How to use the Mi humidifier, Mi humidifier fault description

Xiaomi humidifier.

Here's how to use it:

1. The Mi humidifier needs to be connected to the Mi home.

2. After that, select the environmental appliance and find the humidifier;

3. Select the Mi Home Smart Humidifier and press and hold the WiFi control button for three seconds to reset the WiFi;

4. Enter the wifi password to pair with the mobile phone, and you can use the mobile phone to remotely control the humidifier.

The correct way to use the Bear Appliance humidifier is as follows:

1.Place the machine horizontally in a suitable place.

2.Remove the air outlet, pull up the tank, and turn the tank in reverse (counterclockwise) to unscrew down the water inlet.

3.Connect to AC 220V 50Hz power supply, turn the knob switch clockwise, the machine is powered on after hearing the sound of "click", at this time the power indicator light is "red", indicating that the sink is in a state of water shortage, and the humidifier can not work normally, when turning "green", it means that the sink has been filled with water and the humidifier can work normally.

4.Infuse purified water or clean tap water. (Note: The water temperature should not exceed 40 degrees Celsius) After filling, tighten the lid tightly and wipe off the surrounding water droplets, and then put it on the body.

5.When there is no water or lack of water in the water tank, the built-in safety device will automatically disconnect the atomization circuit and the fan, and the air outlet will be sprayed out without fog, and the red indicator light will be on at the same time.

6.At this time, according to your actual needs, you can rotate the fog adjustment knob to adjust the size of the fog volume.

7.If you need to continue using it, turn off the power supply and refill the water tank.

8.When the humidifier works until there is a shortage of water, the indicator light will flash red and green alternately; When there is a shortage of water, the red light comes on and the humidifier stops working.

9.Before moving the humidifier, stop using it, turn off the power switch, and unplug the power plug, and move the whole device together. Please do not move the humidifier in working condition, so as not to cause the humidifier to work abnormally and cause the humidifier to malfunction.

Summary. 1. First of all, do the most basic check whether the humidifier indicator light is on and whether there is no wind and fog: confirm that the power supply is connected and the power switch is turned on.

Xiaomi humidifier fault description.

1. First of all, do the most basic check whether the humidifier indicator light is on and whether there is no wind and fog: confirm that the power supply is connected and the power switch is turned on.

2. If the humidifier indicator light is on, the red light means that there is a lack of water and water should be added, or the water level float gland is not compressed.

3. If the green light in the humidifier indicator is on, but there is no wind and no fog, we can check whether the fog outlet is blocked, if the fog outlet is unobstructed, the base will also produce fog, but the fog outlet does not fog, then check whether the base fan is working normally.

4. If the fan cannot operate normally, it means that the fan inside the humidifier is stuck or malfunctioning, which may be caused by the fan not being used for too long.

5. If the humidifier has wind and no fog, that is, the fan is normal, then we will check whether the humidifier can work normally, if the humidifier is faulty, it may be because of the long-term use of tap water to make the water alkali on the tablet, we can use vinegar and a little salt to wipe it to effectively dissolve the water alkali.

6. The humidifier should be kept clean regularly to ensure its normal operation, mainly clean the sink, transducer and water tank, it is best not to use tap water for humidification, but choose filtered water.

If there is a problem, then I recommend that you go to Xiaomi's customer service and ask.

The light is normal, and the fog is normal after the water ingress, that is, the water mist does not automatically enter the water, and the water valve cannot be raised.

If it doesn't work, go to the after-sales service, we are just to provide you with some help, and please understand.

If you buy it online, then look for after-sales? Yes.

Emi's house. Smart sterilization humidifier.

For example, the Mi humidifier connects to wifi steps:

1. In the mobile app market.

<> enter "humidifier" and select Mi Home Smart Dehumidifier.

5. Press and hold the WiFi control button for three seconds to reset the WiFi, and click "Next".

6. Start scanning the device after the reset is successful, and prompt to enter the password to connect to wifi after finding the device, and start connecting the device after entering.

7. After the connection is successful, you can set the location of the device, there are several options for bedroom, living room, kitchen, bathroom, and office, and click "Finish" after selection.

Humidifier too. <>

1. The fan of the humidifier machine is faulty.

Generally, there are two conditions for the humidifier to work properly, one is that the ceramic oscillator ** generates water mist, and the other is that the fan rotates to send the water mist out. If the humidifier is working but no water mist is coming out, then there is a good chance that the fan is malfunctioning.

Solution: If you don't use it for too long, it will cause the fan to freeze, you can add some lubricating oil and tap it a few times, so that the fan can turn again.

Second, the humidifier has wind and fog failure.

