Baby hat crochet tutorials

There are many ways to knit a beanie, and we are now going to learn a way to knit a baby beanie with an osmanthus needle.

First, raw materials tools.

Wool, woolen needles.

Second, the method steps.

1. Prepare wool and wool needles, and use 60 needles for demonstration.

2. Distribute on 3 needles, start to knit the cap edge, knit a needle up and a needle down.

3. After weaving to a length of one inch, change the stitching method and weave osmanthus needles.

4. The weaving method of osmanthus needle is to weave a needle on the needle and then knit a needle under the needle, the second circle is to weave the needle at the place of the needle, and the needle is knitted at the place of the needle. In short, when you see the next needle, you will knit the needle, and when you see the upper needle, you will knit the next needle.

5. In this way, you can see the small osmanthus flowers one by one when you weave them to a certain length.

6. Then continue to weave to two-thirds of the length of the hat.

7. The next step is to reduce the needle. Needle reduction method: two needles and one knitting needle, and then continue two needles and one knitting needle, so that a circle is finished. Knit 2 more turns of the needle.

8. After the needle is knitted, the needle is reduced again, this time the needle is different from the last time, the method of needle reduction is: knitting a needle and then 2 needles and a needle; Knit another needle, then 2 needles and one needle. That's how the circle is finished. Knit another circle of needles.

9. When there are 12-14 needles on the rod needle, you can thread and collect the needle. Method: Leave 20 cm long wool, thread it into the coil and tighten it on the reverse side. Turn it over again and tidy it up.

10. Finally, decorate with your favorite flowers, so that the baby hat is knitted.

1. The first step is to start the needle. Let's take 60 stitches, as shown in the figure below. When knitting a hat, you also need to look at the head circumference.

The size of the needle.

Needle starting method: first make a looper, wrap the right hand around, and put the coil on the needle. until the 60-stitch is full.

2. The second step is to weave the brim. After picking up the needle, start knitting a needle up, a needle down, and weave to a length of one inch.

3. The third step is to change the thread and weave the needle. Knit to a length of one inch and change to white thread.

Knit the needle. <>

Knit to two-thirds of the length of the hat.

4. The fourth step is to reduce the needle. When weaving to two-thirds of the length of the entire hat, two needles and one needle are not knitted for 8 needles, then 8 needles are knitted, and then two needles are combined with one needle, and the operation is repeated to finish the circle.

5. In the fifth step, after reducing the needle, weave a circle of needles without adding or subtracting.

6. The sixth step is to reduce the needle in half. Knit one needle, two needles and one needle, then knit one needle, then two needles and one needle, and repeat the operation to finish the circle. Then knit a circle of needles.

7. The seventh step repeats the operation of the sixth step, and there are 12 stitches on the rod needle.

8. The eighth step is to weave the tip of the hat. When there is 12 on the rod needle, start to knit the needle, and weave until you are satisfied with the length, generally 1-2 inches long.

9. The ninth step is to tighten the thread head. Thread the end of the thread through the wire loop and tighten it on the reverse side. Turn it over and tidy it up so that the children's hat is knitted.

Precautions: When knitting for the baby, start the needle according to the head circumference.

The specific operation of the baby hat crochet tutorial is as follows:

3. After the head and tail are connected and the needle is pulled, continue to hook 3 braid needles.

4. Hook 2 long needles in each braid.

5. Hook a long needle in each braid, hook it to the length required by the hat, and then hook a circle of short needles.

6. Hook 3 braid needles, 3 long needles, and 1 extraction needle.

7. Repeat crochet to hook a circle of petals.

8. Finally, sew a bow as a decoration, that is, complete the specific steps of the baby hat weaving.

The baby hat crochet tutorial is as follows:

1. First of all, use a ring needle, wrap a circle around your fingers with wool, and thread the crochet into the three braid needles as the first circle of cherry blossom key hidden needles.

2. After the braid needle is hooked, the crochet needle is inserted into the spine hall circle and begins to hook the long needle, a total of about 12 needles, and then, pull a bright Chang down the thread, tighten it, and let all the long needles be presented on a plane as much as possible. Then close the needle on the first braid needle, and the first circle is hooked.

3. In the second circle, you have to start adding needles, and the hook method is also three braid needles first, and then, hook two long needles in a long needle in the first circle.

4. In the third circle, the needle is still added, and at this time it is two needles and one long needle. That is, one stitch in a single braid in the side, two in the second braid, and so on.

5. The fourth circle is to add a stitch to the three braids on the side. The first and second braids have one long needle, and the third has two long needles in the middle. In this way, hook to the size of the top of the baby's head, and then do not add needles.

Then, in the side braid, the long needle is hooked without adding or subtracting. Hook all the way to the right size. The hat is almost finished.

6. For the lace of the hat, you can hook three braids, and then hook a short needle every other needle, and hook it all the way. You can also collect the needle inside and hook the baby's ears to protect the ears.

First, hook 6 needle lock needles, and connect the head and tail pulls. The first circle: hook 20 long needles in the ring (the first 3 locks of the standing needle count 1 needle), and finally pull with the standing needle (each subsequent turn is with the first needle pull); Lap 2:

2 long needles are hooked in every 1 needle, and a total of 40 needles are hooked; The third circle: add 1 needle every 1 needle, and go to the hook according to the rule of (1, 2), and a total of 30 needles will be hooked; The 4th circle: add 1 stitch every 2 stitches, and dehook according to the rule of (1,1,2), with a total of 40 stitches.

The 5th circle: add 1 needle every 3 needles, and go to the hook according to the rule of (1,1,1,2), with a total of 50 needles after hooking; The 6th circle: every 9 needles plus 1 needle (that is, 9 needles are not added or subtracted, and the 10th needle is hooked with 2 long needles), and a total of 55 needles are hooked; Note:

If the baby's head circumference is larger, you can continue to add needles according to the previous rule of adding 10 stitches per circle. Lap 7: A long needle without adding or subtracting the hook.

