What should I do if the wires in the wall are broken and the power trip when I am renovating the hou

At this time, it is necessary to find an electrician in time, and then repair the wire in time, and then be careful during construction.

The best thing to do is to turn off the switch, then smash the wall open, fix the wires and continue construction.

In this case, it is necessary to check that the wire is broken and should be replaced in time, and then the switch should be repaired to ensure safety.

Punch drill through the wall of the wire and trip, this situation is mostly to call the electrician to pull out the wire for a new one, if your home is made by the decoration company into a horizontal and vertical line, most of them are dead lines, you can try whether you can pull the move, if the dead line can not be pulled, then you will win the lottery, can only play a piece of wall out of the original hole, reconnect!

If the hole is not deep and the wire is not broken, pull the gate and use the iron hook to pull out the wire and connect it, generally the wire will have to stretch, if the wire is broken, just open the hole a little wider and pull the wire out and connect it.

There must be a solution, because now every house is renovated with wires in the wall, and he must have a way, he can replace the whole wire.

Be sure to pay attention to the strength when punching, so that the wires will not be damaged and will not cause tripping.

The solution to the broken wires in the wall of the home is as follows:

The first method is to pull out the original wire and replace the new wire, first we need to find the joints at both ends of the wire, disassemble the wire joints and cut off the bent wire, and then wrap the wire around a large wrench at one end of the wire, and take the wire out of the way by winding the wire on the wrench little by little, instead of pulling the wire directly outward as everyone thinks, and we must also pay attention to the use of the old wire to bring the threading wire in.

The second method is to rearrange the exposed circuit, in order to choose the trunking or the wire wax code tube, remember to buy the best trunking conduit, in addition to the use of structural glue (so that there is no need to play screws on the wall when fixing the trunking), the relevant sticky clip on the line, we first use the structural adhesive to arrange the trunking in our pre-planned trunking position, after the structural glue reaches the strength, put the wire in and then deal with the wire connection beam is completed.

Wire selection criteria

Choose copper core wire: wire, first of all, to good conductivity, there are copper core wires and other wires on the market, copper core wire is the most practical one for interior decoration, but copper core wire is divided into several kinds, there are most of the wheel of which diameter copper core and multi-line copper core.

Wires with strong load capacity: the electricity consumption in the family is sometimes large and sometimes small, and when the maximum we will turn on the TV, turn on the air conditioner, turn on the computer, turn on the lights, turn on the water dispenser, refrigerator, blow dryer, etc., if the load capacity of the wire is not strong, coupled with the hot summer, it is easy to make the wire burn because of the high temperature, resulting in a fire.

Good waterproof performance: Some wires are easy to deform and crack, in case there is a water leak somewhere, then it will lead to electrical appliances burning out, short circuits and even fire and personnel, so it must be hard outer skin and good waterproof wires.

Summary. Public Security Administration Punishment Law of the People's Republic of China》 Article 49: Anyone who steals, defrauds, robs, snatches, extorts, or intentionally destroys public or private property is to be detained for between 5 and 10 days, and may be concurrently fined up to 500 RMB; where the circumstances are more serious, they are to be detained for between 10 and 15 days, and may be concurrently fined up to 1,000 RMB. Criminal Law of the People's Republic of China Article 275:Whoever intentionally destroys public or private property, where the amount is relatively large or there are other serious circumstances, is to be sentenced to up to three years imprisonment, short-term detention or a fine; where the amount is huge or there are other especially serious circumstances, a sentence of between three and seven years imprisonment is to be given.

It is recommended that you can ask the property management company to identify who caused it, and calculate the economic loss according to the degree of fault.

If there is no property situation, you can call the police to deal with it first, and contact the power bureau to repair the wires first to avoid harm.

Moreover, such an act of the neighbor has constituted the crime of intentional destruction of public or private property.

Public Security Administration Punishment Law of the People's Republic of China》 Article 49: Anyone who steals, defrauds, robs, snatches, extorts, or intentionally destroys public or private property is to be detained for between 5 and 10 days, and may be concurrently fined up to 500 RMB; where the circumstances are more serious, they are to be detained for between 10 and 15 days, and may be concurrently fined up to 1,000 RMB. "Criminal Law of the People's Republic of China" Article 275: Whoever intentionally destroys public or private property, where the amount is relatively large or there are other serious circumstances, is to be sentenced to up to three years imprisonment, short-term detention, or a fine of money is to be cancelled; where the amount is huge or there are other especially serious circumstances, the sentence is to be between three and seven years imprisonment.

If the wire trips, it must be caused by a short circuit or the circuit load is too large and exceeds the air switch load!

In fact, short circuit is also a cause of too much load on the circuit!

In this case, the first thing to find out is if there is a short circuit on which line. You can turn off the air switch of each line to see which one of the appliances in the whole home is working normally.

Once you've found the line, look for whether it's a circuit problem or an electrical problem on the line.

It is to turn off the electrical appliances on this line one by one to see if the line can work normally, to see if it is an electrical failure or because there are too many high-power electrical appliances on a line that causes excessive load; If there are too many high-power appliances, be careful not to connect too many high-power appliances on the same line; If it is an electrical fault, after finding the faulty electrical appliance, immediately cut off the power supply and send it for repair!

If the electrical appliance is normal, then check whether the circuit is short circuit caused by aging, animal bites, squeezing, etc.!

Please take a look at the voltage and power of the treadmill, it is estimated that its load is much greater than the load that you can bear for indoor wiring, so the fuse chooses power-off protection. It is recommended to replace the home pipeline, and if conditions permit, you can take a separate route for the treadmill.

Check room leakage protector tripping, or air switch, if the leakage protector tripping, it proves that there is electrical grounding or iron phenomenon, general air switch tripping, is the current is too large to cause tripping, or poor contact so that the air switch trips, now the air is cold, some heating appliances, and water heaters will be used at the same time, resulting in excessive current, the air switch more than two times will form a habitual trip, or even not close the brake, should be replaced with the air switch. There are many reasons like this. The main gate can be increased by the number of ampere, and the single P air switch can also be increased a little.

But don't do it more than the original, so that it can bring you a better and smoother power supply

If the ground wire is tripped after installation, is it a leakage protection trip, there should be leakage, it should be that the contact between the neutral wire is not very good, and the potential difference between the neutral wire and the ground wire is too large. The neutral wire should be connected more reliably and firmly.

This may be due to the fact that after using the treadmill, due to the excessive total power during use, the outer skin of the line is aging and there is a short circuit. It is recommended to check and replace the aging line. Or the size of the circuit breaker is too small, and the replacement specification is larger.

Friend: This is not in a hurry, as long as it is installed according to the above requirements, but the ground wire can also be dispensed with, try it if it doesn't trip, just try it, thank you for adopting.

Method 1: Pull out the original wire and replace it with a new one.

When you find that the wires buried in the wall are damaged, the first thing you think of is to replace the wires, and don't take any luck to continue to use them, otherwise there will be problems sooner or later!

Method 2: Rearrange the exposed circuit.

If you really find that the original wire can't be extracted, or you don't want to replace the wire and don't feel that the surface-mounted wire affects the appearance, then you can take the method of re-laying the surface-mounted wire duct, and then the wiring can be done.

There is an option to trade in the old for the new.

The current wire is generally a live wire process, if there is a problem with the line, directly with the help of the old wire can be extracted and replaced.

In addition, you can also choose to take the bright line, which is a more traditional practice, although it is not very beautiful, but the cost is less, it is more practical, and it is very convenient to replace.

The wires in the wall are broken, how to replace them? The old electrician teaches you the solution by hand, practical electrician technology!