What to do if the floor is not particularly flat when laying wooden floors

What to do when the floor is not particularly flat when laying wooden floors:

1. The ground is high. Use a 2-meter level to put it on the ground, and then the level will appear seesaw, that is, the contact with the level is high, and the high place needs to be polished here or the outer ring of the plaster can be smoothed here.

2. The ground is low. Use a 2-meter level to place it at the place to be measured, and then there will be a gap between the level and the ground, and then use plaster and cement to level it.

3. The ground turns sand, which is mostly caused by the uneven ratio of cement and sand on the ground during construction. Although there will be no problems with the floor in the short term after the floor is paved, it is easy to have a sound after 1 or 2 years, and the important thing is that the sand particles are easy to cut the moisture-proof film, and the floor is also easy to be deformed by moisture.

4. There is a pipe ditch on the ground: if the flatness is OK, simply use gypsum or cement to fill it, remember that the height of the pipe should not be higher than the ground, if there is a high situation, it needs to be disposed of.

The impact of uneven wooden flooring on the ground: empty sound, broken locks, dust in the corners of the wall, and ground leveling needs to be considered first.

The wooden floor adopts direct paste paving, this laying method is to paste the floor directly on the floor, so when laying, the ground needs to be kept dry and flat throughout, when laying, it is best to lay with too long wooden boards, otherwise it is easy to warp, it is best to choose those solid wood or cork floors with a length of less than 30cm for laying;

Small pieces of teak or parquet flooring can be laid directly. Applicable types: parquet, cork flooring and laminate flooring. Advantages and disadvantages: simple and convenient installation, exquisite appearance, but high requirements for construction, easy to warp.

The ground is uneven, the potholes are too big to pave the floor, the best treatment can be done in this way

1. Treat with gypsum, gypsum is a good material for post-treatment of uneven ground, and it is also the easiest. Gypsum treatment of uneven ground is to add white powder inside, responsible for the unevenness of the bay when it is fast drying.

Second, plain cement treatment, mixed with cement and water directly sprinkled on the ground, must be slightly thinner, so that it can flow. In this way, the cement will automatically flow to the potholes, which will play a role in filling and leveling.

The ground is uneven after laying the floor:

One is that people will feel sag when they walk on it, which is very uncomfortable.

Second, it will reduce the service life and years of the floor.

The third is that the floor will be deformed for a long time.