If there is wind in the humidifier but there is no fog, then it is likely that the long-term use of tap water, the scale in the tap water has caused water alkali to breed on the **sheet, resulting in the failure of the **sheet to operate normally, so there is no water mist in the humidifier.

Solution: You can use a professional descaler to remove scale, if you don't have a professional descaler at hand, you can also make it yourself, so that the white vinegar and salt are mixed in a certain proportion can also effectively dissolve the scale on the ** tablet, as long as the scale disappears, the humidifier can naturally be used normally.

3. The humidifier nebulizer sheet is faulty.

If the humidifier is windy but not foggy, and there is no scale on the ** sheet, then it is very likely that there is a problem with the atomizer of the humidifier, and of course there will be no fog without fogging.

Solution: Check if the fuse is burned first, if the fuse is good, try to adjust the potentiometer on the circuit board, then turn a quarter clockwise to try, if the humidifier still does not spray, you need to replace the atomizer.

The Mijia humidifier should clean the sink of the water tank and base frequently, and it is best to change the water every day to avoid the microorganisms in the water from escaping into the air and affecting health. When cleaning the atomizer, use a towel or rag, soft brush, etc. to remove the dirt on the surface of the atomizer and then rinse it with water, and do not squeeze the atomizer vigorously to prevent crushing. For limescale, it is recommended to use a limescale cleaner (food grade citric acid), pour out the solution after cleaning, and then wash it with water.

Xiaomi humidifier.

It needs to be cleaned after a long time, otherwise it will affect health and smell. We can follow the steps below.

Step 1: Turn off the power and pour out the water.

It is necessary to unplug the power supply before washing, because water is a conductor of electricity, and pour the water in the household humidifier clean.

Step 2: Use a special descaler and a soft brush.

Clean your household humidifier with a special descaler, soak it for a while after the descaler is dissolved, then gently scrub the inside of the sink with a small brush or toothbrush, remembering to always use a soft-bristled brush.

Step 3: Shake gently and pour out.

Shake it after brushing, and then quickly pour it out so that the limescale does not block the water outlet.

Step 4: Go through the water a few more times.

Wash it several times with clean water, and be careful not to leak water into the parts if the sink and base are one, causing unnecessary losses.

Be sure to pay attention to the maintenance of parts during daily use. Nowadays, newer household humidifiers, such as the pure type, only need to replace the filter and evaporator regularly.

That is, cleaning is simple.

A humidifier is a household appliance that increases the humidity in a room. The humidifier can humidify a designated room, and it can also be used with a boiler or ** air conditioning system.

Connected to humidify the entire building. Direct evaporative humidifiers are also commonly referred to as purity humidifiers. Pure humidification technology is a new technology that has just been adopted in the field of humidification, and the pure humidifier passes through molecular sieves.

Evaporation technology has a good effect on removing calcium and magnesium ions in water.

Take Mijia smart disinfection humidifier as an example. MI humidifier to connect to wifi steps:

5 Press and hold the WiFi control button for 3 seconds, reset the WiFi, and click Next.

6 Scan the device after a successful reboot. Once the device is located, the user is prompted to enter the password to connect to the wifi.

7 After the connection is successful, you can set the location of the device, including multiple options such as bedroom, living room, kitchen, bathroom, office, etc. Select and click "Done".

The advantage of this humidification method is that it does not pick up water sources, no white powder is generated, and it does not pollute the Fengsui Tong filter inside the air humidifier, and it can also effectively intercept impurities in the water and avoid dispersing into the air to pollute the environment. At the same time, the filter element is folded in multiple layers, and the overall surface area is very large, which can better diffuse water vapor and improve the evaporation efficiency of water vapor. And this filter element can also be washed directly, which can be kept clean at all times, and can be replaced directly after long-term use.

It can be at Mi's house.

and connect, and then adjust it to the lowest level by adjusting it through the button on the phone.

How to use the humidifier:

1. Take out the water tank of the humidifier, there will be a rotating bridge Hechun cover after the water tank is turned upside down, add water after unscrewing, and then decide to add water according to the time of use.

2. After adding water, tighten the cover, assemble the water tank back, check the devices of each way, plug in the power supply, and the indicator light of the humidifier is on, which means that it has started to work.

3. The humidifier will have a switch, a rotary switch to adjust the fog lamp slag at the outlet of the humidifier.

The size can be adjusted left and right, and the medium size is generally sufficient.

4. It is more appropriate to place the humidifier in the middle of the house, and the humidifier should not be placed around the sensitive mask, and it should be kept away from household appliances. If used in the bedroom, do not get too close to the human body.

5. The humidifier does not have a strict humidification time, in order to avoid excessive indoor humidity, it is recommended to control it at 50%-60%.