The water dispenser has not been used for a long time, and I want to clean it, how should it be clea

Water dispensers can be disinfected with white vinegar.

The specific operation is as follows:

1. Pour 4 liters of water into a plastic bucket.

2. Configure white vinegar solution. To neutralize the vinegar taste, you can add one to two tablespoons of lemon juice. Combine the white vinegar and water as per 1:

3 Mix. That is, if you use 4 liters of water, pour liters of white vinegar. To add lemon juice, mix the water and white vinegar before adding it.

3. Unplug the water dispenser and take the bucket off. Make sure there are no other appliances connected to the same outlet and remove the appliances around the water dispenser. In the unlikely event that water and electricity come into contact with the conduction, it is better to be careful.

4. Wipe the inner surface of the water dispenser with a damp sponge dipped in detergent. After 2 to 5 minutes, turn on the faucet on the side of the cold water and drain the cleaning solution (note, don't let it sit for too long, otherwise the plastic will corrode). Place a container under the faucet to catch the cleaning liquid coming out.

Finally, pour the cleaning solution into the sink or toilet).

5. Rinse off the residual cleaning solution. Fill the water dispenser with water, then turn on the cold water tap to drain the dirty water. It needs to be repeated four times. In order to get rid of the smell of white vinegar, be sure to clean the water dispenser thoroughly.

6. Take off the water tray and brush it clean. Some trays come with lids, so don't forget to brush them up as well. When you finish brushing, turn on the faucet and flush it. Every part of the tray and even the crevices are completely dry before it can be reinstalled.

The steps to clean the water dispenser are as follows:

1.Unplug the power or cut off the water source first, and pour out all the water inside the water dispenser.

2.Remove the water bucket or tank from the water dispenser and wash it thoroughly with clean water, especially the bottom.

3.Rinse all the water pipes and pipes in the water dispenser and the water outlet with clean water.

4.Take some white vinegar or professional water dispenser cleaner and clean it according to the requirements of the instructions.

5.After rinsing, you also need to pour 1-2 times of water into the water dispenser, and then drain it thoroughly.

Finally, it should be noted that the cleaned water dispenser must be sterilized by the button to improve hygiene standards to ensure that good drinking water is received.

1. The water dispenser has not been used for a long time, first unscrew the drain of the water dispenser (the purpose is to let the residual water flow out), screw on the drain of the water dispenser, pour a bottle of white vinegar into the water dispenser (white vinegar has a sterilizing effect and can kill the bacteria inside the water dispenser), let it stand for five minutes, remove the lid of the water dispenser, and then pour a pot of boiling water into the water dispenser (boiling water has a sterilizing effect), open the drain of the water dispenser to discharge the wastewater.

2. The water dispenser is a device that heats or cools the bottled purified water (or mineral water) so that people can drink it, and the bottled water is placed above the machine for supporting use.

3. From the perspective of function, the water dispenser is mainly divided into three types: warm, ice hot, and ice warm, which will provide water at different temperatures for people to drink, and the machine itself has the functions of cooling and cooling, or heating and heat preservation. There are also many styles of water dispensers, such as nozzle type, press type, etc.

The specific method of cleaning the water dispenser is as follows:

Step 1: Unplug the power plug, remove the bucket, open the drain nozzle behind the water dispenser (usually a knob made of white plastic), and drain the remaining water. Then, turn on the hot and cold water switch to drain the water.

Step 3: Configure disinfectant water according to the instructions of decontamination effervescent tablets or disinfectant, introduce it into the water dispenser, fill the entire cavity with disinfectant water, and leave it for 10 to 15 minutes.

Step 4: Turn on all the switches of the water dispenser, including the sewage pipe and drinking water switch, and drain the disinfectant.

Step 5: Continuously rinse the entire cavity of the water dispenser with clean water (it is recommended to move the water dispenser to the bathroom to ensure sufficient water), turn on all switches to drain the flushing liquid.

Step 6: Put a glass of water and smell for chlorine. If so, put in the water until you can't smell any smell before you can drink it safely.

