Is there a solution to the tripping caused by the destruction of the wires in the wall during drilli

Punch drill through the wall of the wire and trip, this situation is mostly to call the electrician to pull out the wire for a new one, if your home is made by the decoration company into a horizontal and vertical line, most of them are dead lines, you can try whether you can pull the move, if the dead line can not be pulled, then you will win the lottery, can only play a piece of wall out of the original hole, reconnect!

If the hole is not deep and the wire is not broken, pull the gate and use the iron hook to pull out the wire and connect it, generally the wire will have to stretch, if the wire is broken, just open the hole a little wider and pull the wire out and connect it.

There must be a solution, because now every house is renovated with wires in the wall, and he must have a way, he can replace the whole wire.

Be sure to pay attention to the strength when punching, so that the wires will not be damaged and will not cause tripping.

At this time, it is necessary to find an electrician in time, and then repair the wire in time, and then be careful during construction.

The best thing to do is to turn off the switch, then smash the wall open, fix the wires and continue construction.

In this case, it is necessary to check that the wire is broken and should be replaced in time, and then the switch should be repaired to ensure safety.

In life, some decoration workers are not careful, accidentally hit the wire tripping when punching, at this time many people are thinking about whether to change the wire, for the sake of safety, it is better to change one, even if the punching to the wire tripping after restarting the power or need to be processed.

The wires in this place have been broken by you, and the copper wires inside have been exposed, and as long as they touch water or metal, they will trip.

Your drill bit will trip when it touches the wire, and the drill bit will be removed and it can be energized again, but in the future, if there is water or metal again, it will trip.

If according to the regulations, this wire should be scrapped, replaced with a new wire, not broken wall connection.

There are indeed potential safety hazards, one is the risk of leakage, and the other is that the damage to the wire also has an impact on the loadable load.

First determine whether it is a necessary line, if it is necessary, it should be completely solved, smash the wall to re-bury the pipe wiring, or disconnect from the nearest terminal and take the open wire to bypass. If it is not a necessary line, disconnect it from the nearest terminal and disuse it.

Since the nail is pulled out, the bare wire will touch the PVC pipe (the wire is worn in the pipe), and it will not trip often. If you feel uneasy, you can shake the circuit with a shake meter to see if you can shake it, and it is estimated that there is no problem. This phenomenon is very similar to the phenomenon of mixing the socket and the lighting line.

You can recall that when wiring, there is no lighting zero line taken from the zero line of the socket, or there is a phenomenon of mixing, to see if it can be adjusted back now, if it can be adjusted back, there will be no failure.

Another way is to replace the tripping road with an air switch without leakage protection. Although there is no leakage protection, it solves the problem of frequent tripping, which can be regarded as a test.

If there is a hidden danger in the line, the air switch with leakage protection is often judged to have leakage, so it trips. FYI.