The skin of the roof wall at the door of the bathroom has fallen off, is it because there is too muc

to commit "the first to bear the brunt."Leakage! Because once the wall leaks, it will separate the putty powder decorative layer on the wall from the wall, and finally it will be unable to withstand the attack of leakage, and it has no choice but to "part ways" with the wall! Therefore, in this case, we must first rule out the possibility that there is a rainwater pipe in the load-bearing column, if there is, then block the rainwater pipe and reinstall it on the exterior wall, if not, then find other reasons.

Is there any damage to the floor heating pipe during the decoration process: After the installation of the floor coil unit of the floor heating is completed, do the workers who carry out the decoration work pay attention to the protection or smash the floor heating pipe during the work process, or the floor heating pipe installed by the floor heating company itself is damaged?

<> thereforeOn the one hand, the quality and safety accident of "external wall falling off" has the result of difficult accident loss and damage, and on the other hand, there are many responsible persons and the problem of complex responsibility traceability. In your case, the latex paint is peeled off due to moisture on the wall. It is recommended to remove the latex paint in this area, brush the waterproof first, and then repaint the latex paint.

The root cause of the wall peeling off is water, and the humid environment gives the mold the conditions to multiply, which also affects the firmness of the putty, so the wall skin falls off, and it must be carefully checked.

There are many reasons why the wall skin can fall off, and it is most likely caused by the wall being too wet. The treatment method is to shovel off the wall skin first, then scrape the putty powder twice, apply the primer twice and both sides of the topcoat. The first reason is that the proportion of mortar is not well adjusted when the original wall is painted, and there are mainly large sand, fine sand, and cement.

Some put too little cement to save money, or the cement bought is not up to standard. Contact the manufacturer to check first, if you are in a hurry, you can find a plumber to come and play, play enough 8 pressures, if you can keep an hour without falling pressure, you can eliminate the problem of floor heating, if the pressure is reduced, you must continue to contact the manufacturer to check and repair.

It's because there's too much water vapor. The bathroom is inherently heavy on moisture, which can easily cause the wall to fall off. Household hygiene can be solved by installing an exhaust fan or dehumidifier inside.

Yes, this is because the toilets are generally longer, and there is more water vapor, plus the exhaust effect is also poor.

The skin of the roof wall at the door of the bathroom has fallen off, and it is not ruled out that it is caused by too much water vapor, and the exhaust may not be done, so you must pay attention to ventilation, otherwise it will be more serious in the future.

Probably, because the bathroom is more humid, it will cause this phenomenon to occur, and when decorating, try to choose tiles in the bathroom.

It shouldn't be, maybe it's because the quality of the bathroom door is not very good, and it's relatively humid, so this happens.

Yes, because the water vapor produces moisture, so that the moisture can get rid of the wall skin, and it falls very badly, which will affect the overall beauty.

Not necessarily. It is also possible that the quality is not up to standard, so this phenomenon will occur.

Yes, because the bathroom is a place with a lot of water vapor, and it is also more humid, so the wall skin will fall off.