Just wash with vinegar, open the water outlet behind the water dispenser, pour vinegar into it from above, the main thing is sterilization and disinfection, there is a liquid similar to hydrogen peroxide, and the liquid of Founder sterilization and disinfection can be used, so rest assured with vinegar.

1. Turn off the power of the water dispenser and remove the bucket (there is corresponding memory water in the water dispenser at this time); 2. Open the drain of the water dispenser, use a clean container to hold the water in the water dispenser, and cover the drain after finishing; 3. Take 1 bottle (50ml) of sterilization and disinfectant from the water dispenser and pour it into the container, dilute it evenly, pour it into the body from the top of the water dispenser, and soak it for 30 minutes; 4. Open the drain outlet and drain the water in the body; 5. Repeat the above steps with bottled water, rinse the water dispenser twice and use it normally.

Ingredients to prepare: pots, white vinegar.

Step 1: Unscrew the drain of the water dispenser (the purpose is to allow the residual water to flow out).

Step 2: Then use the basin to follow the water that comes out.

Step 3: Screw on the drain of the water dispenser.

Step 4: Pour a bottle of white vinegar into the water dispenser (white vinegar has a bactericidal effect and can kill bacteria inside the water dispenser).

Step 5: Let stand for five minutes.

Step 6: Remove the lid from the water dispenser.

Step 7: Then pour a pot of boiling water into the water dispenser (boiling water has a sterilizing effect).

Step 8: Open the drain of the water dispenser.

Step 9: Use a basin to drain the white vinegar and boiling water.

Step 10: The water dispenser has been cleaned after a long time of not being used.

Do you really know how to clean a water dispenser? In this way, you can clean it up and drink it safely.

To clean drinking water that has not been used for a long time, the materials that need to be prepared include: beer, basins, and water.

First, first open the water outlet after the water dispenser.

2. Drain the water inside.

3. Then pour in 1-2 bottles of beer, the beer contains carbonic acid, which can effectively remove stains.

Fourth, add the same amount of hot water as beer to catalyze the neutralization of beer acid and alkali and remove stains faster.

5. After standing for 3 hours, the beer mixture is discharged.

6. Then pour water repeatedly for rinsing.

7. In this way, the water dispenser will be cleaned.

The water dispenser should indeed be thoroughly disinfected regularly, and Sister Hua went to the supermarkets and shopping malls with water dispensers** and asked about the method of disinfection of the water dispenser. Generally speaking, water dispensers should be disinfected and cleaned once a month to ensure water hygiene. Before using the water dispenser for the first time or after a long period of inactivity, the user should disinfect it.

The specific method is: mix a piece of disinfectant (some water dispensers are randomly dispensed) with 5-6 liters of purified water to make a disinfectant, inject it into the water dispenser, continue to soak and disinfect for 20 minutes, open the drain valve of hot irrigation to drain the disinfectant, then close the drain valve, and then inject pure water into the machine for rinsing until the water from the faucet has no smell. During cleaning and maintenance, or when the water dispenser is out of use for a long time, please unplug the power supply.

Disassemble and wash, or buy a new one, generally speaking, it is not necessary to wash, and you will not get sick if you eat it cleanly.

Steps to clean the water dispenser: 1cut off the power of the water dispenser; 2.

Insert the 5-gallon water bottle vertically down into the smart seat on the upper part of the machine, turn on the red hot water faucet and the blue cold water faucet until the water is released, then turn off the faucet, and then hold the bottle with both hands and take out the water bottle upwards; 3.Cleaning the outside of the water dispenser and the smart seat; 4.Pour 600ml of special cleaning and disinfectant solution into the water storage tank; After a few minutes, turn on the red and green faucets until the disinfectant is exhausted; 6.

Unscrew the water drain valve at the back or bottom of the machine to drain the disinfectant in the water dispenser; 7.Rinse several times with boiling or purified water; 8.Tighten the drain valve, and the disinfection and sterilization operation procedures are completed.