How to deal with flowers, how to wake flowers

1. The method of awakening flowers is to first prepare a container with a large bottle mouth, if there are many flowers, you can also use a bucket, and if you have a small amount of flowers, you can use a wide-mouth vase, but remember that these containers must be washed with dish soap or other detergents to avoid leaving bacteria, which will cause the rot of flowers.

2. Put clean water in a clean large-mouth container, and try not to be polluted, so as not to affect the awakening of flowers. Then start to process the flowers, first of all, the packaging or other things around the flowers, after removing them from the flowers, cut off a part of the bottom of the flowers with scissors, pay attention here, to cut off the scissors obliquely, about 3-4 cm, so as to make the flowers and water better contact, so as to speed up the speed and efficiency of awakening.

3. Start to deal with the withered leaves around the flowers, about two or three leaves per flower. This step is also to prevent the wilted leaves from contaminating the flowers, and also to better transport water to the flowers.

4. Then soak the parts below the flowers completely in the prepared water, remember not to soak the flowers in water, otherwise it will cause the flowers to rot.

5. Finally, put the container with flowers and leave it in a cool and ventilated place for three to four hours, so as to complete the awakening of the flowers.

To wake up the flowers, remove the leaves.

After a long time of transportation, the buds and leaves will be dehydrated, and if the leaves continue to be retained, the consumption of nutrients will be accelerated, which is not conducive to the preservation of flowers. Therefore, in the process of awakening, it is necessary to prune off the excess leaves on the flower branches, and only keep 1 or 2 leaves at the upper end of the flower branches.

When waking up flowers, you need to prepare a bucket, fill it with pollution-free water, then take out the purchased flowers, remove the outer packaging, separate the flower branches, and then use scissors to cut the base of the flower branches at 60 degrees obliquely, remove the excess leaves, and finally place the flower branches in a bucket or water basin to soak all the flower branches in water.

Here's how to wake up flowers:

1. Don't rush to take care of the flowers before receiving them, and keep the leaves. The leaves help the flowers absorb water and awaken the flowers better.

2. Find a waking bucket (can be replaced by a bucket), prune the roots of the flower branches at an angle of 45 degrees 3 5 cm, and cut off more according to the depth of the bucket at home. Soak all the flowers except the flower heads in deep water for more than 4 hours (one night is best) and the flowers will be rejuvenated.

Precautions for flower awakening

1. When pruning flowers, the specific pruning height should be determined according to the height of the vase, so as not to affect the cuttings in the later stage. It should be noted that the part of the flower inserted into the water should not have leaves immersed in it, so as not to affect the water quality due to leaf rot. When waking up the flowers, do not let the buds get stained with water.

2. Except for hydrangeas and sunflowers, do not touch the water on the flower heads of any other flowers, otherwise your small flowers will have age spots. If you accidentally touch the water, shake it off gently.

Flower awakening means that the following things need to be done after the flower is purchased so that the flower can be maintained for a longer time.

1. Flowers after long-distance transportation, in the high temperature season, flowers will appear wilted or dehydrated, at this time the end of the flower stalk can be cut off a little, and then soak it all in clean water. To keep the flower heads out of the water, (the water level depends on the dehydration), use the pressure of the water to encourage the flower branches to absorb water. Leave 1-2 leaves for each branch.

2. The flower branches are soaked in water for about 2 hours (depending on the dehydration situation), and the flowers will slowly stand upright, and the branches and leaves will become bright and straight again. (It is very important not to throw it away because of its ugly appearance).

3. Flowers are cut from the base, and the outer layer of damaged old petals is not removed, in order to protect the petals inside, and the outer layer of old petals can be removed after receiving flowers. Do not see the outer layer of old petals and throw away the whole bunch. Remember, remember.

Very important, the beauty of the flowers is pruned).

Flowers bought in the florist need to be awakened, because after long-distance transportation, the internal moisture is depleted, and it needs to be replenished in time. When waking up, it is necessary to cut off the flower branches by about 3 cm and prune off the excess withered leaves. Then put it in a clean container, pour in clean water, and let it rest for about 4 hours.

It can then be inserted directly into a clear glass bottle for curing.

Under normal circumstances, after waking up the flowers, it is necessary to take care of the branches and leaves, and remove the bad old petals, and finally carry out normal maintenance.

Generally, the time to wake up is 4 hours to one night, depending on the degree of dehydration of the flower. The method of waking up flowers is actually relatively simple, after the flowers are transported, do not take care of them first, remove the water storage cotton wrapped in the roots, prune 3-5 cm with scissors at an oblique 45 degrees to the roots, and then soak all the parts except the flower heads into deep water for more than 4 hours, so that the flowers will be rejuvenated!

