When taking the driver s license subject 2 test, the bottom line is out of the warehouse

If the warehousing is qualified, it means that your vehicle has reached the specified positionBut when the warehouse is reported to be wrong, there must be a problem in the process of leaving the warehouse, the most likely is that the body is pressed to the edge of the garage detection line when leaving the warehouse, the bottom line of the garage does not refer to the rear of the garage line, the bottom of the entire garage can be called the bottom line of the garage, and the bottom line of the library is basically the body line in the process of leaving the warehouse.

How-to tips. Control the driving speed and idle in 1st or reverse gear throughout the journey.

Start at whatever speed you drive.

In the process of controlling the timing of steering, we should observe carefully, grasp the key points of steering, and turn in a timely manner.

When controlling the driving route test, the driving route of the car mainly depends on the speed and speed of rotating the steering wheel, looking at the sideline, correcting the direction in time, and keeping the car upright into the warehouse.

Generally, there will be no such situation as you said, and it is twice, it must be the front wheel line or the rear wheel line when you leave the warehouse, and report the "outbound line". Did you hear it wrong, can't you print the transcript if you fail, and the reason for the failure is written on the transcript. If it is really what you said about the qualified warehousing, when you go straight suddenly prompted the bottom line out of the warehouse, there is also a possibility that you "slipped" when you hung a gear and walked, that is, the car went backwards and caused the rear line to be pressed.

The real problem is **, you still have to think carefully about your whole process, if you really don't understand, ask the coach or consult the staff on the other side of the examination room.

In the dismantling of the second driving test subject, whether it is the rear or the body, as long as the body is out of the line, it is considered to be out of the body.

First, the content of the test of reversing into the warehouse:

1. Pour it into warehouse B from the starting point A and stop it.

2. Go to the return area C and stop steadily.

3. Pour into warehouse B from the return area and stop steadily.

4. Return to A from library B and the exam is completed.

Second, the evaluation criteria for reversing and warehousing:

1. Those who do not follow the prescribed route and sequence are not qualified.

2. The body is out of the line, reversing is not entering, and stopping halfway is unqualified.

3. More than 210 seconds without completing the reversing and warehousing is unqualified.

Subject 2. The following describes the steps for right outbound shipments.

1. Drive slowly to the reversing warehouse.

The starting point position, the left side of the body is meters to meters from the sideline.

2. Hang the reverse gear and reverse the car. When the lower edge of the right rearview mirror infiltrates with the yellow line heavy allergy source, hit the direction to the right.

3. Look at the right rearview mirror, pay attention to the distance between the rear wheel of the car and the crack angle of the right library, if the rear wheel of the car is just 30cm away from the right library angle, then there is no need to correct the direction, and continue to reverse directly. If the angle between the wheel and the library is less than 30cm, you can turn the steering wheel back a little bit.

to keep a distance of about 30cm.

4. Continue to reverse backwards, pay attention to the rearview mirror, and quickly return to the positive direction when the body is parallel to the edge line of the library.

5. Observe the left rearview mirror, and stop when the lower edge of the rearview mirror coincides with the yellow line. The right library is reversed.

Finish. 6. The same goes for Zuoku.