How to display the maximum depth in UG post processing

<> "Step 1: Create a new PB cmd before motion process, this process post-processing will be called by itself, when each process ends, min z is the lowest processing depth of this process.

Step 2: Collect the minimum machining depth at the end of each process.

Place the process PB cmd task toollist at the end of the operation.

Step 3: Rewrite the collected toollist to the program header, and put the process pb cmd end in the program end sequence.

OK That's it.

There is a problem with the first picture**, it can't come out, can you update it?

mom set seq off is to turn off the line number output, if you post-process the program as follows: n0110....n0120...n0130...The line number of this category. Then you won't be able to find this one.

May I ask the landlord, have you solved this problem, can you summarize it?

How to display the maximum machining depth and the minimum machining depth in the Z-axis in ug post-processing wo I succeeded.

Reply 1 If you want to suppress all z-value output. You can add the following **mom suppress always z) to the motion event

If you don't want to output z, you can delete the linear motion z and fast motion z in the post-processing.

I don't know why you have such a strange request.

This can't be done in full

1. First of all, open the UG software, enter the main interface of the software, and open a part.

2. Enter the processing module and set the parameters of the milling geometry and the size of the milling cutter respectively.

3. Open: Pocket milling operation, setting: specify the milling area.

4. Milling cutter: We select the flat-head milling cutter with a diameter of 8 just created, and select the cycloid for the cutting mode.

Processing. <>

5. Step distance selection: the percentage of the cutter straight, the percentage is 50, and the common depth of each cutter is constant.

6. In the setting of cutting parameters, the cycloidal width must be greater than the minimum cycloidal width, and not greater than the step distance, and the downmilling and outward cutting mode should be adopted.

7. Set the feed rate and speed.

It is more troublesome, because to find the depth and all the tools, the final data can only be obtained after all the program post-processing.

So it is generally output at the end of the program, if you want to output it in front, you need to store the data in a temporary file first, and then merge it with the toolpath data, which involves writing**.

<> is more troublesome, and the list of tools is simple.

This ** comparison z-axis nadir is recorded in min z.

This section is added at the end of each operation to collect tool information and machining depth.

Add this ** to the end of the program, and rewrite the list of tools in the program header.

It is the immutability of the company.

Learn to learn and brainstorm!

Upstairs tidy up, every time I see Yeager Boss, I can always get a harvest.

This is more troublesome and requires professional post-processing design to call system parameters, you can follow the tutorial.