Flute mouth shape and related questions, what is the mouth shape of the flute

1. Yes, slightly cover the side of the blow hole against the lip.

2, I personally generally 45 or a little more, in fact, as long as it suits you best, the wind column is just split by the split corner of the hole, you have to find your own position.

3. The airflow you blow out is unstable, you need to practice more, and at the same time, the mouth shape should also be corrected, if there is a problem with the mouth shape, the wind column is not accurate, take your time.

4. Yes at the beginning, you have to practice diligently, and your fingers will be flexible.

5. Vertical, but the flute film should be cooked from raw, the easiest way is to gently knead the flute membrane into a small ball with your fingers, and then stick the natural texture of the kneaded flute film and the flute vertically, pay attention not to be tight and not loose.

The flute is not something that can be played overnight, and it is still fun to practice diligently.

1.It's a must.

The higher the more vertical.

3.You didn't find the sweet spot.

4.Take it easy.

5.Vertical.

In fact, you can look up these on the Internet or buy some flute sheet music, which also teaches you how to play.

1.Yes degree 3Uniform gas use 4Rourou 4Vertical.

I am a flute practitioner, and I am taking the tenth grade exam this year, I hope it can help you.

1. It is not directly resting on the flute, but the piece under the lip resting on the inside of the blowing hole.

2. This is according to everyone's habits, there is no fix, I like 40 ° to 45 ° (about 40 55).

3. Inhale through your nose, sink to the dantian, and then slowly spit it out.

4. When it's okay, use the inflexible finger of the other hand, slowly, it will be much better.

5. This is not much of a concern, if you just start practicing, you don't pay attention to it, if you have a high pitch, it is better to tighten the flute membrane, and the bass is still loose!

1|4, 90 degree angle, with dantian breath.

The mouth shape of the flute is to first relax and open the neck, larynx and mouth, as you normally do when yawning, and then align the upper and lower lips so that the space between the upper and lower lips is located on the lips**, and the cheeks and the corners of the mouth are closed in the middle of the oval shape. Slightly forward on the upper lip, gently resting on the middle of the lower lip, about a quarter of the way to the bottom lip.

Everyone should pay attention to the correct mouth shape and use the correct angle for playing the flute. Generally, the lips and the blown hole are at a ninety degree right angle. When blowing, you can adjust the pitch by adjusting the angle between the lips and the blowing hole, such as the angle is less than 90 degrees, the pitch is lower, and the pitch is slightly greater than 90 degrees.

It is also necessary to try to minimize the air leakage sound after the blowing hole is opened, so that the air entering the blowing hole is unimpeded and the flute is filled. Thus finding the best method and tone.

To make a beautiful flute sound, you need to breathe correctly and mouth shape. In order to play the high, low, strong, and weak tones of the flute, it is necessary to coordinate the breathing and the changes in the shape of the mouth.

The first thing that comes into contact with each sound hole of the flute is the coordination between the slow and rapid blowing of each sound hole of the flute, the breath and the shape of the mouth. When playing the lowest seven tones of the flute, the speed is relatively slow and steady from the full press of the cylinder tone up to the sixth hole.

When blowing an octave higher than the seven fundamental notes, the method of rapid blowing is used, and the exhaled air flow is rapid and powerful. When blowing a note more than two octaves higher than the keynote, the contraction of the respiratory muscles is strengthened on top of the rapid blowing.

(Good-looking) mouth flute.

(Expensive) mouth flutes.

(Beautiful) mouth flute.

(Delicate) mouth flute.

(Small) mouth flute.

Mouth flute.

(Loud) mouth flute.

(Fun) mouth flute.

Mouth flutes (of various shapes).

(Colorful) mouth flute.

