How can you survive with yellow wattle? Can Huangjing survive digging in October?

To plant the stakes of Vitex to make it have a higher survival rate, it is necessary to dig it in the right season.

In order to avoid water loss after excavation, it is necessary to cut off the excess branches and leaves of the stake under the mountain to ensure the integrity of the root soil ball. Transplanting the P. stake in loose and breathable soil to keep the soil moist during the maintenance period is conducive to the survival of the P. spp.

Vitex has strong adaptability and grows mostly in barren mountains or slopes. To plant a stump with a higher survival rate, you can use soft, fertile, breathable and well-drained soil. Before planting, it is necessary to disinfect the soil, and then transplant the stump of Vitex in a pot, and water it appropriately after transplanting.

Precautions for the maintenance of Vitex.

During the maintenance period, it is necessary to place the P. ritex piles in a cool and ventilated indoor position for maintenance, which is conducive to the adaptation of the P. spp. to the soil. During the maintenance period, it is necessary to pay attention not to give light and fertilizer to the pile, otherwise it will affect the survival of the pile.

After the stake adapts to the new soil, it can be given sufficient light, water and fertilizer, and generally in about 15 days, the stake will sprout. During the budding period, nitrogen fertilizer can be applied to the stump to promote the growth of young shoots. During the curing period, there is also a moderate amount of watering to keep the soil moist.

Can live. In general, the best time to harvest Vitex is in March and April in spring and September and October in autumn, and the survival rate after planting at this stage is high. When excavating the old pile, special attention should be paid to protecting the roots, the roots of the old piles are thick and developed, and most of them are irregular pimple-shaped, so the trauma of the roots should be minimized when excavating, so as to improve the survival rate of planting.

After digging back the stump, plant as much as possible to avoid excessive water loss. Before planting, the roots should be pruned, sterilized, etc., and some too messy roots, as well as long roots that affect planting should be cut or truncated, and then sterilized with potassium permanganate solution.

Don't water too much of the newly potted vitex, generally keep the soil slightly moist, at this time the absorption capacity of the roots is not strong, too much watering will affect the root respiration. At this stage, water can be frequently sprinkled on the plant and around it to maintain the humidity of the surrounding air.

Notes:

After the plants are fully viable, they are watered according to the principle of "seeing dry and wet". During the growth period of the plant in spring, the potting soil should be kept with sufficient moisture, if the potting soil is too dry for a long time, it will not be conducive to growth, and it will also lead to yellowing and falling off of the leaves.

In the later stage, in order to shorten the branches and make the leaves smaller and increase the ornamentality, appropriate water and fertilizer control management can be carried out at the germination stage of the plant to increase the aesthetics.

Yellow Vitex is originally a deciduous family Winter deciduous leaves belong to the normal phenomenon of oak filial piety The survival rate of Vitex is relatively high, so don't worry too much about survival.

Key points of maintenance of Huangjing bonsai.

1. Place the field of caution.

The Huangjing pile should be placed in a place with good air circulation and sufficient sunlight. There is no need for shade in the real season, but it should not be placed on the cement bench, as the high temperature is scorching, which is not conducive to growth. It is more cold-tolerant in winter, and Jiangnan can overwinter outdoors, but it must be put indoors in the cold north.

2. Fertilization. In addition to rainy days, water water - thin rotten cake fertilizer water every week, or biological fertilizer, can be applied to Ribery Yanwo water-soluble fertilizer, avoid thick fertilizer to burn roots, affect growth. After forming, it is necessary to control the fertilization, generally apply one time in spring and summer, and one more time after autumn, so as not to cause too much fertilizer and water, cause growth, disturb the tree shape, and affect the ornamentation.

3. Watering. Potted vitex should be kept moist during the growth period, and it can be slightly dry at ordinary times, so that it can be dry and wet, not dry and watered. Watering in summer should be in the morning and evening, and watering should be less in autumn.

4. Pruning. Vitex is extremely germinating and resistant to pruning, and is pruned once a year after autumn to thin out some unnecessary branches to maintain a certain tree.

Appearance. Usually, you can often pluck the tops to control the growth of branches and leaves.

5. Turn the pot. It should be carried out every 2 3 years, preferably before bud in 3 April. When turning the pot, cut off the dead roots and the old roots, remove the 1b21 day soil, and replace the beams with loose and humus-rich new culture soil.

The bottom of the pelvic should be hollowed out and a layer of coarse sand should be placed to facilitate drainage.