After waking the flowers, cut off a small section of the roots of the flowers, and then prune off the excess leaves and insert them into a vase with water.

If it is just bought back flowers, you can cut off part of the branches and leaves of the flowers, when pruning, especially the bottom of the flowers, to prune at an angle of 45 degrees, after the pruning is completed, the buds are partially exposed, and then prepare a container, add water to the container, and directly put the flowers to the centimeter, but pay special attention to not put the head of the flower into the water, the water level is controlled at about five centimeters of the flower head.

If you want to keep flowers fresh for a longer time, you can add sugar to the water, which can make the flowers fresher, and can also add nutrients to the flowers, avoid bacterial invasion, prevent the appearance of pests and diseases, we can also add some salt to the water, vitamin C is also OK, which can prevent bacteria from entering the flowers, and we can also use flowers to inject nutrient solution, which can make flowers survive longer.

If it is a flower that has just been bought, it must be done to wake up the flowers, so that the flowers will survive longer, and at the same time, we must change the water frequently, it is best to change it once a day, to ensure the cleanliness of the water quality, and at the same time add some nutrient solution to the water, so that the nutrients in the water will be more sufficient, and when maintaining, it is necessary to properly prune the flowers, cut off the withered flowers and branches to ensure its ornamentality.

In winter, wake up and grind cautiously refer to the flower 4 5 hours, and the flower branch is seriously short of water and needs to wake up 4 8 small filial piety, the longest can not exceed 12 hours. When waking up, the flowers can be taken out of the package, pruned off the wilted leaves, moved obliquely from the bottom of the flower branch at an angle of 45 °, and then put it into the container, poured into the tap water to dry for 2 3 days, after waking up, the flower branch can be fished out and inserted into the container for maintenance.

Wake up for 4 to 5 hours in winter, if the flowers are seriously short of water, you need to wake up for 4 8 hours. Note that in the process of awakening, the longest should not exceed 12 hours, otherwise the root system will rot and blacken. During this period, it is also necessary to avoid the flower buds being contaminated with water, otherwise it is easy to rot and blacken.

When waking up the flowers, you need to take the flowers out of the packaging bag first, prune off the dry and wilted leaves around the flowers, and keep only 2 3 well-grown leaves to reduce the consumption of water, and then you can cut 2 3 cm obliquely from the bottom of the flower branches to increase the contact area between the branches and water and prolong the freshness time of the flower branches.

When waking up in winter, you need to choose a container with a larger caliber, and then pour in tap water or 40 50 warm water after 2 3 days of drying, pour a small amount of water, not more than 2 3 of the depth of the container, and add 1 2 drops of diluted preservative, which can effectively shorten the time of waking flowers.

After the flowers are awakened, the inside of the branches will absorb enough water, and the flowers will resume normal growth, after the flowers are awakened, the flower branches can be fished out and placed in a transparent glass container for water culture protection, poured into the water that has not been over the bottle body 1 2, and 3 4 drops of nutrient solution, and the water needs to be changed every 3 days in the later stage to ensure the cleanliness and hygiene of the water quality.

1. Prepare a larger container in advance, such as: bucket (large bucket), put 1 3 2 3 water in the bucket (depending on the variety of flowers and the length of the rhizome), which is used to hold the flowers that have just been separated from the packaging carton.

2. Remove the outermost layer of the bud that is decayed and yellowish, and the petals that are obviously damaged, don't feel a pity, it is a protective petal during transportation, just remove all the petals from the roots, otherwise it will infect the bacteria and affect the opening of the flowers. Because of the fresh cut flowers.

In order to ensure that there is minimal wear and tear during transport, all the old petals of the flowers are not peeled off. Then cut off at least 2 cm at the base of the flower stem at an angle of 45 degrees, so that the whole flower will be full of water. Remember to remove the leaves from the part of the stem that has been soaked in water.

Especially for roses, try to remove all the root leaves, and it is recommended to leave 2 to 3 leaves under the flower buds. The main reason is that the leaves are very perishable when soaked in water for a long time, breeding bacteria, which will destroy the whole bucket of flowers.

3. Put the pruned flower branches in the prepared container and soak them, and slowly you will find that the flowers and leaves are quietly stretching, and it will take about three or four hours to wake up, which depends on the degree of water shortage of the flowers.

Awaken above. The method is suitable for roses, lilies, carnations.

and other mainstream varieties of flowers, but there are a few varieties of flowers that are particularly water-loving, such as hydrangeas, in order to quickly replenish water, a special way of awakening is required, that is, the flower stem together with the flower head is soaked in water, and the flower can be awakened for more than 4 hours.

This one is a bit harder! There was a tutorial for waking flowers in the peony I bought last time.