As soon as the house is renovated, cracks appear in the tiles, how to remedy it?

The solution of the bottom layer is very important to put it bluntly, the bottom layer, in fact, the wall and the pavement, there are some employees in the case of gradually paving the tile, the bottom layer of the oil stains, the ash layer, etc., do not do the solution, the tile can be tightly integrated with the wall.

There is also a situation that the wall may be hollow in the first place, and the bottom layer must be solved before the tiles can be gradually paved. This is the easiest to cause mutual conflict, and when the construction of the project comes to an end, you find that the drum is hollow, and the staff says that your wall is not very good, and I will not carry the pot of the hollow drum.

The cohesiveness of the mixed mortar comes from the smooth chemicals generated by the concrete and water, so the water is very critical. The water absorption of many tiles is extremely strong, in order to better prevent the tiles from pumping out the water in the mixed mortar, the tiles must first be fully drunk.

During the construction process, it is very likely that some employees will immediately use water pipes to pour the tiles, or the tiles will not enter enough, which is all lazy. Naturally, not all bricks must be soaked in water, and tiles with water absorption less than 1% do not need to be soaked in water.

Wall tiles are paved with wall tiles first, or floor tiles first? According to the specific steps and technological process of the construction work, after the first lane, the top of the wall, the wall and then the ground, the bricks of the wall should be paved first. Besides, if you stick the floor tiles first, the floor tiles are paved, and you will have to wait for a while before you can gradually lay the wall tiles, and time is money.

And first paste the floor tiles, until the case of sticking wall tiles, it is inevitable that there will be items falling on the ground, scratching the tiles, it is not easy to do environmental sanitation is a trivial matter, blocking the odor-proof floor drain is troublesome. Nowadays, the standard construction technique of throwing glazed brick wall, throwing glazed brick or throwing glazed brick wall is thin paste. In fact, it is not recommended to put floor tiles on the wall, in the specific operation process, if there is a non-standard engineering construction, it is also a very cumbersome matter to solve the problem of thin stickers.

And first paste the floor tiles, until the case of sticking wall tiles, it is inevitable that there will be items falling on the ground, scratching the tiles, it is not easy to do environmental sanitation is a trivial matter, blocking the odor-proof floor drain is troublesome. Nowadays, the standard construction technique of throwing glazed brick wall, throwing glazed brick or throwing glazed brick wall is thin paste. In fact, it is not recommended to put floor tiles on the wall, in the specific operation process, if there is a non-standard engineering construction, it is also a very cumbersome matter to solve the problem of thin stickers.

You can contact the tile installer and ask them to come and renovate it, there will definitely be leftover tiles when you install the house, and they will have a way.

The tiles should be replaced, and then find the original decoration company, let them solve this matter, under normal circumstances, it will not just be decorated like this, you need to let them see that there is a problem.

Find a construction team and have them do after-sales repairs so that you can solve the problem at the root cause and it will also reduce your losses.

There is no need to be responsible.

1. Some small cracks on the tile generally do not affect the use, so in order not to blacken these cracks and become ugly, we need to deal with the cracks as soon as possible, and buy a professional tile grout to add the joint, which is troublesome and wasteful, and the use of glass glue to add the seam is too technical.

2. In fact, you can use toothpaste to repair these cracks, gently squeeze out some toothpaste, and use your fingers to evenly apply the toothpaste to the cracks. Gently wipe off any excess toothpaste around you with a cloth or paper towel.

When it dries, the tile wall is like new, if the tile is colored, buy the toothpaste of the corresponding color, or mix gouache paint in white toothpaste, and the effect of applying the tile gaps is just as good.

3. If it is serious, the solution to tile cracking can only be to change the tile, but the treatment method is not complicated, as long as the cracked floor tiles are pried up, the ground base is removed, and then the bricks are laid with cement and yellow sand, and the construction party can be found to solve the problem.

