How to make hand knitted roses, hand woven tutorials for roses

Material: 2 60cm 5 wires, 1 20cm jade wire, iron wire.

The specific weaving process of auspicious knot roses is as follows:

Cross two 60cm lines of 5 from the middle and prepare to weave an auspicious knot.

Tie an auspicious knot and pull it firmly tight.

Tie the second auspicious knot, pay attention to the direction, like a round corn stalk, so that the braided roses will be round and have the effect of petals.

Don't pull too tightly, make a circle bigger than the first auspicious knot. The scale here can be grasped by yourself and adjusted to your liking.

Tie the third auspicious knot, which is a little looser than the second auspicious knot, but not too loose.

In this way, the auspicious knot is tied a total of five times, and the main body of the rose comes out.

Turn the roses upside down, and make the pedicle of the rose underneath to make the flower more three-dimensional.

Tie the auspicious knot on the reverse side, pay attention to the line of the square corn knot here, do not pull it too tightly to avoid the deformation of the petals.

Tie the auspicious knot again, a little tighter than the first auspicious knot.

In this way, gradually tighten, until the auspicious knot is pulled to the tightest, you can end it, tie it with jade thread, and if possible, you can also insert the wire and put it in the vase.

Happy life is a little clear, with Chinese knotted roses, how to weave petals? I knit it up, but it won't be tightened, and the second layer has to be knitted along the inside, I don't understand, I use an ordinary Chinese knot, maybe it's a little fine, I can't see the effect.

Tools Raw materials.

1 piece of colored square paper.

Method steps.

Prepare a piece of colored square paper, fold the two sets of square paper on opposite sides and diagonally, and then.

Using the center point of the square as the base point, fold the four corners towards the base point.

Then, a small square is presented, and the four corners are folded towards the center point.

After that, it becomes a smaller square and folds the four corners towards the center point.

Fold the four corners of the first layer outward in the direction of the arrow.

Then fold the four corners of the second and third layers outward.

Finally, fold the corners of the four outer edges of the square backwards in the direction of the arrow. In this way, a simple and beautiful rose is folded!

The rose hand-weaving tutorial is as follows:Tools and high-profile materials: crochet needles, woollen yarn.

1. 51 braided needles for the starting hook.

2. Count two stitches back and crochet three medium and long needles in the third braid needle file book.

3. Hook four medium-length needles in the sixth braided needle, and then hook four medium-length needles in a braided needle every two needles. A total of 17 groups.

4. Change careers and start three braided needles. Then hook two needles with medium and long needles. The first one is finished with Biyan petals.

5. Hook a short needle between the two petals. Hook a pull-out needle, two braid needles, and then two medium-length needles on the first central macrolong needle on the second petal, and then hook a short needle at the petal junction. Hook a line in this way.

6. Roll up the hooked picture above, arrange the shape, and fix it. The roses are ready.

The rose handmade method is as follows:

1. Fold the square card in half 3 times in a row along the opposite corner.

2. With the center point facing down, draw a petal shape and cut out the shape.

3. Cut out 3 identical petals and grind them.

4. For the first flower, cut off half of the petals (the part framed by the white line).

5. Two flowers of the first ear of morning stockings, cut off a whole petal (the part framed by the white line).

6. For the third flower, cut off a whole piece and half of the petals (the part framed by the white line) and keep the cut part for later use.

7. Paste all the petals on both sides of the head and tail with double-sided tape, and cut a small hole in the middle of the flower.

8. All petals are rolled outward.

9. Roll the green cardboard into a straw shape and paste it with double-sided tape.

10. The flowers pass through the small holes in turn from large to small.

11. After all the strings are skewered, tidy them up manually and fix them with double-sided tape.

12. Excess green waste paper, cut out the appearance of leaves.

13. Wear the leaves that become flowers from the bottom, tidy them up, and a beautiful rose is ready!

The handmade rose preparation is as follows:Prepare a square of colored paper. Fold in half diagonally.

Fold it in half and fold it into a triangle. Fold the back edge in half along the edge. Form a square.

Along the creases, a triangle is formed. Fold the corners of the triangle up.

Brother Sui folds the corners of the triangle downward. In turn, pull up one of the corners in the middle. Make a rotation. Press outwards with a toothpick to form the petals. Such a simple rose is ready.

The tutorial on how to make handmade roses is as follows:

1. Cut 4 pieces of shopping bag width of about 8-10 cm square, first take out one of the pieces, fold in half, and then fold in half again, lift one of the corners, fold inward, and fold the other corner in half in the direction of another wandering land.

2. After folding in half, cut along the right angle along the straight line, use the coin to close the edge of the cut, draw an arc, and then use scissors to cut along the arc drawn, after opening, it becomes a complete petal with eight protruding fillet corners.

3. Next, we need to cut out some petals with different numbers of prominent rounded corners. First cut one petal with a round corner, then cut two petals with a rounded corner, and so on, cut out three or four petals with a rounded corner, so that we get 7 petals of different sizes that are high with a round corner.

4. Glue one petal with hot-melt glue to the top of the flower god's stem, and then glue two petals with hot-melt glue to form a flower-shaped pattern and insert it into the flower stem.

5. Then use hot melt adhesive to glue the 3 petals together, and then put them into the flower stem, and so on, 4 pieces, 5 pieces, 6 pieces, 7 pieces of petals according to the size of the ** number, successively set into the flower stem, after the set to get a bright red rose.