle of the knock sensor is that when the engine knocking is detected, the ignition advance angle will be delayed to the ignition time when the detonation will not be detonated, and then the ignition will be slowly restored in advance when the engine does not detonation.

No return is a clutch sound! It should be that the spark plug pauses and does not ignite, and it feels suddenly powerless, and it ignites again in an instant! It's the problem of the spark plug, and the replacement of the spark plug solves the problem. Hope it helps.

There is no such thing as a clutch sound, but what is the sound ,......Hey,

What is the clutch sound?

1. The engine temperature is too low. Some diesel fuel turns into oil vapor when it is not burned, and is discharged from the exhaust pipe with the exhaust gas, emitting white smoke.

2. There is water in the oil supply system. There is water in the fuel or combustion chamber, and the water is heated into water vapor by the heat released by combustion in the cylinder, which is discharged from the exhaust pipe to form white smoke.

Knocking on the cylinder generally checks the fuel quality. Ignition time. Mechanical wear and tear. oil pumps, etc.

Of course, Haojue. Aside from the **, the quality and workmanship of Haojue are incomparable to Qianjiang, the fuel consumption of Qianjiang motorcycles with the same displacement is basically times that of Haojue, and the vibration is large, and the anti-aging ability of the appearance parts is too weak. Decisive Hero. If you have any other questions, you can follow me up.

The quality of these two cars is about the same, and they are relatively stable, but the sales volume of Haojue 125-8 is much greater than that of Qianjiang Golden Prince.

It's all pretty much the same. But Haojue's reputation is better.

The top rod machine is generally used by domestic motorcycles of poor quality, and Qianjiang is generally used by the chain machine, if you are not sure, you can send a ** to I'll just look at it.

Just look for a bicycle repairer, someone will help you adjust it in 30 seconds, and it's like this for new cars! Ask for good reviews.

The valve may not be adjusted when the machine leaves the factory, and the valve is hot and cold expanding! Find a motorcycle hospital to see.

Check the oil level of the oil strainer and change the oil a little better.

It is caused by too much valve clearance, especially for ejector rod machines.