How to cut the inner buckle yourself? How do you cut your hair with an inner button?

Both curling irons and straighteners can be buttoned inward, and curling irons can only curl the ends of the hair inward, but the curl may be larger and the degree of buckle is greater. The straightener can be buttoned inward, and the hair on it can also be straightened and clamped a little smoother, and then when it reaches the ends, it can be curled inward and clipped. Every morning when rolling, the time of the roll stays for a few seconds and can be kept at the end of the day.

I didn't apply then essential oils or anything, it was straight rolling. Finally, comb it, and adjust it too appropriately if you are not satisfied. If you are afraid of not styling, you can spray some hairspray at the end of your hair.

All you need is a pig hair curl comb and an adjustable hair dryer. With hair so short, there's no need for a curling iron and a cleat, unless you want an exaggerated inner button. In daily life, you can curl the comb, which is quite natural, and the damage to the hair is also very small.

After washing your hair, use a hair dryer on a high-end or medium-range hair dryer to dry your scalp and roots, and use a curl comb to pull the inner buttons while the ends of your hair are still dry. Because I'm lazy! So usually I only deal with the ends.

Start by combing through the short hair with a comb, then grab a strand of hair and pinch the ends with a curling iron. Pull the curling iron down to the ends of the hair, then select 90 to 180 degrees inward, leave it for 5 seconds and release it to form an inner curl. Perm all the ends of your hair in this way and you're done.

First, divide the hair into three or seven parts and comb the hair through with your hands, then divide the hair into five small strands and temporarily hold them in place with large hair pins. Use a heated curling iron to iron the hair on the left side of the hair into an inner button, and then use the curling iron to twist the hair on both sides of the forehead in a spiral shape.

I've always had medium to long hair, and I cut it short last year. But I've always used a curling iron for my hair. I've scalded it a few times before, but the effect has not been very satisfying, so I just did it myself.

First of all, choose an electric curl rod, which is the kind that can be rolled or straightened, and can be bought a little more expensive, without hurting the hair.

My hair is relatively soft, so you can comb it with a curling comb, and you can buckle it yourself after washing your hair, if your hair is hard, you can do a softening or your hair likes to turn out, it is recommended to use as little as possible with a curling iron or something, it feels very hurtful to the hair, it is really not good to consciously blow it in every time you wash your hair.

1. The angle of the hair clip: if you want to achieve the best effect of the inner buckle, you must keep improving and pay attention to some details that are often overlooked, when the fingers clamp the hair piece, do not turn it outward, it may feel that it will be convenient to cut, but it will also have an impact on the effect, it is best to clamp it directly and do not have any direction of deflection action. in order to keep our incisions the same inside and out.

2. Tension: The most common problem with the hairstyle with internal buckle is that the tension is too large, which destroys the original tension of the hairpiece. Sometimes I feel that the incision is cut very cleanly, but when the loose piece is naturally combed with a comb, you will find that the incision is uneven, which is that the hairpin clip is too tight, because the seam of our fingers will not have a very uniform tension, resulting in uneven tension of the hair piece, and there will be deviation when it is loosened after cutting.

The best way to do this is to use a comb to lift the piece and then clip it with your fingers and cut it directly, without any more pulling.

3. Angle: The higher the angle of lifting, the effect of the inner buckle will be discounted, if we take the comb zero degree close to the hair piece of the ** cut, you will find that the effect of the inner buckle will be very good, but the angle of lifting is more than 45 degrees, the effect of the inner buckle is basically gone, and the higher the angle, the greater the tension on the hair piece, the first point I will tell me, the greater the tension will destroy the surface tension of the hair piece. That's why all the buttoned hair pieces we see are low-angle hair pieces.

1. First, comb the outer layer of hair neatly, and you must pay attention to maintaining the curl of the hair in the process of combing the hair. Otherwise, the hair will become less and less frizzy.

2. The second step is that after the hair is combed neatly, we need to spray the outer layer of hair with hair essence, or use some products that can make the hair look softer and make your hair look more shiny. After spraying the above hair conditioner, we need to use a comb to comb the hair from top to bottom to make it smoother. In the process of this step, we should pay attention to the choice of wide teeth and wide combs, because hair is easy to get tangled, resulting in hair breakage and hair loss.

3. The third step is that we need to use our hands to arrange the shape of the hairstyle, this step does not need to use other auxiliary products, we only need to hold the hair with our hands and let the hair roll inward. Remember to use your hands to hold your hair from the bottom up. Then we use a hair dryer to blow the hair inwards to keep the curls in their original state.

If we are in the process of drying when the hair gradually becomes very dry. You can spray conditioner on top of your hair to prevent it from drying out.

1. The hair is divided into upper and lower parts, and a small strand of hair from the lower part is rolled inward on the cylindrical comb with a cylindrical comb.

2. Use a hair dryer to blow on the hair that is curled on a cylindrical comb.

3. From top to bottom, until a certain arc is blown, and the end of the hair is paid attention to blowing for a while.

4. Take the second strand of hair and use the same square rolling method to operate.

5. According to the amount of hair taken each time, the styling process needs to be repeated about 3-5 times.

6. Blow all the hair according to the method, and a hairstyle will come out with a front shed buckle.

The cutting method of the inner buckle is as follows:

1. Divide your hair into 7 areas and roll them up with rubber bands.

2. First, open the bottom hair and cut it to shoulder length with scissors.

3. Cut the hair of the previous layer down to the same length as the hair just now.

4. Put down the hair on both sides layer by layer and cut it to the same length as the hair at the back.

5. Comb the hair back and cut the length of the front and back hair.

6. Use small shears to repair the ends of your hair to make it neat.

7. Thin the hair on both sides.

8. Finally, comb your hair neatly.

1. Divide the hair into two layers, the upper and lower layers (the top is a thin layer), and then divide it into three parts and roll it outward with a curling iron, and the lower hair is also divided into three parts and roll it inward with a curling iron.

2. Use a hair dryer to blow hot air on the curling iron for a short while, and then take it off after it has cooled.

3. The upper layer of hair is slightly grabbed and equipped with styling water to make short hair look more fluffy.

4. Spray the styling water on the ends of the hair and lift it slightly by hand to make the curvature of the ends more obvious and fluffy.

5. Finally, after a little tidying, a hairstyle with an inner button is completed.

Yes, if it's not too short.

Comb the short hair with a comb first, then remove a small strand of hair from the side and hold it with a curling iron.

2.Then move the hair straightener to the ends, then press it inward, leave it for about 5 seconds before releasing it, so that the inner curl is formed. Perm all hair ends into inner buttons in the same way, so that you have a short inner button.