I bought a Canon 6180 printer, and the on site supply was changed and supplied, and after sales

This illustrates the cause of your ink supply system.

There are two workarounds.

1. Replace the printhead (printhead), even the ink supply system and ink together, don't use the previous ink, there are a lot of domestic inks that can be used, maybe the ink you use now will make the printhead blocked.

2. Replace the printhead (print head) and replace the original ink cartridge.

The printhead can also be cleared, you use a container to put the printhead inside, fill it with boiling water, and after the water cools, wipe the water with a dry rag (mainly when the green chip in the back can not have water) and install it.

If you can't pay it off like this, you use a container to put the print head inside, fill it with boiling water, and after the water cools, use a syringe to make a squeeze nozzle (make a head on the syringe) and squeeze out the nozzle, the general rule is that you can dry the water with a dry rag (mainly the green chip in the back can not have water when you get on the machine) and install it.

Industry and commerce is useless, you use even for canon will not provide, even for non-original consumables, can not be warranted, and the printhead is also consumables can not be guaranteed, your printer has a warranty card on the card, you complain is useless.

It is useless to find the industrial and commercial bureau. Only in consultation with the dealer. Under normal circumstances, the printer is changed, and the dealer will not have three guarantees.

According to your introduction above, it should not be that the sprinkler head is broken. Generally, the nozzle will not break within 1 year. It's just a plugging sprinkler.

Wash it with a cleaning solution and it should be fine.

There are pros and cons, and even the ink supply is saved. The impact of a machine failure on you is for sure, spend some money to buy a lesson. If you don't use it often, you won't change it, and if you change it, you don't have a spare machine, and you blow the dealer to help you do it.

The technician's technology can't keep up, and you will be hastily concluded, and the fault is still after the change.

6180 to continuous ink supply:

1: The sprambler needs to use ferrochrome to cut the protective plate. Dig out the left 8x10 and right 10x10 spaces on both sides of the cartridge change window. In order to make the supply pipe run normally around the car.

2；6180 is changed to continuous supply, and the ink supply pipe is very important.

3；The pipeline is introduced from the left side, at the scanning arm, and the groove is smooth and smooth. Position the pins on the left side of the disc inlet. From the right side of the cartridge (6x1) line distance 30 cm.

4；After the 6180 is corrected, it can operate normally. For online inquiries such as drilling ink cartridges, filling and exhausting air, and protecting ink cartridge chips during operation.