1. To form a good mouth shape, first of all, the neck, throat and oral cavity should be naturally relaxed, the lips should be naturally attached to the teeth, and the upper lip should be slightly forward. Then, the mouth is pouted and the "hū" sound (the vocal cords do not vibrate) to promote the natural relaxation and opening of the laryngeal cavity and mouth (including gas), and the cheeks, corners of the mouth, and upper and lower lip muscles naturally converge to the middle, directly prompting the formation of an oval "damper" (feeling circular) in the middle of the upper and lower lips.

2. Then, gently lean against the blowing hole in the middle of the lower lip, cover about 1 4 places of the blowing hole, and exhale the breath through the "damper" to inject the mouth wind downward into the blowing hole, acting on the pronunciation of the flute.

3. After clarifying the basic formation of the mouth shape, we should also pay attention to the angle of the mouth shape and the blowing hole, so that the lips and the blowing hole form a 90-degree right angle, the breath is unimpeded, fill the flute, minimize the air leakage, and strive to make the flute sound pure and mellow. In mouth formation exercises, it is necessary to always pay attention to maintaining the natural relaxation of the larynx, mouth, and tongue, and use the state of pronouncing the "hū" sound to guide and maintain the mouth shape.

The lips are naturally relaxed, and the lower lip does not cover the mouthpiece. Then do a whimper. But don't curl your lips, and don't bulge your cheeks when you blow.

When the mouth is whimpering, grin slightly on both sides at the same time, and try to make the mouth as round as possible. The flute is slightly slanted outward. Also, don't bulge your upper lip over your lower lip.

The breath that blows out is felt with your hands, and it is like a column of air.

The lips are relaxed, closed naturally, leaving a certain gap, the gap for beginners can be larger, depending on the situation, the flute is parallel to the lips, the angle of air intake is about 60 degrees, and it can be adjusted according to the specific situation, until the air leakage noise is minimal or almost disappears, this process takes a long time.

Beginners do not stick the flute film, generally do not use the flute film if they are not performing on stage, usually practice sticking adhesive paper or label paper, but also do not paste tape paper.

Generally learning bamboo flute is basically children, I now use a "children's flute tutorial" feels good, and when lz blows to a certain extent, you can buy a copy of "Chinese flute examination score" for the examination, the Chinese flute examination once a year, but you can jump.

You can try it and choose the best-sounding lip shape.

Whistling is similar in shape.

The correct blowing method should be to flatten the flute hole, and the air flow feels like a 90-degree angle to blow into the hole, so that the sound can be fully rubbed to make the sound crisp, loud, clean and round.

When playing the flute, look at eye level, looking too high or low can also change the angle of the airflow.

When the upper and lower lips are pressed together, the lower lip will overflow outward, just covering the hole 1 2, (the lower lip should not exceed the 1 2 of the blow hole).

When blowing, the vent in the middle of the lip should be olive-shaped, and the size should be about 5-6 mm in length, and should not exceed the length of the blowing hole. When playing bass, it can be slightly louder.

Since the bass requires more airflow, both sides of the vents should be controlled. When playing a high note, the mouth should not overflow, keep the breath concentrated, and have the feeling of converging on one point.

The upper lip should be a little higher than the lower lip when blowing, but not too much in front and behind the upper lip, which will directly change the direction and angle of the airflow.

Pay special attention to the air outlet part of the upper and lower lips, do not press tightly, and let the air flow out without hindrance.

At this time, the entire lip muscle is in a squeezed state, and it should be slightly raised forward, so that the airflow is very concentrated into the flute hole.

Dizi: It is an ancient Chinese musical instrument, and it is also the most representative and national wind instrument among Chinese musical instruments.

One of the commonly used horizontal blowing woodwind instruments in Chinese tradition, the Chinese bamboo flute, is generally divided into the southern qu flute, the northern bang flute and the alto flute in between.

The flute is often used in Chinese folk, opera, Chinese national orchestras, Western symphony orchestras and modern Chinese orchestras, and is one of the representative musical instruments of China.

In the national band, the flute is an important wind instrument and is regarded as the representative of the national wind music. Most of the flutes are made of bamboo, but there are also stone, jade, mahogany, and bone flutes in ancient times.