Wall deformationCracking of tiles caused by wall deformation will show regular cracks in transverse, vertical or oblique directions. Precautionary measures: Before laying bricks on the light wall, ask the construction personnel to test the wall to see if the wall is installed firmly; Secondly, it is recommended to make a layer of steel wire mesh on the side of the wall tiles to improve the strength and load-bearing capacity of the wall.

These little things will be handled by professional decoration, how much does it cost to decorate the house? Click here to calculate for free: [Enter the area of the house, and calculate the house decoration with one click**].

The so-called local maintenance is to repair the position of the tile on the wall of the bathroom, and the location without the problem does not need to be repaired. And now the new house has only been moved in for a short time, that is to say, the wall tiles of the bathroom can still be bought, and this type of tile will not be discontinued immediately, so it can be partially repaired.

Maintenance steps: First of all, according to the number of edge cracks and peeling tiles on the bathroom wall, the new tiles will be purchased, and then the problem parts of the wall tiles will be cut and eradicated, and then the new tiles can be paved. The overall maintenance is not troublesome, after contacting the tiling master to the site, the repair can be completed in one day, and it will not have any impact on daily life.

Precautions for this method: for the removal of the edge of the wall has cracked, peeling tiles, special attention should be paid not to destroy other intact tiles, because the wall tiles are too small when paving, it is easy to damage the tiles next to them, so when shoveling, the edge should be cracked with a cutting machine, cut around the peeling tiles, and then slowly remove, so as to ensure that the tiles next to it will not be damaged at the beginning.

Solution 2: Have a tile beautician beautify the tiles.

The so-called tile beautician is to contact a skilled master who specializes in repairing tiles after a small damage to the tile. Tile beautician can repair the damaged part to the same as the previous undamaged part without removing the tiles, so now the wall tiles in the bathroom are cracked and peeled, and it is also possible to repair them by the tile beautician.

Maintenance steps: first crack the edge of the side wall brick, polish and smooth the peeling part, then use special repair materials to smooth it, and finally color, so that the wall tile part can be complete, without edge cracking and peeling.

Precautions for this method: for tile repair, it seems very simple, but the requirements for professional skills are very high, not that anyone can do it, so the repair ** is very high, usually charged according to the point, a point is about 100-150 yuan, according to the repair point to calculate the total, the overall maintenance cost is very high.

The wall cracks appear in less than three months after the completion of the decoration of the new house, which is a normal phenomenon, and there is no need to worry too much, let alone think about whether it is the quality of the house, because the wall construction is a very cumbersome construction in the decoration, and the result is that it is easy to crack. There was a crack in the beautiful wall, which was really unacceptable to us. So after the renovation is completed, why do these cracks appear on the wall or roof?

Like the general relatively large cracks, basically the result of the sinking of the building, this situation is mostly some new buildings, the foundation is not very stable, need a settlement period, during this period is prone to such a situation, this situation is generally no way, can only wait for the settlement of the building to stabilize. How to deal with wall cracks after less than three months of renovation. This is a common situation encountered during the decoration process.

Basically, there are two types of wall cracks. Dense cracks, exaggerated large cracks. Dense cracks, basically the bottom layer is not good, the plastering layer will be scraped off the powder by hand.

Don't panic if there are cracks in the decoration of the new house, how to deal with the cracks in the decoration? After the renovation is completed, we will encounter the situation of decoration cracks, and I believe that any owner will be unhappy when he sees the cracks on the wall after the renovation. So why do there be fine seams in the wall?

At this time, the first thing to see is whether the crack is big, if the crack is not big, you can use the same color as the tile to repair the joint, if the crack is very large, you need to smash the brick down and re-pavement, and also to figure out why the tile will crack, to prevent such a situation in the future.

We should go to the renovation staff again, because it is a mistake made by the renovation staff, and we should go to them to compensate or ask them to take care of it for us again. Because we can't solve this kind of thing by ourselves, we should protect our own rights and interests.

