The correct use of the fish tank water pump, how to install the fish tank water pump

The correct way to use the fish tank water pump is as follows:

1.Before use, you need to check whether the nameplate on the pump is consistent with the rated voltage used. After the power cord is arranged, it is necessary to check whether the power cord is damaged, and if there is, it cannot be used.

2.Move the entire pump to the edge of the fish tank and adjust the height to a suitable range.

3.Plug it in and turn it on, and water will squirt out.

4.Next, you need to connect the upper and lower ends of the air duct and plug in the power cord, which means that the whole thing is ready to use.

It should be noted that during the use of the fish tank water pump, the oxygen pump needs to be placed above the water surface to prevent the siphon effect from pumping out the water in the fish tank during a power failure. In addition, the pump's inlet needs to be cleaned regularly to prevent blockages and damage.

A long tube with one end on the submersible pump and the other end on the drain box. By the way, your pump is oxygenated, there is a thin pipe plugged into the pump at one end, and the other end is fixed on the side of the fish tank, pay attention to expose the water surface.

When installing a submersible pump, the cable should be overhead and the power cord should not be too long. Do not stress the cable when the unit is launched, so as not to cause the power cord to break. Do not sink into the mud when the submersible pump is working, otherwise it will cause poor heat dissipation of the motor and burn out the motor winding.

When installing, the insulation resistance of the motor should not be lower: the motor below 13kw can be started directly, and the starting compensator should be used above 13kw.

Try to avoid turning on the machine at low pressure. The power supply voltage can not differ from the rated voltage by 10%, the voltage is too high to cause the motor to overheat and burn out the winding, the voltage is too low to reduce the speed of the motor, if it does not reach 70% of the rated speed, the starting centrifugal switch will be closed, causing the starting winding to be energized for a long time and heating and even burning out the winding and capacitor. Do not switch the motor on and off frequently, because the electric pump will produce backflow when it stops, and if it is turned on immediately, the motor will be loaded and started, resulting in excessive starting current and burning out the windings.

Do not let the electric pump run for a long time, do not pump water with large sand content, and the dehydration time of the electric pump should not be too long, so as not to overheat the motor and burn out. During the operation of the unit, the operator must observe whether the working voltage and current are within the specified value on the nameplate at any time, and if it does not meet the requirements, the motor should be stopped to find out the cause and eliminate the fault.

Fish tank inverter pump installation**, have you learned?

Pipe plug submersible pump plug drain box pump with oxygenated thin tube plug pump and fix the fish tank side, pay attention to the exposed water surface, simple do not understand, and then ask.

Tell me the name and accessories on the manual of your pump to guide you in the installation.

<> fish tank submersible pump should generally be placed at the bottom, there is a branch above the outlet pipe, the upper part should be connected to the intake pipe, and the other end should be exposed to the water surface for air intake, and a control button needs to be installed at the end to adjust the size of the air intake. The function of the submersible pump is to keep the water flowing, so that it can avoid becoming stagnant water, so that the water quality can be better maintained, avoid rapid deterioration, and at the same time, it can also raise dissolved oxygen in a small amount.