How often should the bloodworm hook be changed and how the bloodworm hooked

If you don't have the hook on it, you can change it.

If you don't have a hook, you can change it.

Supplement. into a hook of bloodworms.

You can hang the worm stick near the barb of the hook so that the fish can easily swallow it. However, when tying the worm to the hook, pay attention to the tightness. If it is too tight, the worm will be like welding to the hook after the fish swallows the hook and cannot be retreated, and the tip of the hook will be difficult to pierce into the fish's mouth; If it is too loose, after the swallowing hook of the fish and the gnawing and pecking of the small fish, the worm will hang under the hook again, and the fish will only swallow the bait and not swallow the hook.

You can also hang the worm above the back bend of the hook, so that if the fish wants to swallow the bait, it must swallow the hook first. It is better to use a sleeve hook with a narrow hook door, and the hook and bait will be sucked into the mouth of the fish together. But if the worm ties it too high and the hook is exposed too much, some fish will not bite the bare hook when their mouths touch the bare hook.

Please click Enter a description.

Monolithic hooks. If you want to fish for small crucian carp, you can use a single worm through the hook or a multi-worm hook. The hook that wears a single worm should not only be thin, but also sharp, otherwise the body fluids of the bloodworm will flow out if you are not careful, and it will become a white skin, without the effect of attracting fish.

To thread the hook for a single worm, choose a slightly larger bloodworm, and then gently prick a small eye with a needle on the head, squeeze out a drop or two of liquid, and then insert the hook.

Please click Enter a description.

Multi-worm hooks. In addition to the thin hook bar, the hook tip of the hook should be slender, and three or four bloodworms should be threaded side by side from the bottom of the head, but care should be taken not to let the body fluids of the bloodworms flow out.

Please click Enter a description.

Barb-free hookworms.

Barbless hook fishing, which is not harmful to fish, is conducive to the protection of fish resources, and is worth advocating. However, fishing with bloodworms in winter and spring has become a problem. Whether it is a worm or a single worm, the fish can eat the bloodworm from the hook without hitting the fish.

One way is to tie a loop around the middle waist of the hook with a thread, and then point it with 101 glue, and after the glue dries, it becomes a fixed small round hoop. Then tie the worm to it, and the fish will not eat the bait and not hit the fish when they swallow the bait.

Here's how to hook up bloodworms:

1. Tie the bloodworm hook method with a small red line, use a chopstick, and cut it on the opposite side. Use a small stick to jam the gap. Then first pass the red thread through the tachyon, and then put the bloodworms one by one into the other gap of the tachyon, tie them with the red thread, and hang them directly on the hook.

This is a very commonly used red early hook method.

2. Use bloodworm clips for bloodworm hooking, and it is very common to leak high bloodworm clips, and fishing tackle stores generally sell them. Attach a rubber band to the hook and prepare to pack the bloodworms in this band. Use the bloodworm clip to stretch the bands out.

This makes it easy to pack the red morning directly in this clip. Place the bloodworm clip in the bloodworm pile.

After the bloodworm clip is released, there will be bloodworms tied up by the rubber band, so the bloodworm hook is more than half completed. Finally, pull out the redundant and unfledged bloodworms, and only load three or four to form a small red early ball.

3. Hand tie method, this method of hooking the bloodworm is relatively slow and requires a certain amount of patience. Holding the hook in your hand, place the red on top of a cushion, such as a flattened apple, to facilitate the use of a bloodworm hook. One by one, pass the bloodworms through the middle, and hang a few of them.

If you are skilled, this bloodworm hooking method is not bad.

Although the season has slowly entered spring, the advantages of bloodworm fishing in early spring are still very obvious, so using bloodworms well can greatly improve the possibility of explosive protection.

Here's how to hook up a bloodworm:

How to hook a bloodworm with a single hook:

If we encounter a small crucian carp, we can use the method of direct hooking of a single bloodworm, and we should choose a male bloodworm with a larger individual, because its flesh is relatively thick, and it is not easy to deform after hooking. After we have selected a bloodworm, we prick a small hole in its head, squeeze out a little of the bloodworm's body fluid, and then insert a single hook into the bloodworm's body.

Here I would like to remind everyone that it is best to use sharp and thin cuff hooks to avoid the outflow of fluid from the bloodworm's body if you are not careful, resulting in only a small piece of white skin, which will not play a role in attracting fish.

Methods of multi-hooking bloodworms:

When encountering larger fish, a single bloodworm hook cannot play a role in attracting fish, so we need to use the method of multiple bloodworm hooks. The method of hooking multiple bloodworms is the same as that of a single bloodworm, we need to choose some large male bloodworms and thread them side by side into the hook. The hook is required to be sharp and slender, otherwise it is easy to leak the liquid in the body of the virtual body bloodworm.

The bloodworm hook method is as follows:

1. Single hanging method: single hanging method refers to directly hanging a single bloodworm on the hook, which is divided into two kinds of threading method and waist threading method due to different wearing methods, and this hook method is suitable for fishing small individual fish such as wheat ear fish, white striped fish, and small crucian carp with a small hook.

2. Multi-hanging method: multi-hanging method refers to hanging multiple bloodworms on the hook, generally using the waist threading method to wear the bloodworms on the hook in turn, such as accompanying this hook method is suitable for fishing crucian carp, tilapia, small carp and other medium-sized individual fish.

3. Gas cavity door core method: valve core method refers to the use of rubber bands to tie a number of bloodworms and then hang on the hook, this hook method is suitable for fishing large fish, such as large crucian carp, carp, large tilapia, yellow catfish, catfish, etc.

To sum up, there are three hook methods commonly used in bloodworm fishing, namely the single hanging method, the multi-slag slippery hanging method and the valve core method, among which the single hanging method is suitable for fishing small fish such as wheat ear fish and white striped fish with a small hook, and the multi-hanging method is suitable for fishing crucian carp and tilapia with a small hook, while the valve core method is suitable for fishing large crucian carp, carp, yellow catfish, etc.

Bloodworm Introduction: Daphnia belongs to the phylum Arthropods, Crustacea, and Gill Legs. Commonly known as fish insects. The body is small, about 2 mm long, light flesh-red, and lives in fresh water. The body is divided into a head and a trunk, and the trunk has 5 pairs of trunk limbs (thoracic limbs), which are motor and respiratory organs.