What to do with thick ice in the refrigerator compartment?

The solution to a very thick ice freezer in the refrigerator is:

1. If the ice is thick, it should be de-iced in time, cut off the power supply first, then open the freezer door, take out the food, and clean it up after it melts naturally. It can also be cleaned with special cleaning tools, but not with metal products to avoid damaging the pipeline, or you can add a glass of boiling water to speed up the melting speed.

Second, after each defrosting, wipe the freezer with a towel, and then apply a layer of vegetable oil on the surrounding aluminum walls, and wait for the next frost, because it is attached to the refrigerator wall containing oil, the suction between the frost and the refrigerator wall is greatly reduced, so you don't have to spend much effort, you can easily peel off the lumps.

3. If the drainage outlet of the refrigerator is blocked, resulting in poor drainage, too much water in the box leads to freezing, you need to check it first, there is a drainage hole in the middle and lower middle of the back wall of the refrigerator, if it is blocked, you can use the soft wire barrel to open it, and the drainage should be good.

Fourth, if the temperature of the refrigerator refrigerator is set too low, and the melted water cannot be discharged when the refrigerator is normally shut down to cause freezing, you can check it, there is a drainage hole in the back wall of the refrigerator refrigerator, and the melted water can be discharged from here during normal shutdown.

The refrigerator compartment is covered with thick ice, so you need to unplug the power of the refrigerator, open the refrigerator, and put two basins of warm water in it. After about half an hour, the ice will fall off naturally.

1.Turn off the power supply and use a hair dryer or electric fan to fold the frost in half to accelerate the melting of the frost.

2.After cutting off the power, put several bowls of hot water in the refrigerator according to the degree of freezing, increase the temperature in the refrigerator, and close the refrigerator door if you want the effect to be faster.

3.Cut off the power and apply a hot towel to the frost surface, the principle is the same, increase the temperature and accelerate the melting.

4.After the power is off, de-icing is carried out directly.

Refrigerator freezer compartment knot.

Very thick ice, is frost.

Periodic power cuts, defrosting are required.

1. Naturally dissolve ice when the power is off.

This method is the simplest and most effective, as long as the food is taken out in advance, and then the power is turned off to let the temperature in the refrigerator rise naturally, the ice inside the refrigerator will melt, and then the ice cubes are taken out and placed in the sink, and finally wiped clean with a dry rag.

2. Vigorously shovel ice.

If you have a small shovel at home, you can also shovel off the thick ice in the refrigerator, and you don't need to take out the food in the refrigerator, as long as the power is turned off to make the refrigerator slightly warmer, the ice in the refrigerator can be removed.

3. Thermal weathering ice method.

Sometimes the freezer is too thick and the refrigerator drawers can't be pulled out, what should I do at this time? If you want to de-ice quickly, then first turn off the refrigerator so that the refrigerator is no longer refrigerated, and the refrigerator temperature will rise naturally, and then use a hair dryer to blow on the ice, which can accelerate the melting of the ice.

4. Hot water ice melting method.

If the ice layer of the refrigerator is not very thick, you don't need to use a shovel, and you don't need a hair dryer, then you might as well try to use hot water, you can add a basin of hot water to the refrigerator freezer layer when the refrigerator is powered off, pay attention to if the refrigerator freezer layer can't hold, take off the refrigerator mezzanine, and then put the hot water in.

5. Clean the drain.

Refrigerator icing is often related to poor drainage, the drain of the refrigerator is generally in the refrigerator room, and there is a small hole in the innermost part of the refrigerator, which is the drain outlet.

The freezer freezer is very thick and should be cleaned regularly, and when we use the refrigerator, we will put some water and gas into it, and after emitting water vapor, the refrigerator will be refrigerated, and the refrigerator will freeze in the body.

If it is not cleaned frequently, it will lead to a decrease in the cooling capacity of the refrigerator.

You can let the ice melt naturally after the refrigerator is powered off, and then clean it out.

Blowing de-icing method. First unplug the power supply to ensure that the refrigerator stops working; Then seal the food in the refrigerator and take it out; Then open the refrigerator door, place a towel with good water absorption on the bottom layer of the refrigerator, and finally, use a hair dryer or electric fan to blow cold air on the inside of the refrigerator. It won't be long before the ice will melt or become easy to remove, so be sure to use cold air to avoid deforming the internal parts of the refrigerator, and blow back and forth inside the refrigerator when using a hair dryer.

