How do you find groundwater when digging a well? How to tell if there is water in the ground when di

1.In summer, the ground temperature is low, and the water volume must be large in places that have not been hot for a long time; In particular, the pond that has been silted up for a long time can produce water after digging deep;

2.Observe the surface drainage. Where it is often wet and the slowest drainage, groundwater is close to the ground.

3.There is drought all around, and only the middle is wet, and there is a water source where the crops are ripening at the latest.

4.There is moisture on the ground at the foot of the mountain, and there is water in the early morning, dusk, or winter, when the water rises like fog, or where moss grows on the edge of the rocks, and where water often flows out after rain.

5.The ground water source is generally good when the spring thaws early, the winter freezes late, and the snow melts quickly.

6.In the morning or evening of summer, where mosquitoes gather in clusters, there may be a lot of water underground.

7.Where the fog rises in autumn mornings, the water table is high.

8.After the winter freezes, there is hoarfrost in the places where the cracks in the ground are located, and the water table is high.

9.Observe the grass and trees on the slope, if they sprout early in spring, and do not wither in drought, there must be a water source nearby.

10.On the ground where the wells are to be drilled, some small pits about two feet deep are dug to observe the groundwater. Method:

1) In the morning of spring and autumn, when the sun has just risen, climb from this place to the ground and obliquely look, which pit has a large fog, and the surrounding groundwater level is high. (2) Buckle a bowl in a small pit, and see that there are many and large water droplets in the bowl every other day, and the underground water source is prosperous and the water is shallow. (3) In spring, autumn or winter sunny days, put firewood in the pit that is easy to smoke, and the smoke rises straight after lighting, and the groundwater near it may be good.

If you want to find groundwater, you must first look at the mountains, and in the alpine areas, the main source of groundwater is the natural storage of water. It is water that seeps into the ground and stores when it usually rains. However, such places are characteristic, such as the ring-shaped mountain at the top, so there will inevitably be springs overflowing at the bottom of the mountain or halfway up the mountain, and of course, the flow will be smaller or dry up in times of severe drought.

If there is still a trace of running water or dampness in that place, there is a way to let the water stored in the mountains flow out of it. If I just said that I could get the flow out with fire, people wouldn't believe it, and they would say that I was a madman. Although, since ancient times, water and fire are incompatible, water and fire are always mutually compatible.

But sometimes they can really get together. I once saw that when people in the mountains burned charcoal, there was always water flowing out of the newly built charcoal kiln. If you choose a place that is not cool, there will always be water flowing out of the side of the charcoal kiln.

I slowly realized the truth when I couldn't figure it out.

When the charcoal is burned, the kiln generates a large amount of heat, which absorbs a large amount of surrounding water and turns it into water vapor. Because it is constantly absorbing and evaporating, the water in the ground forms a state of flow, and gradually searches the channel in front of it. So the water in it flowed out.

This is also the principle of ancient shamans praying for rain. Because the pilgrims always burn paper and incense at the outlet of the spring, which causes the flow of water in the ground.

1.Look at the size of the water area and the Taiji point of the water area from the well. 2.

Look at the water and see the faults. 3。Look at the water and see the color of the rocks.

4.Look at the water to see if the two adjacent rocks are weather-resistant, if both rocks are weather-resistant, there is water if there is a gap in the middle, and there is no water if there is no gap. If both rocks are not weather-resistant, there will be water if they are hard at the bottom, and there will be no water if they are not hard underneath.

For example, if there are two kinds of rocks, one is weather-resistant, the other is not weather-resistant, and there is water when drilled from the junction of the two rocks. 5.At the bend at the bottom of the ditch, the low-lying point of the plain.

In general, I can't describe it in detail, but I hope to include it.

Before drilling a well, the well drilling team will first use professional water finding equipment to determine the water level of the well. In addition to this method of measuring with instruments, there are also some methods of geographical knowledge: generally when the weather is relatively hot, if a certain place feels exceptionally humid, then there is most likely well water here.

Especially when it rains, it is generally difficult to dry up the water in these places. On the other hand, when it's colder, the water on the road will freeze, but if you find that the water in a certain place doesn't freeze. Then most of the underground water sources will also exist here.

If it's in the fall, foggy days are common. And sometimes we find that the fog is particularly bad in one place. Then there must be a water source nearby.

To dig a well, you need to know how to look at the place and find the water level. I was digging a well. After hitting more than two meters, the water could not be stopped, and then the water company fined money to stop.

When drilling a well, there will be a special survey machine, which can measure how many meters of groundwater is under the ground and does not need to be manually surveyed, so it is not accurate at all.

That is, how to find groundwater, this needs to be found with the help of tools, or with the help of third-party detection tools.

Hello dear<>

1. How to know that there is water in the ground when digging a well 1. According to an important principle of "back and oblique"; Faults are generally difficult to obtain water, the fault plane is fragile and cracked, water will seep down, naturally, no matter how the well is drilled, it will not upwell; The "anticline" is "convex", and the rock in the middle is hard and above average thickness, and it is futile to dig a well in such a location. 2. If the vegetation of the "anticline" mountain is relatively sparse, the vegetation of mosses will generally be relatively rich.

