What needs to be added to the filter of the fire polisher

How about a double-sided polishing machine? This question cannot be generalized and should be analyzed according to your specific situation. Here is a brief introduction to the characteristics of the double-sided polishing machine for your reference.

1. The machine adopts the principle of four-motion polishing; The two motors drag the upper and lower throwing discs, the sun gear, and the inner gear ring respectively; PLC adjustment setting control; Human-machine interface system with color NT display. 2. Gantry box-shaped structure, equipped with high-power deceleration system, soft start, soft stop, smooth operation, polishing time can be set at will according to the timer, and automatic polishing liquid supply device is adopted. 3. The parts in contact with the polishing slurry are selected with anti-corrosion materials or special treatment on the surface.

4. The closed-loop feedback control of pressure is realized through the combination of precision load cell and high-precision pneumatic control system, which ensures the accuracy of workpiece pressure. 5. Main Sports....

The fire polishing machine can throw some irregular shapes and places that are difficult to throw by other polishing methods to make up for the lack of cloth wheel polishing machine. It is generally used in conjunction with a cloth wheel polishing machine.

Raw materials: purified water, pure alcohol.

Steps: 1) Turn on the power and adjust the air pressure to 4-5.

2) When the isopressure rises to 5-6, open the air pressure valve.

3) Turn on the gas pipe knob and don't open it too much.

4) Ignite under the needle with a lighter.

5) Adjust the knob of the gas pipe so that a blue flame appears.

6) Clean the surface of the material to be polished and start polishing.

Precautions: 1. The surface of the polished material must be free of dust, debris and other debris, otherwise it is easy to scorch the material.

2. The flame should not be too large, and it is advisable to have a blue flame.

3. Pay attention to grasp the heat, the height of the flame moving on the surface of the material should be uniform, otherwise the surface of the material is easy to become uneven.

4. When the electrolyte and alcohol are used up, pure water and pure alcohol should be added, and when the liquid in the liquid display tube is less than 1 3, it needs to be added.

5. After polishing, turn off the power supply, discharge all the residual gas, and then close the air pressure valve.

CNC cutting machine**.

CNC Flame Cutting Machine**.

CNC plasma cutting machine**.

Here's how to use it correctly:

1. Pour kilograms of special electrolytic powder into the alkali-resistant dissolver, add a small amount of distilled water, stir slightly, and cool naturally for about 20 minutes. Connect the leather tube and the flame gun, connect the air outlet, and select the nozzle model according to the thickness of the wool ruler or combing;

2. Unscrew the solution nut, slowly fill it to a lower than "high" liquid level, do not exceed 90, and tighten the nut;

3. Loosen the alcohol tank, add alcohol slowly, do not exceed 50%, and tighten the alcohol tank;

4. Connect the power supply to turn on, the power indicator light is on, the Fengling selling machine is turning, the air outlet has a gas sense, and the pressure gauge has an indication, which means that everything is normal;

5. Unscrew the regulating valve of the flamethrower, pay attention to the first use of the fire after 5 seconds of ignition of the open flame, the flame is straight or obliquely aimed at the burr, keep an appropriate distance, and scan it evenly;

6. If it is found that the liquid level indication drops significantly, it is necessary to add water in time, and there is no need to add electrolytic powder;

7. In the process of use, when the current is significantly reduced, it is appropriate to add the electrolytic powder preparation.