You can turn over the pot to see if there are rotten roots or insect pests in the roots, so as not to cause problems with the bonsai in the future. If the roots are fine, you can apply the right amount of fertilizer, loosen the soil, and water to see, if there is no improvement, it is completely useless to laugh.

Studies have shown that the good temperature for the germination of Vitex should be kept between 14 and 29 degrees, and the most common way to sow seeds is Vitex spp. Autumn is not very cold, the temperature is basically at the degree suitable for germination and growth of Vitex, so of course you can sow Vitex in autumn, and the growth of Vitex plants sown in autumn is also very vigorous, so it is also very suitable to sow Vitex in autumn.

Vitex planting management:

1. Planting: Choose the right pot soil, the flower pot can choose purple sand clay pots, and the soil should be made of breathable and permeable garden soil. Prune properly before potting, remove old roots, rotten roots, and over-dense roots, fill a certain amount of soil in the pot, and then plant the yellow vitex into it.

2. Maintenance: It is resistant to semi-shade but likes light, and grows in a place with good light. During the growing period, water should be given regularly to maintain good nutrition. It has a strong ability to sprout and tiller, and it is pruned to maintain its beauty.

3. Yellow vitex is repotted.

1. Vitex is a shrub of the verbena family, which is widely distributed in China, and is widely distributed in mountains, hills, canals and other places from the Yellow River Basin to the Pearl River Basin in China.

2. Vitex is a plant with strong adaptability to the environment, drought tolerance, barrenness, low temperature resistance, shade tolerance, and is a relatively strong plant variety that grows in the wild, so it can be transplanted all year round.

3. The excellent bonsai material with strong germination ability of Huangjing is widely distributed, easy to take, and very resistant to pruning, suitable for pruning and pruning, which is a good material for making bonsai.

Although Vitex can be repotted all year round, in terms of survival rate and slow seedling, the best time to change pots is - before the germination in spring every year, which is conducive to slow seedlings and germination, followed by the autumn and winter after the leaves fall in autumn.

Fourth, the precautions for changing pots.

1. Soil selection.

2. Precautions for basinging.

Vitex likes water and fertilizer, so in the process of potting, you must pay attention to putting a layer of broken rubble in the basin in order to ensure the normal and vigorous growth of plants and prevent water accumulation. Then put a layer of fertilizer at the bottom of the pot, and in the process of potting, the soil must be compacted. After potting, it can be placed in a warm place in the spring after watering, and in the summer, it needs to be placed in a cool and ventilated place to slow the seedlings.

Vitex is resistant to drought and barren soil, with strong germination ability and strong adaptability. In the distribution area, Vitex has no special requirements for soil, and can be planted without slope or technical constraints.

When the seedling growth and germination speed is fast and the palmate compound leaves are 2-3 rounds, you can choose to pick up the topping with wax, and at the same time strengthen the water and fertilizer management of the nursery to promote the growth and germination of branches and leaves. It can also be pruned according to the height of the seedlings. The following year, the 1-year-old seedlings can be used for afforestation.

The early growth of Vitex is slow, so you can apply some nitrogen fertilizer, or take deep ploughing and burying green, or use tillage instead of planting beans and green manure. It can loosen the soil, enhance the soil permeability and water storage performance, facilitate the extension of the root system, and promote the growth of young forests. On slopes with a lot of mixed shrubs, vegetation should be cleared.

1. How to plant.

1. Prepare potting soil: In order to ensure the aesthetics, the flower pot is generally selected purple sand clay pot, the color should be darker, and the shape can be rectangular. It is better to choose a garden soil with good air and water permeability, and it is also rich in nutrients to facilitate the growth and development of the root system.

2. Treat the plant: Before the plant is potted, it is necessary to deal with it properly, prune the roots, remove the old roots, rotten roots, and over-dense roots, and cut off the overly long roots. Proper pruning of the branches and leaves to reduce water evaporation.

3. Planting pots: The time is generally selected in spring from February to March, filling the slag in the pot and renting a certain amount of soil, and then planting the yellow wattle into it.

Second, there is a lack of sale, how to raise.

1. Light: It can tolerate semi-shade, but it prefers sunlight, and its growth needs to be placed in a sunny place, exposed to enough sunlight, to maintain good growth.

2. Water and fertilizer: It can tolerate drought and has little demand for water, but it needs to be given water regularly during the growth period. It is also necessary to maintain good nutrition and apply fertilizer according to the needs of growth, and the concentration should not be too high.

3. Pruning: It has a relatively strong germination and tillering power, and it is necessary to maintain the aesthetics of the bonsai through pruning and pruning regularly.