However, the best raw material for making flutes is still bamboo, because bamboo flutes have better sound effects and lower production costs.

This is not difficult, the lips are very loosely closed, and a slit is blown open with air, and the corners of the two mouths are slightly outward.

If you have the strength of the mouth, there will be no air leakage. This process takes about a year.

The difficult state in the mouth later on, like holding an egg. The throat is to be opened, and the most obvious feature of the opening of the throat on the outside is that the laryngeal segment sinks.

The hardest thing is the breath, which can be enough for you to practice for many years.

At the beginning, it was like this, I passed 2, 3, and it took a week to blow the tone accurately, the method is actually the same, the main thing is to practice more, and slowly find the feeling, don't worry, tighten your lips a little.

The lower lip is slightly inward, and it is most tense.

The mouth shape is mainly to control the airflow, and beginners must pay attention to the three factors of "damper", "mouth wind" and "mouth strength" when playing.

1. Damper: When playing the flute, the gap between the two lips through which the airflow passes is called the damper. When the damper is played again, it changes with the pitch of the flute. The lower range is slightly enlarged due to the slower airflow; The damper is slightly narrowed in the treble due to the rapid airflow.

2. Mouth wind: When playing the flute, the breath that comes out through the "wind gate" is called "mouth wind". When the high, middle and low pitches and intensity of the flute change, it is required to control the lightness, weight, slowness and urgency.

When blowing the treble and strong notes, the "mouth wind" is required to be tight and heavy; When playing the bass and weaker notes, the "mouth air" is required to be slow and light.

3. Mouth strength: When controlling the size change of the "damper" and the light, heavy, slow and urgent "mouth wind", the lip muscles, the corners of the mouth and the cheek muscles cooperate with each other, and the control ability of repeated retraction is called "mouth strength". In order to achieve the ideal level of blowing, beginners must work hard to control the "mouth wind" and "damper" practice to keep the pitch accurate and the timbre beautiful, so that their "mouth strength" can pass the test first.

In addition, Madi emphasized that the mouth must be open to the maximum state when blowing, as if blowing with something in his mouth, which is conducive to controlling the shape of the mouth and breath.

To practice the flute, you must first practice the basic skills, first of all, you must practice qigong well, and the breath must be sent and received freely, starting from the long tone. If you are a beginner, these pieces may be more difficult to blow, Gusu Xing is relatively easy, in which the fluttering vibration is used frequently, reflecting the style of southern music, it is recommended to listen to the performance of famous artists. The use of the whip is frequent, reflecting the characteristics of the northern song, which has high requirements for the use of the calendar, the fingering and breath must be well matched, and the pronunciation should be crisp and neat.

357 is a Wu opera music card, bold and rough, relatively difficult, is a famous song of the southern school, trembling and vibrating needless to say, but also luck cycle ventilation skills, the whole music is made of 6 cylinder sounds, high requirements for fingering, the fingers should be extremely flexible, and added the skills of the northern school chopping, the style of the whole song.

It requires a combination of rigidity and softness. I'm a hobby, and I've been blowing Gusu for 10 years when I've been able to blow Gusu Xing a little fluently, but it's still out of reach compared to Yu Lao, and I've been blowing the whip for three years, and I still don't know its essence, not to mention three-five-seven-nine, I usually practice it's okay, and I don't dare to blow it in front of others. It is recommended that you start with a simple blow and practice the basic skills.

When blowing, gently place the blow hole under the lip, cover about a quarter of the blow hole with the lower lip, open the mouth, relax, and gently blow the bamboo flute.

To get the right mouth shape, you can take the following steps:

1. Relax facial muscles;

2. Naturally purse the lips;

3. Lift the laughing muscles and lift the pressure points on both sides of the lips upward;

Fourth, blow out the breath gently. Through these four steps, the correct mouth shape can be formed. When not in use, the tongue should be naturally relaxed in the lower part of the mouth to open the mouth and increase the airflow channel.