The "oblique" is of the "concave" type, obviously, the water seeps into the bottom of the rock, and the effect of drilling a well from above is better, not only the workload is less, but also the water source is continuous. 1. If you dig a well by yourself, you can see that a lot of water suddenly comes out, and it is continuous, that is, the water is out; 2. If the machine drills a well, when drilling the well, the mud will come out of the well pipe, if there is water below, the mud will decrease, the water will increase, and sometimes it will become muddy water, indicating that the water has been hit, if there has been more mud, it means that the water has not been hit, only to live and play, it is difficult to hit the machine, and then decide whether to change a place. Wells, engineering structures mainly used to extract groundwater.

It can be vertical, oblique and a combination of different directions, but it is generally vertical, which can be used for domestic water irrigation, and can also be used to dodge, hide or store some things, etc., and the above is my reply to you, if you think my reply is good, please move your fingers to give me a five-element like, oh <>

Make full use of the characteristics of the natural environment, and the growth characteristics of some plants to find water sources, like some wild plants with strong roots and deep roots, other places are sparse and sparse, but there is a piece that grows extremely vigorously, the soil at the root of the plant is moist and has water vapor, this place is a good place to come out of the water, the surface of the underground water source is sufficient, these are the crystallization of the wisdom of the past, through the plant environment is easy to obtain water sources.

2. The small method of digging wells to find water in the folk tradition, after selecting the site, put some soybeans in the appropriate place, and then use a large bowl to buckle the soybeans to keep a sealed environment, after staying overnight, open the bowl to see how the soybeans have changed, if the soybeans have not changed, it indicates that the water vapor on the ground is less, the groundwater level and water source are not ideal, it is not suitable for digging wells here, and the soybeans have obvious swelling changes, that is, the underground water gas is quite vigorous, and the water source is also very ideal. It is perfectly possible to excavate.

The first of groundwater is that after the rainwater falls to the ground, part of it seeps into the ground and accumulates in the cracks of the soil and rocks, which becomes groundwater. The amount of groundwater is related to lithological structure, topographic and geomorphological conditions and recharge**. Therefore, the experience of the masses in finding water is specially introduced, and the farmers in drought-prone areas are found to find water sources and dig wells.

Find water according to the characteristics of the terrain:

1. "It is most advantageous to find water". Surrounded by mountains on three sides, groundwater flows to Pukekou in a concentrated manner, so wells are drilled near Pukeikou, and the amount of water is more.

2. "Two mountains are sandwiched by a ditch, and there is a water flow in the ditch rock". Sandwiched between the two mountains is a ravine, and water sources are easily found in the rock formations on both sides of the lower valley.

3. "Two ditches intersect, spring water surging". At the intersection of the two ditches, there may be a spring water flowing under the mouth of the mountain, and the water source is more reliable when a well is drilled here.

4. "Mountain mouth to mountain mouth, there is good water under the mouth". The two mountain mouths are opposite each other and the distance is close, and the terrain under the two mountain mouths is flat, and it is easy to dig a well at the place where the lock mouth is located.

According to the situation you described. Ask how to make sure there is water in the ground. This general technology is evolving. However, they are all tested by instruments to determine whether there is water in the ground.

Generally, there is water in the place, and there will be water in many meters underground, but the depth of the water layer is different, and it can also be surveyed by instruments.

Now that science and technology have developed, there are special detection instruments to detect and see where there is water, so there is no need to worry about this.

In summer, when looking for a suitable place to drill wells, you need to observe the ground conditions, if the ground is wet, the ground temperature is lower than other places after the sun has passed, it means that there is a water source under the ground, which is more suitable for drilling wells.

In rainy or humid seasons, it is easier for the surrounding moisture and stagnant water to disperse, but if there is only one place where the stagnant water is often the last to dry up and the drainage rate is very slow, it means that the place is close to the underground water source, and it is also suitable for drilling wells.

How do you find groundwater when digging a well?

Kiss is happy to answer for you: How to find groundwater when digging a well? A:

Kiss Searching for groundwater is mostly based on topography and landforms. First, according to the flow direction of the water, low-lying areas are relatively easy to find, low-lying places can accumulate groundwater or when the flow rate is low, there will be a large amount of groundwater seeping into the ground. The two valleys sandwiched between the two mountains are mainly inclined to the middle of the slopes of the two mountains, and the water flows along the slope to the ditch to converge to form groundwater, which can be drilled out by drilling wells.

Third, the intersection of the two ditches is easy to form groundwater, and fourth, the two mountain ravines are sandwiched and lonely mountains, blocking the valley, blocking the groundwater, making it converge, and it is easy to form the groundwater formed by the spring flowThank you for your patience. The above is my full reply, if you are satisfied with my service, please give a thumbs up, and I wish you all the best!

Peace and joy!