I often hear that cleaning floor heating is really useful?

It is often heard that cleaning floor heating is really useful. Because the accumulation of impurities is serious, it can lead to clogging of pipes. When a pipe is blocked, that pipe can't provide heat.

If the amount of pipe replacement is huge, it can cause a lot of time and financial losses. The effect that can be achieved is the thermal conductivity of the underfloor heating pipes.

Reach normal. As long as the thermal conductivity of the floor heating pipes is normal and the water temperature of our supply and return water is normal, this means that our indoor air temperature can fully meet the requirements.

1.After we cleaned the floor heating, we removed some impurities from the heating pipes. In this way, the heating pipe achieves a normal caliber, so the circulating water is normal.

If the underfloor heating pipes are dirty, the heat will definitely not be as good as the air emitted by clean hot water. Therefore, it can also improve the air environment to a certain extent. With a wrench.

Slowly unscrew the water splitter.

The exhaust valve at the end of the main return pipe connects a length of hose and puts the end of the hose into the sewer.

2.When we find that the floor heating at home is not hot, judge the specific reasons for the floor heating not to be hot. The first thing to do is to go to other homes to see how well they are heating, and if other homes are hot, then we can conclude that it is our home's underfloor heating problem.

In this case, the appropriate elimination method should be taken to find the specific cause. If too much bioslime accumulates in the geothermal pipes, it can clog the inside of the geothermal pipes, causing the geothermal heat to not work properly. If it is to be repaired again, it needs to be dismantled, and the geothermal piping system needs to be replaced.

3.We have to make sure that there is no gas in the underfloor heating system, so that the water can circulate properly and achieve the normal heating effect. Check all the plumbing and plumbing valves on our indoor underfloor heating to make sure all doors are at the normal opening angle.

At this time, all you can do is to release the water all the way, observe the flow of water and then release the water. The purpose of drainage is simply to clean up the impurities present in the underfloor heating pipes. If it is a new floor heating, the problem of not heating can basically be solved by draining water.

The above is the answer to the question of whether it is really useful to hear about cleaning floor heating.

It's not particularly useful, because cleaning the floor heating in time, your community heating ** is not particularly good, so it still won't cause the temperature of the floor heating to rise.

It is useful, and the floor heating can be cleaned up in time after a long time, which can make the effect of floor heating better and will not affect the heating supply.

It is indeed useful, and these places will make the temperature in the room warmer, and the overall effect will be improved.

Cleaning underfloor heating is not fooling.

The impurities generated in the floor heating pipes affect the heating effect and service life. After running for a heating period, the floor heating pipeline will accumulate 1 mm thick dirt and slime, which will reduce the diameter of the pipeline, reduce the water flow, and reduce the indoor temperature by 3 6 degrees Celsius.

If the above substances are not completely removed, it will not only cause pipeline embolism and cannot be dredged, but also multiply a large number of bacteria, causing serious harm to our health. If the floor heating is not cleaned, it will not only affect the temperature of the room, but also cause a waste of energy. In severe cases, the service life of the floor heating will end, and only the floor will be removed and the heating method will be replaced, which will bring you property damage and loss, and affect the life of the ordinary life.

The basic principle of underfloor heating

The hot water in the underfloor heating work pipe is circulated through the heating pipe coiled below the ground, that is, the hot water for heating is connected from the water separator to our underground heating track.

Hot water is constantly circulating in the pipeline, you can transfer the heat in the water to our floor heating pipe, and at the same time through the method of radiation heat dissipation, so that the temperature of the whole room is improved, if our home is laid with floor heating, then the ground temperature at home is still relatively high, through the ground heating, you can make the whole indoor air become warmer.

It is useful to clean the underfloor heating.

With the gradual growth of heating demand, the heating industry is emerging, especially for the demand for floor heating, and many people will choose floor heating cleaning projects when there is a problem with floor heating at home.

SentenceHow to cut off the floor heating at home whether it needs to be cleaned:

1.First of all, in the process of using floor heating, if you obviously feel that the temperature of the floor heating in your home does not change very much, or the temperature rises very slowly, you can observe the pipes connecting the manifold to the floor heating.

