I always hear a whining sound at home, like a mobile phone vibrating, ringing once every two minutes

I don't know if you believe it, I have been back to my hometown since November, every night at 1---3 o'clock can hear the sound of knocking on the door, my family in the countryside, there is no entertainment after eating at night, basically every family eats, watching TV 8, 9 o'clock basically sleep, I am a night owl, every time I sleep at about two o'clock in the morning, at first I thought it was someone who had something to do and didn't take it seriously, but the next night I can still hear, my family has 6 roosters, every time I hear the sound of beating, my rooster crows, I can't hear the rooster crow, as long as I knock on the door, my chicken will crow The most is 6 times to knock on the door The chicken basically can't hear it I asked my mother, my mother didn't say much, they all told me that it was a neighbor's house, and every time I got up early to work, but I didn't believe it! Because my mother goes to bed early every time, no matter how rainy or snowy it is, the temperature is minus 7---8 degrees in the early morning, and the rural people basically sleep. At first, I was scared to go to bed early, and I was woken up by the sound of knocking on the door several times, and I looked at my phone at more than 2 o'clock, and I was not in good spirits for a few days Now it's 12:50, and I used to go to bed early, but my current job doesn't allow it Your whining is better to find a little famous feng shui master to see!!

You must doubt what I say, you will definitely not believe it, I have a master who understands the five elements and is now old, so I believe it, and I believe it!! Brother whining at home, go find a feng shui, or know how to take a look

Is your home new, or is the heating ringing?

Did you find the cause of the problem? This is also the case for me, also once every 2 minutes

It's not something out there.

It's possible that the engine inside is causing the stuttering vibrations.

Hello this may resonate I hope my answer can be helpful to you, please set to, thank you!

It is recommended to go to the 4S store for test confirmation.

You should take it to the 4S store to check, no matter how versatile the network is, some things still can't be solved.

After the automatic washing machine is started, only the whining sound is heard, but the reason for not turning and the treatment method:

First, when the washing machine is washing clothes, if the motor has a humming sound, but does not turn, it may be a problem with the starting capacitor. If there is no sound from the motor, it may be that the lid linkage switch of the dehydration bucket is faulty.

Second, check whether the belt is loose, check the pawl and clutch, and see if the brake is tight or whether the mechanism plate on the drum cover is broken.

Third, the automatic washing machine does not rotate, some motors with clutches are very hot, and the starting capacitor may be broken, or the wire head falls off and the motor cannot be started. If there is no clutch, see if the motor is stuck, do not idle the belt under the motor experiment, whether it is stuck, if it is not stuck, most of the starting capacitors are problematic.

Fourth, the spinning tube does not rotate in the following situations:

1. The motor burns out (no reflection when energized).

2. The brake line is broken (the motor cannot be started after the power is turned on).

3. The timer is damaged (after twisting and twisting, the timer has no ticking sound).

4. The water seal is damaged (the water seal is damaged, and it is difficult to put the clothes right until the official does not turn, and the sound of the clothes tube can be heard at this time).

5. The line is open (generally visible with the eye).

1. The capacitance of the capacitor decreases due to poor quality or too long use. It can be paralleled with a capacitor with a withstand voltage of 400 volts and a capacitance smaller than the original specification, or the capacitor of the original specification can be replaced.

2. After the washing machine is overhauled, the winding of the motor is connected incorrectly. The motor windings should be re-welded.

3. Some guide strips of the motor rotor are broken. The rotor should be replaced with a new rotor or a new motor.

4. Local short circuit of the stator of the motor. If a local short circuit cannot be ruled out, only a new motor.

5. The relevant bearings are poorly lubricated due to lack of oil, and the rotational resistance increases. The bearing should be filled with oil or replaced with a new bearing.

6. The power supply voltage is low.

7. If the belt of the washing machine is too loose, you can adjust the tightness of the belt by adjusting the fixing bolts of the motor, or replace the belt with a new one.

8. Washing too much laundry, exceeding the rated capacity, the general solution to this problem is to control the amount of laundry washed within the rated range.

9. The matching hole between the wave wheel and the rotation is seriously worn, and it is generally enough to replace the Weidong wave wheel.

Generally speaking, it is caused by the failure or old damage of the starting capacitor, just buy and replace it as it is...

The motor is not powerful....Or the belt is too loose....Be careful and check it out....Thank you.

If you hear a sound when the washing machine starts, but you don't see it moving. Then you have to disassemble the chassis below to see if the belt has fallen off or is broken.

The circuit board is broken, the signal cannot be sent, or the motor is in poor contact or the motor is broken.

Before you put it into practice, be sure to read the manual. Are people so lazy now? Remember the precautions clearly before starting to use them, and remember not to idle!

Let me know when you have the results, my family is pretty much the same.

You unplug the electric plug of the water heater, and then turn on all the faucets in the house, including the toilet tank and the water heater shower faucet to put water together, about five seconds to ten minutes, and the water will be discharged with air, and it will never ring again.

1. It is normal to make a sound, because the heating water with resistance performance will make a sound, and the electric heating pipe will emit a burning vibration wave and the sealing resonance sound of the water reservoir when it starts to heat after the power is turned on, and the sound will become smaller and smaller as the temperature rises, so there is no need to worry.

2. If you hear the squeaking sound of other electrical appliances or smell the smell of electrical plastics, then this sound belongs to the fault of the electrical part, and then immediately stop using and call the relevant maintenance personnel to come for maintenance.

In the case of the water heater, when you go from winter to summer, it makes a sound, which is normal.

Because the amount of gas suddenly decreased, a small amount of air was mixed in. So there will be a booming sound, and the flames will turn red.

If it is always ringing, you can turn up the heat appropriately, or it may be the main accessory of the water heater, the burner.

The burner burns unsteadily during ignition, resulting in a de-flame resulting in noise.

At the same time, the output of hot water, once the above unexpected failure, the gas water heater will automatically stop working within 10 seconds, and immediately cut off the gas to prevent the gas from continuing to flow out, and can not be automatically reopened, unless the above faults are artificially eliminated and then restart the gas water heater, in order to work normally, therefore, its working performance is relatively safe and reliable.

Such a situation is generally more common in the use of gas water heaters in winter, this is because the temperature is low, the temperature of the combustion chamber rises sharply when the water heater is turned on and ignited, including the abnormal sound caused by the temperature difference resonance caused by the sharp increase in the temperature of the exhaust pipe, if the interval is not long when in use, because the combustion chamber and the smoke exhaust pipe have not been completely cooled during the second ignition, this phenomenon will be reduced or completely disappeared in summer.

Normally, it is caused by the high temperature of the gas combustion flame heating the water in the heating tube.