I don t know what s wrong with the computer, how to solve it!! 10

I'll tell you, it's your memory that has a problem, go buy a good memory, not necessarily incompatible, it may be that the memory is broken, at the same time I am here to express my personal opinion on modern memory, I bought modern memory last year on the 2nd floor of Yangzhou Galaxy Electronics, used for less than a year, there was a problem, I went to change, said that it could only provide a repair, I didn't care, I looked forward to 4 weeks later, the memory was finally taken out, and it could be used, but the problem came out, the computer has been very stable, Now it's the old dead machine (without any prompts.,Reboot directly),I didn't think it was a memory thing at first.,My 256 512 are all modern.,It's just repaired and taken back (go to the modern warranty),Both are the same.,I thought it was 2 incompatible or something.,Just 256's ** out.,The information that people reflect is also like this.,It's very unstable.,Can light up.,Can enter the system.,But it's unstable.,Say reboot on reboot.,It's very serious., At this time, I realized the memory, the problem, and then after careful inspection, I found that there was something removed from the original memory (there were traces of welding), is it such a service after sales, grandma's, there are modern people out to say a word.

It should be caused by a problem with your hard drive, which leads to the loss of some files in the system.

Format the hard disk at a low level and try to fill the system. Otherwise, replace the hard disk and fill the system.

hehe ..

Many friends have this problem, if it is useless after reinstallation, it is a broken hard drive

1 Check whether the hard disk has bad sectors;

2. If there is a bad sector, mark or fix it;

3 Reinstall the system.

One problem has been found with the windows closed to avoid damaging my computer.

A critical thread on which a process or system is running exits or is terminated.

If you are seeing this stop error for the first time on your computer and the screen appears so follow these steps again;

chedk makes any new hardware and software properly installed. If this is a new installation, ask your hardware or software for any Windows updates you may need.

If the problem continues, malfunction or any newly installed hardware software is cleared. Loss of memory BIOS selection, such as caching or occlusion. If you need to use Safe Mode to remove or malfunction components. Restart your computer and keep holding F8Select Safe Mode.

Technical information: *Stop: 0x0000f4 (0x00000003, 0x826a1250, 0x826a13c4, 0x805fb7a8).

The body begins to pour physical memory, and the memory dump is complete. Your left half is the system administrator or technical support team for further assistance.

Hehe, it's just one problem, the system doesn't work, reinstall it again, and any problem will be fine.

Now this prompt is caused by too many temporary files in the system, or a disk problem, take a look at the following method.

1) This prompt appears in the lower right corner of the taskbar (a file is damaged, please run to use the chkdsk tool to repair), it is generally caused by too many junk files in the system, mainly the junk files generated by the Internet, just clean it up.

Open a web page, click on the "Tools" menu on Internet Options under the "General" tab and click on "Delete cookies(i)", delete files in the "Delete Files" pop-up, click on "OK" (including offline files), and restart your computer (no need to use the chkdsk tool that prompts).

2) The system comes with the disk repair method: (If the fault is still there, that is, there is a problem with your disk, please repair the disk, and repair each disk).

The specific steps are as follows: select the drive letter in My Computer, right-click, select "Tools Start Checking" in the pop-up drive properties window, and select "Automatically Repair File System Errors" and "Scan and Recover Bad Sectors", and then click Start, the scanning time will vary depending on the disk capacity and scanning options (after doing the above method, a box will pop up, the point is, automatically shut down and repair at boot).

3) If it still doesn't work, it may be that there is a problem with the hard disk, try to repair it with software. Bad sectors on the hard drive will lead to corruption or loss of computer system files, computer failure to boot or freeze. Hard disk bad sectors can be repaired using NDD Disk Utility or Scandisk.

4) If the fault persists, please restore the system or reinstall it (it is still not possible to format the hard disk and repartition and reinstall it, if it doesn't work, you will have to replace the hard disk, or overhaul it).

Just reinstall your computer's system.