In life, there are a lot of electrical appliances in the family, like the refrigerator in some families will have other symptoms, such as the freezing layer of freezing, for this phenomenon should be the refrigerator icing to clean him up, qing, after cleaning it up, re-adjust the temperature of the refrigerator appliances, so that it can be solved, because after the icing he will also affect the power, because a lot of freezing, he needs to weigh some and turn it to be able to achieve intelligence, so when it is found that the freezing is frozen, clean it up in time, It is beneficial to preserve food in this way.

It is possible to take things out, then turn off the power, put boiling water in a bowl and put it in the freezer and close the door. After half an hour, the frozen block can be removed.

Take out the food in the refrigerator, put boiling water in 10 small basins, put songs, pay attention to the door of the box in the city, and wait for 20 minutes after the ice will automatically fall off, which is a good way.

The quickest way to de-ice the freezer in the refrigerator is to use a hair dryer to blow it and it will melt quickly. It's the fastest way to skate.

Unplug and defrost thoroughly.

1. You can increase the temperature of the refrigerator to make it melt by itself. 2. You can check the tightness of the rubber strip of the repair door seal. 3. The position of the water receiving funnel in the refrigerator can be adjusted.

Reasons for this:

1. It may be that there is too much ice on the evaporator, which causes the water to overflow into the water tray and flow in the refrigerator when it melts.

2. It may be that the water tray in the refrigerator is not aligned with the water incoming funnel, resulting in the water flowing in the refrigerator.

3. It may be that the drain pipe mouth is frozen, and the defrosting water cannot flow out and accumulates in the refrigerator.

4. It may be that the beverage container is turned over in the refrigerator, or the lid of the beverage bottle is not tightened, causing the beverage to flow out.

5. It may be that the door is not closed tightly, or the rubber strip is damaged, so that the external hot gas flows in and condenses.

6. It may be that there is too much uncooled food stored, which makes mist and water droplets form in the refrigerator, which condense as the temperature drops.

7. It may be that the stored food contains a lot of water, and as the temperature drops, the water vapor evaporates, condenses when cold, and flows in the refrigerator.

8. It may be that the temperature in the refrigerator is too low, causing the beverage glass bottle to burst and the liquid to flow in the refrigerator.

9. It may be that the summer weather is hot, and the hot air enters the refrigerator room from the outlet pipe, causing freezing.

10. It may be that the water in the freezer is too full, and the volume expands and overflows the ice maker when the water freezes into ice.

It may be caused by too much frost in the evaporator, and it is necessary to defrost frequently when using the refrigerator to avoid problems; It may also be that the water tray in the refrigerator is not aligned with the water receiving funnel, and the funnel needs to be adjusted to align the position of the receiving water tray; It may also be that the drain is frozen, and the temperature of the refrigerator can be adjusted to prevent freezing. 1. There is too much frost on the evaporator, and the water overflows the water tray when it melts and flows in the refrigerator. When using the refrigerator in ordinary times, it is necessary to defrost the refrigerator frequently, which is also a necessary means to save electricity.

2. The water tray in the refrigerator is not aligned with the water receiving funnel, resulting in the water flowing in the refrigerator, and the water receiving funnel needs to be adjusted to align the position of the receiving water tray, which can effectively avoid this problem. The icing of the drain pipe mouth makes the defrosting water not flow out, and the accumulation in the refrigerator, the temperature of the refrigerator needs to be 2 6, which can effectively prevent the water from forming ice. 4. Cold drinking water or other beverage containers are turned upside down in the refrigerator, or the lid of the beverage bottle is not tightened, usually when refrigerating the drink, you need to handle it gently, and the bottle cap should be tightened, and the beverage bottle can not be put in the refrigerator casually, which will have a lot of adverse effects.

Usually the refrigerator door is not closed tightly or the sealing strip is damaged, so that the outside hot air continues to flow in and condense into water, usually when using the refrigerator must close the door to prevent the cold air from running out, if the sealing strip is found to be damaged, it needs to be replaced in time.

Here's how to fix it:

1. Cut off the power supply first, then open the freezer door, take out the food, and clean it up after it melts naturally. You can also use a special cleaning tool to clean up, but you can't clean it with metal products to avoid damaging the pipeline, or you can add a glass of boiling water to speed up the melting speed of Liang Zheng.

2. If the drainage outlet of the refrigerator is blocked, resulting in poor drainage, and too much water in the box causes freezing, you need to check it first, and there is a drainage hole in the middle of the lower part of the middle trace of the back wall of the refrigerator.