How do I make a movable guide ring on the rod?

That's how I did it, find a waste rod that I don't use, or two or three sections, sawed into a small section of about 6-7 mm, and then try one by one, can keep the useful rod slightly positioned, on the line glue, pay attention, when gluing the movable ring to take it down, otherwise it is easy to stick with the rod slightly, I hope it will help you.

It's very simple, the wire I use, peel off a small piece of skin, and then tie the wire loop, glue, very OK

Ballpoint refills are also fine, and if you don't want to remove the guide ring at the tip of the rod, you can cut the refill aside. Tie the guide ring and paint it directly with 504 (not 502, ** on.) It's sturdy.

I see that there are people who tie figure-eight rings to the tips of poles, and it is said that it is okay.

For the retraction and release of fishing line, the fishing rod is provided with a guide ring device, the guide ring device is generally provided with a guide ring support and an inner ring, the inner ring is to reduce the friction of the fishing line, and the overall size of the guide ring is very small, according to the prior art, the connection of the guide ring support and the inner ring is generally to embed the outer edge of the inner ring into the annular hole of the guide ring support, and the two are closely matched by the plane to complete the combination. The first production process of the inner ring of the guide ring for the existing fishing rod: the magnetic ring or the ceramic ring is pressed into the support, and the reinforcing glue is pointed, and the flow chart is made as shown in Figure 3; The second production process:

Due to the gravitational force of the fishing line, the inner ring often detached, the reliability is poor, so the size requirements of the annular hole on the outer edge of the inner ring and the guide ring bracket must be very strict, so that the production cost is relatively high, in addition, because the material of the two is different, the assembly size of the two is more accurate, when the temperature changes, the inner ring is also easy to break, loosen or fall off, and the fishing rod brings serious defects in use.

The front rod is used for table fishing.

Matching line group: It is still normal to use the main and sub-line groups for table fishing, such as the main line gamete.

Line or number, match or number, Fuling match or number, etc. However, the chosen line set is shorter than the length of the front rod. For example, the table fishing line set with rice before the rice rod is matched, and the meter front rod is matched with the meter table fishing line set.

This is because the wiring of the reel can also be properly paid-off.

After tying the fishing line, release the wiring until the rod is equal in length. For example, if the front rod is equipped with a normal rice fishing line set, and then the length of the reel is lengthened, the length of the entire fishing line group will also be meter long.