You can buy professional tile caulk to fill the joints, or you can use toothpaste to repair these cracks, if it is more serious, you can only change the tiles.

Kiss! Hello, happy to answer your <>

The solutions to the cracks in the tiles of the newly renovated house are as follows: 1. The cracks can be covered with tile paste for cracking repair. For the first time, users with high requirements often use tile paste as caulk, which can produce almost the same smooth visual effect as the tile surface, and is available in multiple colors, hard and wear-resistant, so it can also be used to repair obvious cracks and play a role in disguise.

2. If the hard object is damaged, use toner to make up for the problem of scratches caused by the hard object knocking the surface of the tile, if you think it is troublesome to change the brick or you can't find the same style of tile, you can use marble glue reinforcing agent, adjust the toner to a close color, fill in the vacancy on the porcelain surface, and polish and polish it after hardening, but this practice may lead to different degrees of color difference. 3. Cracks in floor tiles are recommended to be chiseled and pasted if the bricks are so damaged that cracks appear, it is recommended to replace the old bricks directly, be careful when chiseling bricks, it is recommended to ask professional workers, and then stick the same brick, so that the effect is the best. Second, tile cracking prevention measures 1, the hardness of the ceramic tile of the choice of brand products is directly related to the density, when purchasing, turn the brick over to see the back, the more delicate the particle of the tile density, the higher the hardness, the better the quality; You can sprinkle water on the back of the tile, if the water does not seep down and flows downward, it means that the tile is denser and harder; If water seeps down, it means that the tile is less dense and less hard.

2. Soak the tiles in advance and use cement mortar to pave the tiles (mainly referring to the wall tiles), and the tiles need to be soaked in water for about two hours in advance. The higher the density and quality of the bricks, the shorter the time it needs to be immersed in water. The thin paste method does not need to be soaked in water, and the proportion of the adhesive contained in the mortar used is larger, and the water retention is extremely strong.

3. Leaving a reserved joint tile and caulk will have thermal expansion and cold contraction, and appropriate gaps should be reserved when paving; Caulk is a flexible product with toughness and low strength, which makes up for the expansion coefficient of thermal expansion and cold contraction of ceramic tiles, and can avoid hollowing and cracking to a certain extent. Hope mine can help you <>

Do you have any other questions?

Many people put tiles on top of the decoration of their houses, which can make people live better and make people look more comfortable. However, there are also people who suddenly see cracks in the floor after making tiles, which is unacceptable to them. Many people think that this kind of thing is a very bad thing, so they go to a professional teacher to explain it.

This method can also be well avoided and treated, and sometimes, you can use a pigment mixed with white powder, apply it to the cracked tiles, and finally brush a piece of wax oil on the floor, it will become very transparent.

Many people believe that having a crack in the floor is a very bad thing and they can't stand it. That's why, this happens. This is also to let everyone think less about it, and in some cases, this kind of thing is something that everyone doesn't want to see, and some measures can be taken to make up for it.

This is also a good precaution, otherwise, it is easy to cause some unfavorable situations.

Cracks appear in some places, also to attract everyone's attention and attention. If you can ask a master to fix it, you can solve this problem. It's called "don't worry" because that's a terrible thing.

I hope everyone is sensible about some situations, cracks in the floor, and it's not because of their bad skills.

The cracks on the floor are also the cause, and the master did not use many raw materials in the process of laying bricks. Therefore, there is a gap in the ** of this floor tile, and this gap comes from this. The simple method is to batch putty in the gaps and spray latex paint, and the other method is a little troublesome, knock off some putty in the cracks, paste the mesh cloth, and then apply putty in important batches, and then spray latex paint after polishing.

If there are specialized masters, tinkering with some small methods, this can be prevented. Therefore, for such a situation, everyone should treat it rationally, and the cracks on the floor are not worth making a fuss about at all.