The 8th-9th circle: change the B color line, do not add or subtract the hook for 2 long needles; The 10th circle: change back to the original line, do not add or subtract a long needle; Line 11:

We're going to start hooking the brim part; Add 1 needle every 4 needles to hook out 6 groups; Row 12: 1 lock, directly into the 2nd needle on the hook short needle (you can also directly into the 2nd needle in the hook short needle, and then 1 lock), the middle part does not add or subtract the hook short needle, the last 2 needles crochet short needle 2 and 1; Rows 13-15: Repeat the regular dehook in row 12 (i.e., subtract 1 stitch from each end of each row).

Finally, hook a decorative strip: start with 32 locking pins (the number can be adjusted by yourself), and then hook a row of long needles without adding or subtracting. Once hooked, place it on the row of B-colored lines above the brim, add buttons to the ends and sew it up, and this cute baby hat is complete!

Children's hat crochet tutorial

There are many ways to crochet a hat, some of which are complicated and not easy for beginners to learn. Crocheting, like any other skill, starts with the simplest ones. Now let's learn how to hook a child's hat that is relatively simple and easy to learn.

Tools Raw materials: wool, crochet needle.

Method steps.

1.Choose the color of the yarn according to your child's needs, then prepare the crochet needle and start stitching. Wrap the left index finger around the left hand with a wool thread twice, and then use a crochet needle to make 3 knitting needles in the loop.

2.Next, continue to crochet long needles, a total of 14 long needles, plus the first 3 knitting needles for a total of 15 long needles. After the hook is completed, the head circumference is connected, and the hook is hooked, and the pin is drawn.

3.In the second circle, hook 3 braid needles, and hook 2 long needles in each unprecedented braid. Hook the second round.

4.Third lap. Hook 3 braid needles, hook two long needles in the braid and continue to hook one more long needle. Repeat until the third lap is complete.

5.The fourth lap is the same as the third loop.

6.On the fifth lap, the pattern begins. Hook 3 braid needles at the beginning, then 3 braid needles in the front hole.

Hook a short needle again. Then continue to hook 3 long needles in the front hole, and then hook a short needle. Repeat to complete the fifth lap.

7.The sixth lap begins, and the fifth lap is the same.

8.The seventh to thirteenth circles are hooked in the same way as the circles. After 13 laps, start hooking.

9.Hook edge: Pick up 3 braid needles, then hook 3 long needles in the same hole. Then hook a short needle in the front hole, then continue to hook out 3 braid needles, and hook 3 more long needles in the same hole, and so on repeatedly.

10.In the end, the thread is broken and the thread is broken, and the child's hat is completed.

Baby hat crochet tutorial with **, as follows:

1. Sort out the wool you bought, some of the wool is twisted and twisted, and you need to sort it out into a clump after you buy it, so that it will not be knotted.

2. Prepare the rod needle and wool, first tie the yarn into a slipknot, thread the rod needle into the slipknot, and then wrap the thread with your fingers, put the winding coil on the rod needle, and now there are two coils on the rod needle.

3. Repeat the needle in this way, a total of 32 needles.

4. After the needle is completed, start to knit a needle on the needle, a needle under the needle, as the saying goes, up and down the needle.

5. Repeat the knitting to the length required for the brim.

6. Then start to knit the hat body, after knitting a circle of positive needles, and then knit a circle of reverse needles, and repeat the knitting to the length required by the hat body.

7. After the completion of the knitting of the hat body, it is necessary to knit the top of the hat, and the weaving of the top of the hat takes the method of collecting the needle, after weaving two positive needles, two needles and one needle to collect the needle, so repeat the weaving, only to the rod needle There are 10 needles on it.

8. Prepare a section of thread, thread the coil on the rod needle, and then tighten and tie it on the reverse side. In this way, the top weave is complete.

9. Then turn the hat over and sew a small decoration you like on the hat, so that the baby hat is knitted.

The crochet method of baby hat is as follows:

1. Method 1.

1. Take coarse wool as raw material, knit with double needles, start 58 needles (the number of needles depends on the thickness of the wool) and weave a total of 5 inches, weave 10 lines of needles, 14 lines of needles, and so on, each row puts a needle on one side and a needle on the other side, and then closes the needle after knitting to the size of the head circumference, and then sews both sides into a spiral cylinder.

2. Close the top, pick the needle on one side of the cylindrical edge, knit the needle in a loop, and collect the needle every 2 rows at 5 pins, every 2 rows at intervals of 4 stitches, every 2 rows at intervals with 3 stitches, receive the top has been a small number of stitches, and then put away these small number of stitches at one time, it will be sealed into a dome, and a button will be surrounded by hooked wool and sewn on the top of the hat.

3. Knit the brim, pick the needle on the other side of the cylindrical edge, weave a 1-inch needle in a circular row, and then knit an ingots needle or bag needle 1 inch, and after receiving the needle, turn over the brim.

2. Method 2.

1. Use the woolen needle, hook 6 lock needles into a loop.

2. Determine the number of stitches according to the size of the hat needed.

3. Each long hook has two long needles, that is, twenty stitches are added, and the hook is forty stitches.

4. In this row, pay attention to the needle hook under the two long needles added in the previous row, and the two long needles are separated by a lock needle.

5. After the 8th line, no longer add the needle, hook to the required depth, there is a baby can be tried on the baby's head, here hook 6 lines plus the previous 8 lines is 14 lines.

6. Hook back and forth like this until the outline of the hat comes out.

7. Finally, the circle can make the hat more beautiful, outlining the lace in the brim.