If you look at the color of the above has been tan or dull gray, it proves that a lot of dirty mud has been accumulated, and if the darker the color of the pipe, it means that the floor heating needs to be cleaned in time.

2.Secondly, you can also judge the blockage of the underfloor heating pipes by draining the water one by one, before that, all the valves for the return water should be closed, and then we will open the valves of the upper circuit of the water separator and the water collector one by one, and then observe the flow of water.

If the flow of water is large in each circuit and the pressure supply is sufficient, it does not need to be cleaned, but if it is obvious that the pressure of the water is insufficient and the flow rate is small, then cleaning is required.

3.Finally, you can also test whether the temperature is suitable by touching, put your hand on the return pipe connected to the water separator, if you find that the water temperature is low, or even no temperature, it means that the floor heating pipe has been blocked and needs to be cleaned.

1. Geothermal cleaning is useful. Due to the long-term flow of water in the geothermal pipe, the water will contain a large number of microorganisms, under certain conditions, these microorganisms will produce a large amount of biological slime, and will adhere to the inner wall of the geothermal pipe, after a long time will have an impact on the heating effect of the geothermal heat. Therefore, it is best to clean the geothermal heat regularly.

2. The standard specifications of the floor heating pipes that are buried under the floor and invisible are 20*, which means that the outer diameter of the pipe is 20 mm and the wall thickness is mm), and its inner diameter is 16 mm.

3. People who have floor heating at home may know which floor heating pipe has such a thin inner diameter, and the water flow in the pipe flows back and forth in such a thin inner diameter. Then the problem comes, if the hot water in such a thin pipe is in for a long time, the inner wall of the pipe will scale the mucous membrane, which will cause blockage and affect the heating effect of the home.

Summary. 1. Floor heating should be cleaned for about 2 or 3 years, otherwise it will cause the heating effect of floor heating to decline, because long-term non-cleaning will lead to a lot of scale and impurities inside the floor heating pipe, and the heat conductivity of scale and impurities is not good, so the heat of hot water in the floor heating pipe can not be transmitted to the ground in time, so that we feel that the temperature of floor heating is getting lower and lower year by year. 2. The circulating water in the floor heating pipe is mainly blocked by tap water, the tap water quality is not good, calcium carbonate will be formed when heated to about 60 degrees, which is what we call scale, the scale will slowly adhere to the inner wall of the floor heating pipe, and the scale will become thicker and thicker after a long time, and finally it may lead to the blockage of the floor heating pipe, and the cleaning will not play a role if the scale condensation is serious, and the whole floor heating will be directly wasted.

Oh no, dear. Cleaning the floor heating is not fooling people, and the impurities generated in the floor heating pipe affect the heating effect and service life. If the pipeline is not effectively cleaned for a long time, on the one hand, the water flow rate decreases, the flow rate slows down, and the indoor temperature also drops significantly; On the other hand, the more serious lead surface is that some of them will crack into pipeline embolism, which cannot be dredged, resulting in the permanent failure of the geothermal pipeline and irreversible.

1. Floor heating should be cleaned for about 2 or 3 years, otherwise it will cause the heating effect of floor heating to decline, because long-term radical change will lead to a lot of scale and impurities inside the floor heating pipe, and the heat conductivity of scale and impurities is not good, so the heat of hot water in the floor heating pipe can not be transmitted to the ground in time, so that we feel that the temperature of floor heating is lower and lower year by year. 2. The circulating water in the floor heating pipe is mainly blocked by tap water, the water quality of tap water is not good, calcium carbonate will be formed when heated to about 60 degrees, which is what we call scale, scale will slowly adhere to the inner wall of the floor heating pipe, and the scale will become thicker and thicker after a long time, and finally it may lead to the blockage of the floor heating pipe, and the cleaning will not work if the scale condensation is serious, and the entire floor heating will be directly wasted.

3. Hengchen wastes energy when there is scale in the local heating pipe, which will affect the heating effect, and the same energy is spent, but the worse the heating effect of the floor heating, which is equivalent to wasting energy, which can not achieve the heating effect and consumes very much electricity.